- 您現在的位置：買賣IC網 > PDF目錄367727 > P83C434 (NXP Semiconductors N.V.) 8-bit microcontrollers with LCD-driver PDF資料下載
參數資料
| 型號： | P83C434 |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | 8-bit microcontrollers with LCD-driver |
| 中文描述： | 8位微控制器與LCD驅動器 |
| 文件頁數： | 14/36頁 |
| 文件大?。?/td> | 165K |
| 代理商： | P83C434 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
1997 Jul 03
14
Philips Semiconductors
Product specification
8-bit microcontrollers with LCD-driver
P83C434; P83C834
6.3.4
I
NTERRUPT
P
RIORITY
R
EGISTER
(IP)
Table 8
Interrupt Priority Register (address B8H)
Table 9
Description of IP bits
7
6
5
4
3
2
1
0
PT1
PX1
PT0
PX0
BIT
SYMBOL
DESCRIPTION
7 to 4
3
PT1
Reserved.
Defines the Timer 1 Overflow Interrupt priority level
. When PT1 is HIGH, Timer 1
Overflow Interrupt is assigned a high priority level.
Defines the External Interrupt 1 priority level
. When PX1 is HIGH, External
Interrupt 1 is assigned a high priority level.
Defines the Timer 0 Overflow Interrupt priority level
. When PT0 is HIGH, Timer 0
Overflow Interrupt is assigned a high priority level.
Defines the External Interrupt 0 priority level
. When PX0 is HIGH, External
Interrupt 0 is assigned a high priority level.
2
PX1
1
PT0
0
PX0
6.4
Reduced power modes
6.4.1
I
DLE MODE
In the Idle mode, the CPU puts itself to sleep while all of
the on-chip peripherals remain active. The instruction to
normal operating mode before the Idle mode is activated.
The CPU contents, the on-chip RAM, and all of the special
function registers remain intact during this mode. The Idle
mode can be terminated either by any enabled interrupt (at
which time the process is picked up at the interrupt service
routine and continued), or by a hardware reset which starts
the processor in the same manner as a power-on reset.
6.4.2
P
OWER-DOWN MODE
In the Power-down mode, the CCO oscillator (processor
clock) is stopped; as the instruction to invoke Power-down
mode is the last instruction executed. Whether the 32 kHz
oscillator is stopped depends on bit RUN32 in the MCON
register (MCON5). The Power-down mode can be
terminated by a RESET in same way as in the 80C51 or in
addition by one of two external interrupts, INT0 or INT1.
A termination with an external interrupt does not affect the
internal data memory and does not affect the Special
Function Registers. This makes it possible to exit
Power-down without changing the port output levels.
To terminate the Power-down mode with an external
interrupt, INT0 or INT1 must be switched to level-sensitive
and must be enabled. The external interrupt input signal
INT0 and INT1 must be kept LOW until the oscillator has
restarted and stabilized. An instruction following the
instruction that puts the device in the Power-down mode
will be executed. The control bits for the reduced power
modes are in the Special Function Register PCON.
To wake-up the microcontroller by a reset, the RESET pin
must be kept HIGH for a minimum of 36
μ
s.
6.5
Reset
Reset is accomplished either at power-on when the supply
voltage rises above Power-on-reset threshold or by a
logic 1 signal at the RESET pin.
The Power-on-reset threshold is minimum 1.8 V and
maximum 3.0 V. The RESET signal should be active
(HIGH) for at least 2 machine cycles (24 oscillator
periods).
The reset algorithm puts registers and flip-flops in a
defined state (see 80C51 Family specification in “Data
Handbook IC20”and Section 6.6.1). The I/O ports are set
to a logic 1 at reset.
To wake-up from power-down the RESET signal must be
kept HIGH for a minimum of 36
μ
s.
相關PDF資料 |
PDF描述 |
|---|---|
| P83C834 | 8-bit microcontrollers with LCD-driver |
| P83C834CFP | 8-bit microcontrollers with LCD-driver |
| P83C453EFAA | CMOS single-chip 8-bit microcontrollers |
| P87C453EBLKA | CMOS single-chip 8-bit microcontrollers |
| P87C453EFAA | CMOS single-chip 8-bit microcontrollers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| P83C434CFP | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:8-bit microcontrollers with LCD-driver |
| P83C453EBAA | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:80C51 8-bit microcontroller family 8K/256 OTP/ROM, expanded I/O |
| P83C453EFAA | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:CMOS single-chip 8-bit microcontrollers |
| P83C504GBA | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller |
| P83C504GBB | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller |
發布緊急采購，3分鐘左右您將得到回復。