- 您現在的位置：買賣IC網 > PDF目錄224694 > PCA9533D (NXP Semiconductors N.V.) 4-bit I2C-bus LED dimmer PDF資料下載
參數資料
| 型號： | PCA9533D |
| 廠商： | NXP Semiconductors N.V. |
| 元件分類： | LED驅動器 |
| 英文描述： | 4-bit I2C-bus LED dimmer |
| 封裝： | PCA9533D/01<SOT96-1 (SO8)|<<http://www.nxp.com/packages/SOT96-1.html<1<week 5, 2005,;PCA9533D/01<SOT96-1 (SO8)|<<http://www.nxp.com/packages/SOT96-1.html<1<week 5, |
| 文件頁數： | 1/24頁 |
| 文件大?。?/td> | 140K |
| 代理商： | PCA9533D |
1.
General description
The PCA9533 is a 4-bit I2C-bus and SMBus I/O expander optimized for dimming LEDs in
256 discrete steps for Red/Green/Blue (RGB) color mixing and back light applications.
The PCA9533 contains an internal oscillator with two user programmable blink rates and
duty cycles coupled to the output PWM. The LED brightness is controlled by setting the
blink rate high enough (> 100 Hz) that the blinking cannot be seen and then using the duty
cycle to vary the amount of time the LED is on and thus the average current through the
LED.
The initial setup sequence programs the two blink rates/duty cycles for each individual
PWM. From then on, only one command from the bus master is required to turn individual
LEDs ON, OFF, BLINK RATE 1 or BLINK RATE 2. Based on the programmed frequency
and duty cycle, BLINK RATE 1 and BLINK RATE 2 will cause the LEDs to appear at a
different brightness or blink at periods up to 1.69 second. The open-drain outputs directly
drive the LEDs with maximum output sink current of 25 mA per bit and 100 mA per
package.
To blink LEDs at periods greater than 1.69 second the bus master (MCU, MPU, DSP,
chip set, etc.) must send repeated commands to turn the LED on and off as is currently
done when using normal I/O expanders like the NXP Semiconductors PCF8574 or
PCA9554. Any bits not used for controlling the LEDs can be used for General Purpose
parallel Input/Output (GPIO) expansion, which provides a simple solution when additional
I/O is needed for ACPI power switches, sensors, push-buttons, alarm monitoring, fans,
etc.
The Power-On Reset (POR) initializes the registers to their default state, causing the bits
to be set HIGH (LED off).
Due to pin limitations, the PCA9533 is not featured with hardware address pins. The
PCA9533/01 and the PCA9533/02 have different xed I2C-bus addresses allowing
operation of both on the same bus.
2.
Features
I 4 LED drivers (on, off, ashing at a programmable rate)
I Two selectable, fully programmable blink rates (frequency and duty cycle) between
0.591 Hz and 152 Hz (1.69 second and 6.58 milliseconds)
I 256 brightness steps
I Input/outputs not used as LED drivers can be used as regular GPIOs
I Internal oscillator requires no external components
I I2C-bus interface logic compatible with SMBus
PCA9533
4-bit I2C-bus LED dimmer
Rev. 03 — 27 April 2009
Product data sheet
相關PDF資料 |
PDF描述 |
|---|---|
| PCA9533DP | 4-bit I2C-bus LED dimmer |
| PCA9550D | 2-bit I2C-bus LED driver with programmable blink rates |
| PCA9550DP | 2-bit I2C-bus LED driver with programmable blink rates |
| PCA9551BS | 8-bit I2C-bus LED driver with programmable blink rates |
| PCA9551D | 8-bit I2C-bus LED driver with programmable blink rates |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PCA9533D/01 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:4-bit I2C-bus LED dimmer |
| PCA9533D/01,112 | 功能描述:LED照明驅動器 4-BIT I2C FM OD LED DIM RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
| PCA9533D/01,118 | 功能描述:LED照明驅動器 4-BIT I2C FM OD LED RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
| PCA9533D/01112 | 制造商:Rochester Electronics LLC 功能描述: 制造商:NXP 功能描述: 制造商:NXP Semiconductors 功能描述: |
| PCA9533D/01-T | 功能描述:LED照明驅動器 4-BIT I2C FM OD LED DIM RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
發布緊急采購，3分鐘左右您將得到回復。