2
PS7023P
10/14/09
PI5C16212
24-Bit Bus-Exchange Switch
Storage Temperature ....................................................... –65°C to +150°C
Ambient Temperature with Power Applied ...................... –40°C to +85°C
Supply Voltage to Ground Potential................................... –0.5V to +7.0V
DC Input Voltage ............................................................... –0.5V to +7.0V
DC Output Current.......................................................................... 120mA
Power Dissipation ................................................................................. 1W
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
Recommended Operating Condition
Parameter
Description
Min.
Max.
Units
VCC
Supply Voltage
4
5.5
V
VIH
High-Level Input Voltage
2
VIL
Low-Level Input Voltage
0.8
TA
Operating Free-Air Temperature
–40
85
°C
Note:
Stresses greater than those listed under MAXIMUM RAT-
INGS may cause permanent damage to the device. This is a
stress rating only and functional operation of the device at
these or any other conditions above those indicated in the
operational sections of this specication is not implied. Ex-
posure to absolute maximum rating conditions for extended
periods may affect reliability.
DC Electrical Characteristics (Over the Operating Range, TA = –40°C to +85°C, VCC = 5V ±10%)
Parameter
Description
Test Conditions(1)
Min.
Typ(2)
Max.
Units
VIH
Input HIGH Voltage
Guaranteed Logic HIGH Level
2.0
V
VIL
Input LOW Voltage
Guaranteed Logic LOW Level
–0.5
0.8
II
Input Current
VCC = Max, VIN = VCC or GND
±1
μA
VCC = 0, VIN = VCC
10
IOZ
High Impedance Output
Current
0 – A, B – VCC
±1
VIK
Clamp Diode Voltage
VCC = Min, IIN = –18mA
–0.7
–1.2
V
IOS
Short Circuit Current(3)
A (B) = 0V, B (A) = VCC
100
mA
VH
Input Hysteresis at Control Pins
150
mV
RON
Switch On Resistance(4)
VCC = Min, VIN = 0.0V, ION = 64mA
7
VCC = Min, VIN = 2.4V, ION = 15mA
12
Notes:
1. For Max. or Min. conditions, use appropriate value specied under Electrical Characteristics for the applicable device.
2. Typical values are at Vcc = 5.0V, Ta = 25°C ambient and maximum loading.
3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.
4. Measured by the voltage drop between A and B pin at indicated current through the switch. On-Resistance is determined by the lower of the
voltages on the two (A,B) pins.
09-0003