參數資料
型號: PI90SD1636AFCE
廠商: Pericom Semiconductor Corp.
英文描述: SERDES Gigabit Ethernet Transceiver
中文描述: SERDES的千兆以太網收發器
文件頁數: 6/15頁
文件大小: 559K
代理商: PI90SD1636AFCE
6
PS8641 10/14/04
PI90SD1636A
SERDES Gigabit Ethernet Transceiver
Functional Block Description
Input Data Latch
The input data latch block latches the 10-bit TTL input parallel byte, TX<9:0>, on the rising edge of the 125 MHz user-provided
TX_CLK into the holding registers.
Parallel-to-Serial Converter
The received 10-bit TTL parallel input byte is converted to serial PECL level data stream by the parallel-to-serial block, and is trans-
mitted differentially to the line driver block at 1.25 Gbps. The 8b/10b encoded data is transmitted sequentially with bit 0 being sent
first.
Clock Generator
The 125 MHz signal used for clocking the serial outputs is generated by the TX PLL block based on the user-provided TX_CLK.
This clock should have a ±100 ppm tolerance.
Internal Loopback
When EWRAP is set to a logic HIGH, the serial data stream generated by the transmitter is looped back to the receiver path, instead
of going out to the DOUT± pins. When in loopback mode, a static logic 1 is transmitted at the line driver (DOUT+ is HIGH and
DOUT- is LOW).
Signal Detect
Signal detect block is used to sense the serial input data stream at pins DIN±. If the serial input is lower than 50mV differentially, this
block deasserts SIG_DET and sets the output, RX<9:0>, to all logic ones. When the serial input at pins DIN± is greater than 50mV,
the signal is directed to the receive path.
Equalizer and Slicer
The signal received from the line (DIN± pins) is distorted by the cable bandwidth. In order to maintain a low bit-error rate, an equalizer
is used to compensate for the signal loss. The slicer recovers the differential low-level signal to a CMOS-level single-ended signal,
for clock recovery and data re-timing.
Clock Recovery
The serial input data stream contains both data and clock. The clock recovery block is used to extract both data and clocks from this
input. In addition to data, two clocks of 62.5 MHz are recovered.
相關PDF資料
PDF描述
PI90SD1636AFD SERDES Gigabit Ethernet Transceiver
PI90SD1636AFDE SERDES Gigabit Ethernet Transceiver
PIA01CB235A
DIA01C7245A
DIA01CB235A
相關代理商/技術參數
參數描述
PI90SD1636AFCEX 功能描述:以太網 IC 1.25G SERDES Gigabit Ethernet RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray
PI90SD1636AFD 制造商:PERICOM 制造商全稱:Pericom Semiconductor Corporation 功能描述:SERDES Gigabit Ethernet Transceiver
PI90SD1636AFDE 制造商:PERICOM 制造商全稱:Pericom Semiconductor Corporation 功能描述:SERDES Gigabit Ethernet Transceiver
PI90SD1636C 制造商:PERICOM 制造商全稱:Pericom Semiconductor Corporation 功能描述:SERDES Gigabit Ethernet Transceiver
PI90SD1636CFC 制造商:PERICOM 制造商全稱:Pericom Semiconductor Corporation 功能描述:SERDES Gigabit Ethernet Transceiver