- 您現在的位置：買賣IC網 > PDF目錄190059 > PIC16C505-20/P 8-BIT, OTPROM, 20 MHz, RISC MICROCONTROLLER, PDIP14 PDF資料下載
參數資料
| 型號： | PIC16C505-20/P |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, OTPROM, 20 MHz, RISC MICROCONTROLLER, PDIP14 |
| 封裝： | 0.300 INCH, PLASTIC, DIP-14 |
| 文件頁數： | 11/85頁 |
| 文件大小： | 1205K |
| 代理商： | PIC16C505-20/P |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁
1999 Microchip Technology Inc.
DS40192C-page 19
PIC16C505
5.0
I/O PORT
As with any other register, the I/O register can be
written and read under program control. However,
read instructions (e.g., MOVF PORTB,W) always read
the I/O pins independent of the pin’s input/output
modes. On RESET, all I/O ports are defined as input
(inputs are at hi-impedance) since the I/O control
registers are all set.
5.1
PORTB
PORTB is an 8-bit I/O register. Only the low order 6
bits
are
used
(RB<5:0>).
Bits
7
and
6
are
unimplemented and read as '0's. Please note that RB3
is an input only pin. The configuration word can set
several I/O’s to alternate functions. When acting as
alternate functions, the pins will read as ‘0’ during port
read. Pins RB0, RB1, RB3 and RB4 can be configured
with weak pull-ups and also with wake-up on change.
The wake-up on change and weak pull-up functions
are not pin selectable. If pin 4 is configured as MCLR,
weak pull-up is always off and wake-up on change for
this pin is not enabled.
5.2
PORTC
PORTC is an 8-bit I/O register. Only the low order 6 bits
are used (RC<5:0>). Bits 7 and 6 are unimplemented
and read as ‘0’s.
5.3
TRIS Registers
The output driver control register is loaded with the
contents of the W register by executing the TRIS f
instruction. A '1' from a TRIS register bit puts the
corresponding output driver in a hi-impedance mode.
A '0' puts the contents of the output data latch on the
selected
pins,
enabling
the
output
buffer.
The
exceptions are RB3, which is input only, and RC5,
which may be controlled by the option register. See
The TRIS registers are “write-only” and are set (output
drivers disabled) upon RESET.
Note:
A read of the ports reads the pins, not the
output data latches. That is, if an output
driver on a pin is enabled and driven high,
but the external system is holding it low, a
read of the port will indicate that the pin is
low.
5.4
I/O Interfacing
The equivalent circuit for an I/O port pin is shown in
Figure 5-1. All port pins except RB3, which is input
only, may be used for both input and output operations.
For input operations, these ports are non-latching. Any
input must be present until read by an input instruction
(e.g., MOVF PORTB,W). The outputs are latched and
remain unchanged until the output latch is rewritten. To
use a port pin as output, the corresponding direction
control bit in TRIS must be cleared (= 0). For use as an
input, the corresponding TRIS bit must be set. Any I/O
pin (except RB3) can be programmed individually as
input or output.
FIGURE 5-1:
EQUIVALENT CIRCUIT
FOR A SINGLE I/O PIN
Data
Bus
Q
D
Q
CK
Q
D
Q
CK
P
N
WR
Port
TRIS ‘f’
Data
TRIS
RD Port
VSS
VDD
I/O
pin(1)
W
Reg
Latch
Reset
Note 1:
I/O pins have protection diodes to VDD and VSS.
Note 2:
See Table 3-1 for buffer type.
(2)
相關PDF資料 |
PDF描述 |
|---|---|
| PIC16C54CT-04I/SO | 8-BIT, OTPROM, 4 MHz, RISC MICROCONTROLLER, PDSO18 |
| PIC16C56A-20I/JW | 8-BIT, UVPROM, 20 MHz, RISC MICROCONTROLLER, CDIP18 |
| PIC16C620A-04/P301 | 8-BIT, OTPROM, 4 MHz, RISC MICROCONTROLLER, PDIP18 |
| PIC16C620A-20/P301 | 8-BIT, OTPROM, 20 MHz, RISC MICROCONTROLLER, PDIP18 |
| PIC16LC620A-20/P | 8-BIT, OTPROM, 20 MHz, RISC MICROCONTROLLER, PDIP18 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PIC16C505T-04/SL | 功能描述:8位微控制器 -MCU 1.5KB 72 RAM 12 I/O 4MHz SOIC14 RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC16C505T-04E/SL | 功能描述:8位微控制器 -MCU 1.5KB 72 RAM 12 I/O 4MHz Ext Temp SOIC14 RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC16C505T-04I/SL | 功能描述:8位微控制器 -MCU 1.5KB 72 RAM 12 I/O 4MHz Ind Temp SOIC14 RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC16C505T-20/SL | 功能描述:8位微控制器 -MCU 1.5KB 72 RAM 12 I/O 20MHz SOIC14 RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC16C505T-20E/SL | 功能描述:8位微控制器 -MCU 1.5KB 72 RAM 12 I/O 20MHz ExtTemp SOIC14 RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。