- 您現在的位置：買賣IC網 > PDF目錄3857 > PIC16C558-04/P (Microchip Technology)IC MCU OTP 2KX14 18DIP PDF資料下載
參數資料
| 型號： | PIC16C558-04/P |
| 廠商： | Microchip Technology |
| 文件頁數： | 41/108頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC MCU OTP 2KX14 18DIP |
| 產品培訓模塊： | Asynchronous Stimulus 8-bit PIC® Microcontroller Portfolio |
| 標準包裝： | 25 |
| 系列： | PIC® 16C |
| 核心處理器： | PIC |
| 芯體尺寸： | 8-位 |
| 速度： | 4MHz |
| 外圍設備： | POR，WDT |
| 輸入/輸出數： | 13 |
| 程序存儲器容量： | 3.5KB（2K x 14） |
| 程序存儲器類型： | OTP |
| RAM 容量： | 128 x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 3 V ~ 5.5 V |
| 振蕩器型： | 外部 |
| 工作溫度： | 0°C ~ 70°C |
| 封裝/外殼： | 18-DIP（0.300"，7.62mm） |
| 包裝： | 管件 |
| 產品目錄頁面： | 636 (CN2011-ZH PDF) |
| 配用： | ISPICR1-ND - ADAPTER IN-CIRCUIT PROGRAMMING 309-1059-ND - ADAPTER 18 ZIF BD W/18SO PLUGS DVA16XP180-ND - ADAPTER DEVICE FOR MPLAB-ICE AC164010-ND - MODULE SKT PROMATEII DIP/SOIC |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁當前第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁
PIC16C55X
DS40143D-page 36
Preliminary
2002 Microchip Technology Inc.
6.4
Power-on Reset (POR), Power-up
Timer (PWRT), Oscillator Start-up
Timer (OST)
6.4.1
POWER-ON RESET (POR)
A Power-on Reset pulse is generated on-chip when
V
DD rise is detected (in the range of 1.6V – 1.8V). To
take advantage of the POR, just tie the MCLR pin
through a resistor to V
DD. This will eliminate external
RC components usually needed to create Power-on
Reset. A maximum rise time for V
DD is required. See
Electrical Specifications for details.
The POR circuit does not produce internal RESET
when V
DD declines.
When the device starts normal operation (exits the
RESET condition), device operating parameters (volt-
age, frequency, temperature, etc.) must be met to
ensure operation. If these conditions are not met, the
device must be held in RESET until the operating con-
ditions are met.
For additional information, refer to Application Note
AN607 “Power-up Trouble Shooting”.
6.4.2
POWER-UP TIMER (PWRT)
The Power-up Timer provides a fixed 72 ms (nominal)
timeout on power-up only, from POR. The Power-up
Timer operates on an internal RC oscillator. The chip is
kept in RESET as long as PWRT is active. The PWRT
delay allows the V
DD to rise to an acceptable level. A
configuration bit, PWRTE can disable (if set) or enable
(if cleared or programmed) the Power-up Timer. The
Power-Up Time delay will vary from chip to chip and
due to V
DD, temperature and process variation. See
DC parameters for details.
6.4.3
OSCILLATOR START-UP TIMER
(OST)
The Oscillator Start-Up Timer (OST) provides a 1024
oscillator cycle (from OSC1 input) delay after the
PWRT delay is over. This ensures that the crystal
oscillator or resonator has started and stabilized.
The OST timeout is invoked only for XT, LP and HS
modes and only on Power-on Reset or wake-up from
SLEEP.
6.4.4
TIMEOUT SEQUENCE
On power-up, the timeout sequence is as follows: First
PWRT timeout is invoked after POR has expired, then
OST is activated. The total timeout will vary based on
oscillator configuration and PWRTE bit status. For
example, in RC mode with PWRTE bit erased (PWRT
disabled), there will be no timeout at all. Figure 6-7,
Figure 6-8 and Figure 6-9 depict timeout sequences.
Since the timeouts occur from the POR pulse, if MCLR
is kept low long enough, the timeouts will expire. Then
bringing MCLR high will begin execution immediately
(see Figure 6-8). This is useful for testing purposes or
to synchronize more than one PIC16C55X device oper-
ating in parallel.
Table 6-5 shows the RESET conditions for some spe-
cial registers, while Table 6-6 shows the RESET condi-
tions for all the registers.
相關PDF資料 |
PDF描述 |
|---|---|
| PIC16LF870-I/SO | IC MCU FLASH 2KX14 EE A/D 28SOIC |
| 06FMN-BMT-A-TF | CONN FMN HSNG 6POS SNGL NOR SMD |
| PIC16LF88-I/SO | IC MCU FLASH 4KX14 EEPROM 18SOIC |
| PIC18F26J53-I/SS | IC PIC MCU 64KB FLASH 28SSOP |
| ATMEGA128L-8AI | IC AVR MCU 128K 8MHZ LV 64-TQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PIC16C558-20/P | 功能描述:8位微控制器 -MCU 3.5KB 128 RAM 13 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC16C558-20/P | 制造商:Microchip Technology Inc 功能描述:IC 8BIT CMOS MCU 16C558 DIP18 |
| PIC16C558-20/SO | 功能描述:8位微控制器 -MCU 3.5KB 128 RAM 13 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC16C558-20/SO | 制造商:Microchip Technology Inc 功能描述:8BIT CMOS MCU SMD 16C558 SOIC18 |
| PIC16C558-20/SS | 功能描述:8位微控制器 -MCU 3.5KB 128 RAM 13 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。