參數資料
型號： PIC17C766-16/L
廠商： Microchip Technology
文件頁數： 39/159頁
文件大?。?/td> 0K
描述： IC MCU OTP 16KX16 A/D 84PLCC
產品培訓模塊： Asynchronous Stimulus
8-bit PIC® Microcontroller Portfolio
標準包裝： 16
系列： PIC® 17C
核心處理器： PIC
芯體尺寸： 8-位
速度： 16MHz
連通性： I²C，SPI，UART/USART
外圍設備： 欠壓檢測/復位，POR，PWM，WDT
輸入/輸出數： 66
程序存儲器容量： 32KB（16K x 16）
程序存儲器類型： OTP
RAM 容量： 902 x 8
電壓 - 電源 (Vcc/Vdd)： 4.5 V ~ 5.5 V
數據轉換器： A/D 16x10b
振蕩器型： 外部
工作溫度： 0°C ~ 70°C
封裝/外殼： 84-LCC（J 形引線）
包裝： 管件
配用： AC164318-ND - MODULE SKT MPLAB PM3 84PLCC
DVA17XL841-ND - DEVICE ADAPTER FOR PIC17C762
DM173001-ND - KIT DEVELOPMENT PICDEM17
AC164027-ND - ADAPTER PICSTART PLUS 84PLCC
AC174012-ND - MODULE SKT PROMATEII 84PLCC
2000 Microchip Technology Inc.
DS30289B-page 17
PIC17C7XX
4.0
ON-CHIP OSCILLATOR
CIRCUIT
The internal oscillator circuit is used to generate the
device clock. Four device clock periods generate an
internal instruction clock (TCY).
There are four modes that the oscillator can operate in.
They are selected by the device configuration bits dur-
ing device programming. These modes are:
LF
Low Frequency (FOSC
≤ 2 MHz)
XT
Standard Crystal/Resonator Frequency
(2 MHz
≤ FOSC ≤ 33 MHz)
EC
External Clock Input
(Default oscillator configuration)
RC
External Resistor/Capacitor
(FOSC
≤ 4 MHz)
There are two timers that offer necessary delays on
power-up. One is the Oscillator Start-up Timer (OST),
intended to keep the chip in RESET until the crystal
oscillator is stable. The other is the Power-up Timer
(PWRT), which provides a fixed delay of 96 ms (nomi-
nal) on POR and BOR. The PWRT is designed to keep
the part in RESET while the power supply stabilizes.
With these two timers on-chip, most applications need
no external RESET circuitry.
SLEEP mode is designed to offer a very low current
power-down mode. The user can wake from SLEEP
through external RESET, Watchdog Timer Reset, or
through an interrupt.
Several oscillator options are made available to allow
the part to better fit the application. The RC oscillator
option saves system cost while the LF crystal option
saves power. Configuration bits are used to select var-
ious options.
4.1
Oscillator Configurations
4.1.1
OSCILLATOR TYPES
The PIC17CXXX can be operated in four different oscil-
lator modes. The user can program two configuration
bits (FOSC1:FOSC0) to select one of these four
modes:
LF
Low Power Crystal
XT
Crystal/Resonator
EC
External Clock Input
RC
Resistor/Capacitor
The main difference between the LF and XT modes is
the gain of the internal inverter of the oscillator circuit,
which allows the different frequency ranges.
For more details on the device configuration bits, see
4.1.2
CRYSTAL OSCILLATOR/CERAMIC
RESONATORS
In XT or LF modes, a crystal or ceramic resonator is con-
nected to the OSC1/CLKIN and OSC2/CLKOUT pins to
establish oscillation (Figure 4-2). The PIC17CXXX oscil-
lator design requires the use of a parallel cut crystal. Use
of a series cut crystal may give a frequency out of the
crystal manufacturers specifications.
For frequencies above 24 MHz, it is common for the
crystal to be an overtone mode crystal. Use of overtone
mode crystals require a tank circuit to attenuate the
gain at the fundamental frequency. Figure 4-3 shows
an example circuit.
4.1.3
OSCILLATOR/RESONATOR
START-UP
As the device voltage increases from Vss, the oscillator
will start its oscillations. The time required for the oscil-
lator to start oscillating depends on many factors.
These include:
Crystal/resonator frequency
Capacitor values used (C1 and C2)
Device VDD rise time
System temperature
Series resistor value (and type) if used
Oscillator mode selection of device (which selects
the gain of the internal oscillator inverter)
Figure 4-1 shows an example of a typical oscillator/
resonator start-up. The peak-to-peak voltage of the
oscillator waveform can be quite low (less than 50% of
device VDD) when the waveform is centered at VDD/2
(refer to parameter #D033 and parameter #D043 in the
electrical specification section).
FIGURE 4-1:
OSCILLATOR/
RESONATOR START-UP
CHARACTERISTICS
V
DD
Crystal Start-up Time
Time
相關PDF資料
PDF描述
PIC18F8720-I/PT IC MCU FLASH 64KX16 EE 80TQFP
PIC18F8723-I/PT IC PIC MCU FLASH 64KX16 80TQFP
PIC18F6720-I/PT IC MCU FLASH 64KX16 EE 64TQFP
PIC18LF6723-I/PT IC PIC MCU FLASH 64KX16 64TQFP
PIC17C756A-33I/L IC MCU OTP 16KX16 A/D PWM 68PLCC
相關代理商/技術參數
參數描述
PIC17C766-33/L 功能描述:8位微控制器 -MCU 32KB 902 RAM 66 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
PIC17C766-33/L 制造商:Microchip Technology Inc 功能描述:8BIT CMOS MCU SMD 17C766 PLCC84
PIC17C766-33/PT 功能描述:8位微控制器 -MCU 32KB 902 RAM 66 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
PIC17C766-33E/L 功能描述:8位微控制器 -MCU 32KB 902 RAM 66 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
PIC17C766-33E/PT 功能描述:8位微控制器 -MCU 32KB 902 RAM 66 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*