- 您現在的位置：買賣IC網 > PDF目錄3852 > PIC24FJ64GA004-E/PT (Microchip Technology)IC PIC MCU FLASH 64K 44-TQFP PDF資料下載
參數資料
| 型號： | PIC24FJ64GA004-E/PT |
| 廠商： | Microchip Technology |
| 文件頁數： | 28/52頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC PIC MCU FLASH 64K 44-TQFP |
| 標準包裝： | 160 |
| 系列： | PIC® 24F |
| 核心處理器： | PIC |
| 芯體尺寸： | 16-位 |
| 速度： | 32MHz |
| 連通性： | I²C，PMP，SPI，UART/USART |
| 外圍設備： | 欠壓檢測/復位，LVD，POR，PWM，WDT |
| 輸入/輸出數： | 35 |
| 程序存儲器容量： | 64KB（22K x 24） |
| 程序存儲器類型： | 閃存 |
| RAM 容量： | 8K x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 2 V ~ 3.6 V |
| 數據轉換器： | A/D 13x10b |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 125°C |
| 封裝/外殼： | 44-TQFP |
| 包裝： | 托盤 |
| 產品目錄頁面： | 647 (CN2011-ZH PDF) |
| 配用： | 876-1004-ND - PIC24 BREAKOUT BOARD DM240011-ND - KIT STARTER MPLAB FOR PIC24F MCU AC162088-ND - HEADER MPLAB ICD2 24FJ64GA004 28 AC164335-ND - MODULE SKT FOR 10X10 PM3 44TQFP DV164033-ND - KIT START EXPLORER 16 MPLAB ICD2 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁當前第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁
PIC24FJXXXGA0XX
DS39768D-page 34
2008 Microchip Technology Inc.
5.0
THE PROGRAMMING
EXECUTIVE
5.1
Programming Executive
Communication
The programmer and programming executive have a
master-slave relationship, where the programmer is
the master programming device and the programming
executive is the slave.
All communication is initiated by the programmer in the
form of a command. Only one command at a time can
be sent to the programming executive. In turn, the
programming executive only sends one response to
the programmer after receiving and processing a
command. The programming executive command set
is described in Section 5.2 “Programming Executive
Commands”. The response set is described in
5.1.1
COMMUNICATION INTERFACE
AND PROTOCOL
The Enhanced ICSP interface is a 2-wire SPI,
implemented using the PGCx and PGDx pins. The
PGCx pin is used as a clock input pin and the clock
source must be provided by the programmer. The
PGDx pin is used for sending command data to, and
receiving response data from, the programming
executive.
Data transmits to the device must change on the rising
edge and hold on the falling edge. Data receives from
the device must change on the falling edge and hold on
the rising edge.
All data transmissions are sent to the Most Significant
bit (MSb) first, using 16-bit mode (see Figure 5-1).
FIGURE 5-1:
PROGRAMMING
EXECUTIVE SERIAL
TIMING FOR DATA
RECEIVED FROM DEVICE
FIGURE 5-2:
PROGRAMMING
EXECUTIVE SERIAL TIMING
FOR DATA TRANSMITTED
TO DEVICE
Since a 2-wire SPI is used, and data transmissions are
half duplex, a simple protocol is used to control the
direction of PGDx. When the programmer completes a
command transmission, it releases the PGDx line and
allows the programming executive to drive this line
high. The programming executive keeps the PGDx line
high to indicate that it is processing the command.
After the programming executive has processed the
command, it brings PGDx low for 15
μsec to indicate to
the programmer that the response is available to be
clocked out. The programmer can begin to clock out the
response 23
μsec after PGDx is brought low, and it must
provide the necessary amount of clock pulses to receive
the entire response from the programming executive.
After the entire response is clocked out, the program-
mer should terminate the clock on PGCx until it is time
to send another command to the programming
executive. This protocol is shown in Figure 5-3.
5.1.2
SPI RATE
In Enhanced ICSP mode, the PIC24FJXXXGA0XX
family devices operate from the internal Fast RC oscil-
lator (FRCDIV), which has a nominal frequency of
8 MHz. This oscillator frequency yields an effective
system clock frequency of 4 MHz. To ensure that the
programmer does not clock too fast, it is recommended
that a 4 MHz clock be provided by the programmer.
5.1.3
TIME-OUTS
The programming executive uses no Watchdog Timer
or time-out for transmitting responses to the program-
mer. If the programmer does not follow the flow control
mechanism using PGCx, as described in Section 5.1.1
possible that the programming executive will behave
unexpectedly while trying to send a response to the
programmer. Since the programming executive has no
time-out, it is imperative that the programmer correctly
follow the described communication protocol.
As a safety measure, the programmer should use the
command time-outs identified in Table 5-1. If the
command time-out expires, the programmer should
reset
the
programming
executive
and
start
programming the device again.
PGCx
PGDx
12
3
11
13
15
16
14
12
LSb
14
13
12
11
45
6
MSb
1
2
3
...
4
5
P2
P3
P1
P1B
P1A
PGCx
PGDx
12
3
11
13
15
16
14
12
LSb
14
13 12
11
45
6
MSb
1
2
3
...
4
5
P2
P3
P1
P1B
P1A
相關PDF資料 |
PDF描述 |
|---|---|
| PIC18F65K90-I/PTRSL | MCU PIC 32K FLASH MEM XLP 64TQFP |
| PIC18F1320-I/ML | IC MCU FLASH 4KX16 EEPROM 28QFN |
| DSPIC33EP64MC202-I/MM | IC DSC 16BIT 64KB FLASH 28QFN |
| PIC24EP64MC202-I/MM | MCU 16BIT 64KB FLASH 28QFNS |
| PIC24EP64GP202-I/MM | MCU 16BIT 64KB FLASH 28QFNS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PIC24FJ64GA004-I/ML | 功能描述:16位微控制器 - MCU 64KB FL 8192b RAM 16MIPS 35I/O 16b Fam RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT |
| PIC24FJ64GA004-I/PT | 功能描述:16位微控制器 - MCU 64KB 8192 bytes 16MIPS 35 I/O RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT |
| PIC24FJ64GA004T-I/ML | 功能描述:16位微控制器 - MCU 64KB Flash 8192bytes-RAM 35I/O RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT |
| PIC24FJ64GA004T-I/PT | 功能描述:16位微控制器 - MCU 64KB Flash 8192bytes-RAM 35I/O RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT |
| PIC24FJ64GA006 | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:General Purpose, 16-Bit Flash Microcontrollers |
發布緊急采購，3分鐘左右您將得到回復。