參數資料
型號： PLRXXL-SC-S43-C1
廠商： JDS UNIPHASE CORP
元件分類： 光收發
英文描述： FIBER OPTIC TRANSCEIVER, 840-860nm, 10312.5Mbps(Tx), 10312.5Mbps(Rx), PANEL MOUNT, LC CONNECTOR
封裝： ROHS COMPLIANT PACKAGE-30
文件頁數： 8/14頁
文件大小： 573K
代理商： PLRXXL-SC-S43-C1
3
ROHS COMPLIANT XFP OPTICAL TRANSCEIVER – 850NM
FOR UP TO 300M REACH
The JDSU 10 Gb/s 850 nm XFP optical transceiver has several low-speed interface
connections including a 2-wire serial interface. These connections include; mod-
ule not ready (Mod_NR), module deselect (Mod_DeSel), Interrupt, transmitter
disable (TX_DIS), module absent (Mod_ABS), Receive Loss Of Signal (RX_LOS),
and power down/reset (P_Down/RST).
Two loopback modes are available through the two-wire serial interface. The
loopback modes are useful to facilitate stand-alone testing. In system loopback
mode, data recovered from the system side transmit interface is re-directed to the
system side receive interface. This facilitates system side test and debug. In net-
work loopback mode, data recovered from the line side receive interface (optics)
is looped to the line side transmitter output back to the ber.
Transmitter
The transmitter path converts 9.95 Gb/s, 10.3 Gb/s, 10.5 Gb/s, or 10.75 Gb/s NRZ
electrical data to a standard compliant optical signal. The transmitter accepts a
100
Ω differential 120 mV peak-to-peak to 1000 mV peak-to-peak 10 Gb/s CML
electrical signal on TD- and TD+ pins. This performance exceeds the XFI “Ziffy”
specication in the XFP MSA INF8077i revision 4.5 and provides over 300 mm
(12 inches) reach on improved FR4 material (loss tangent of 0.016) and offers
greater exibility to system integrators for host board layout.
Inside the module, the differential signals pass through a signal conditioner with
equalization that compensates for losses and deterministic jitter present on the
input data stream. A reference clock input (RefCLK+, RefCLK-) is used by the
internal PLL to determine line rate and signal lock condition. The Tx clock cir-
cuit provides a lock alarm output, failure to lock results in Mod_NR asserted. The
output of the Tx signal conditioner is input to the laser driver circuit which trans-
forms the small swing digital voltage to an output modulation and bias current
that drives a directly modulated 850 nm VCSEL. The optical signal is engineered
to meet the IEEE802.3 2005 Clause 52 10GBASE-SR, 10GBASE-SW, and 10 GFC
specications. Closed-loop control of the transmitted laser power over tempera-
ture and voltage variations is provided. An LC connectorized receptacle provides
the mechanical interface to the multi-mode ber plant.
Receiver
The receiver converts incoming DC balanced serial 9.95 Gb/s, 10.3 Gb/s, 10.5 Gb/s,
or 10.75 Gb/s NRZ optical data into serial XFI electrical data. An LC connector-
ized receptacle provides the mechanical interface to the multi-mode ber plant.
A high speed PIN photodiode converts the optical signal into a current which
is converted to a voltage in a high-gain transimpedance amplier. The amplied
signal is passed to a signal conditioning IC that provides clock and data recovery.
Loss of signal, and signal lock detection is included in the receive circuitry that is
reected in the Mod_NR status pin. The recovered data is output on the RD+ and
RD- pins as a 100
Ω 250 mV peak-to-peak CML signal. The output signal meets
the XFP MSA requirements.
相關PDF資料
PDF描述
PLS-2 Broadband, 100 to 900 MHz
PLS13W3F0000 13 CONTACT(S), FEMALE, POWER CONNECTOR
PLS13W3M0000 13 CONTACT(S), MALE, POWER CONNECTOR
PLS7W3F0000 7 CONTACT(S), FEMALE, POWER CONNECTOR
PLS7W3M0000 7 CONTACT(S), MALE, POWER CONNECTOR
相關代理商/技術參數
參數描述
PLS 制造商:Ohmite Mfg Co 功能描述: 制造商:Ssac 功能描述:
PLS USE 74LVT16245BDGG,118 INSTEAD 制造商:NXP Semiconductors 功能描述:LOGIC IC CMOS
PLS00005 制造商:Pulse 功能描述:Table Top Microphone Clamp
PLS00006 制造商:Pulse 功能描述:Articulating Broadcast Studio Microphone
PLS00010 制造商:Pulse Electronics Corporation 功能描述:SPEAKER STAND 35MM SILVER
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*