- 您現在的位置：買賣IC網 > PDF目錄69063 > PME5218T (ERICSSON POWER MODULES AB) DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | PME5218T |
| 廠商： | ERICSSON POWER MODULES AB |
| 元件分類： | 電源模塊 |
| 英文描述： | DC-DC REG PWR SUPPLY MODULE |
| 封裝： | ROHS COMPLIANT, SMD-6 |
| 文件頁數： | 16/32頁 |
| 文件大?。?/td> | 742K |
| 代理商： | PME5218T |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
Ericsson Internal
PRODUCT SPEC.
1 (5)
Prepared (also subject responsible if other)
No.
SEC/D KEVIN YAN
3/1301-BMR 642 5 Uen
Approved
Checked
Date
Rev
Reference
SEC/D Wei Zhang A
2007-1-26
B
EMC Specification
Conducted EMI measured according to test set-up.
The fundamental switching frequency is 600 kHz for
PME 5218T @ VI = 5.0 V, max IO.
Conducted EMI Input terminal value (typ)
TBD
EMI without filter
TBD
Test set-up
Layout recommendation
The radiated EMI performance of the DC/DC regulator will
depend on the PCB layout and ground layer design.
It is also important to consider the stand-off of the DC/DC
regulator.
If a ground layer is used, it should be connected to the output
of the DC/DC regulator and the equipment ground or chassis.
A ground layer will increase the stray capacitance in the PCB
and improve the high frequency EMC performance.
Output ripple and noise
Output ripple and noise measured according to figure below.
See Design Note 022 for detailed information.
Output ripple and noise test setup
Operating information
Extended information for POLA products is found in
Application Note POLA.
Input Voltage
The input voltage range 4.50 to 5.50 Vdc makes the product
easy to use in intermediate bus applications when powered
by a regulated bus converter.
Turn-off Input Voltage
The DC/DC regulators monitor the input voltage and will turn
on and turn off at predetermined levels.
The minimum hysteresis between turn on and turn off input
voltage is 50mV.
Remote Control (RC) Inhibit
The products are fitted with a
remote control function referenced
to the primary negative input
connection (- In), positive logic. The
INHIBIT function allows the
regulator to be turned on/off by an
external device like a
semiconductor or mechanical
switch. The INHIBIT pin has an
internal pull up resistor to + In.
The regulator will turn on when the input voltage is applied
with the INHIBIT pin open. Turn off is achieved by connecting
the INHIBIT pin to the - In. To ensure safe turn off, the voltage
difference between INHIBIT pin and the - In pin shall be less
than 0.6V. The regulator will restart automatically when this
connection is opened.
E
PME 5000 series
POL regulator, Input 4.5-5.5 V, Output 6 A/21.6 W
EN/LZT 146 314 R1B Aug 2007
Ericsson Power Modules AB
Technical Specication
23
相關PDF資料 |
PDF描述 |
|---|---|
| PME5218TP | 1-OUTPUT 21.6 W DC-DC REG PWR SUPPLY MODULE |
| PME5218TS | 1-OUTPUT 21.6 W DC-DC REG PWR SUPPLY MODULE |
| PMF4118VSRF | POWER SUPPLY SUPPORT CKT, DMA10 |
| PMF4118VPF | POWER SUPPLY SUPPORT CKT, DMA10 |
| PMF8118VSRF | 1-OUTPUT 12.5 W DC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PME5218TP | 功能描述:DC/DC轉換器 0.8-3.6V 6A Non-Iso Input 5V 21.6W RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| PME5218TS | 功能描述:DC/DC轉換器 .8-3.6 Vdc 6A Iso Input 5V 21.6W RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| PME5218TSR | 功能描述:DC/DC轉換器 0.8-3.6V 6A Non-Iso Input 5V 21.6W RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| PME-5FF-RYGBC | 制造商:Autonics Corporation 功能描述:TOWER LIGHT 90-240VAC 163mA 制造商:Autonics Corporation 功能描述:TOWER LIGHT, 90-240VAC, 163mA 制造商:Autonics Corporation 功能描述:TOWER LIGHT, 90-240VAC, 163mA, IP / NEMA Rating:IP56, Flash Rate Per Minute:80, |
| PME60-619KOHMSPORM1PCT | 制造商: 功能描述: 制造商:undefined 功能描述: |
發(fā)布緊急采購，3分鐘左右您將得到回復。