參數(shù)資料
型號: PQ60033HTA50PYS
廠商: SYNQOR INC
元件分類: 電源模塊
英文描述: 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
文件頁數(shù): 4/14頁
文件大?。?/td> 756K
代理商: PQ60033HTA50PYS
Product # PQ60033HTA50
Phone 1-888-567-9596
www.synqor.com
Doc.# 005-2HT633F Rev. A
4/11/03
Page 12
Input:
Output:
Current:
P
Package:
ackage:
35-75 V
3.3 V
50 A
Half-brick
T
Technical S
echnical Specification
pecification
Startup Inhibit Period: The Startup Inhibit Period ensures that
the converter will remain off for approximately 200ms when it is
shut down for any reason. When an output short is present, this
generates a 5Hz "hiccup mode," which prevents the converter
from overheating. In all, there are seven ways that the converter
can be shut down, initiating a Startup Inhibit Period:
Input Under-Voltage Lockout
Input Over-Voltage Shutdown (not present in Quarter-brick)
Output Over-Voltage Protection
Over Temperature Shutdown
Current Limit
Short Circuit Protection
Turned off by the ON/OFF input
Figure F shows three turn-on scenarios, where a Startup Inhibit
Period is initiated at t0, t1, and t2:
Before time t0, when the input voltage is below the UVL threshold,
the unit is disabled by the Input Under-Voltage Lockout feature.
When the input voltage rises above the UVL threshold, the Input
Under-Voltage Lockout is released, and a Startup Inhibit Period is
initiated. At the end of this delay, the ON/OFF pin is evaluated,
and since it is active, the unit turns on.
At time t1, the unit is disabled by the ON/OFF pin, and it cannot
be enabled again until the Startup Inhibit Period has elapsed.
When the ON/OFF pin goes high after t2, the Startup Inhibit
Period has elapsed, and the output turns on within the typical
Turn-On Time.
FULL FEATURE APPLICATION NOTES
This section provides some basic application information for the
full-feature version of the
PowerQor series converter. The pin-out
configuration for these optional feature pins is shown on page 2,
and the part numbering format is shown on the last page of this
specification sheet.
All units in this product family include back-drive protection to
simplify the use of multiple converters in a parallel or sequencing
application. However, any voltage applied to the output of the
converter should be kept below 120% of the rated output voltage
of the converter.
In addition to back-drive protection, these units include the fol-
lowing features (pins):
Current Share (pin 3): The active current share feature allows
for N+1 and parallel applications. To achieve load sharing,
directly connect the I share pins of multiple units. The load current
will share equally among the multiple units (±5% at full rated cur-
rent). It is important that the Vin(-) pins of the sharing units be
directly connected and NOT placed outside of an EMI filter or
other impedance path. The voltage at the I Share pin will range
from 0 to 5 volts (at full rated current), referenced to the primary-
Under-Voltage
Lockout Turn-On
Threshold
ON/OFF
(pos logic)
Figure F: Startup Inhibit Period (turn-on time not to scale)
Vout
Vin
200ms
(typical start-up
inhibit period)
t0
t1
t2
t
20ms (typical
turn on time)
ON
OFF
相關PDF資料
PDF描述
PQ60033HTA50NNF 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
PQ60033HTA50NYF 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
PQ60033HTA50PNF 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
PQ60033QGA25NYS 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
PQ60033QGA25PKS 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
相關代理商/技術參數(shù)
參數(shù)描述
PQ60033QGA25 制造商:SYNQOR 制造商全稱:SYNQOR 功能描述:25 Amp, No Heatsink, Isolated DC/DC Converter
PQ60033QGA25NKS 制造商:SYNQOR 制造商全稱:SYNQOR 功能描述:25 Amp, No Heatsink, Isolated DC/DC Converter
PQ60033QGA25NNS 制造商:SynQor 功能描述:
PQ60033QGA25NNS-G 制造商:SynQor 功能描述:PowerQor DC/DC Converters 制造商:SynQor 功能描述:DC-DC CONV, ISO POL, 1 O/P, 25A, 3.3V, DC / DC Converter Type:Quarter Brick, DC / DC Converter Output Type:Fixed, Input Voltage DC Min:35V, Input Voltage DC Max:75V, No. of Outputs:1, Output Voltage Nom.:3.3V, Output Current Max:25A , RoHS Compliant: Yes
PQ60033QGA25NRS 制造商:SYNQOR 制造商全稱:SYNQOR 功能描述:25 Amp, No Heatsink, Isolated DC/DC Converter