- 您現在的位置：買賣IC網 > PDF目錄69112 > PSB155-9IR (POWER-ONE INC) 1-OUTPUT DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | PSB155-9IR |
| 廠商： | POWER-ONE INC |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| 文件頁數： | 2/13頁 |
| 文件大?。?/td> | 220K |
| 代理商： | PSB155-9IR |
PSB Series Extended Data Sheet
Positive Switching Regulator (Industrial)
REV. OCT 17, 2003
Page 10 of 13
Safety and Installation Instructions
Installation Instruction
Installation of the switching regulators must strictly follow
the national safety regulations in compliance with the enclo-
sure, mounting, creepage, clearance, casualty, markings
and segregation requirements of the end-use application.
Check for hazardous voltages before altering any connec-
tions. Connections can be made using fast-on or soldering
technique.
The input and the output circuit are not separated, i.e. the
negative path is internally interconnected!
The units should be connected to a secondary circuit.
Do not open the module.
Ensure that a unit failure (e.g. by an internal short-circuit)
does not result in a hazardous condition. See also:
Safety
of operator accessible output circuit.
Cleaning Agents
In order to avoid possible damage, any penetration of
cleaning fluids is to be prevented, since the power supplies
are not hermetically sealed.
Protection Degree
The protection degree is IP 20.
Standards and Approvals
All switching regulators are UL recognized according to UL
1950, UL 1012 and EN 60950 and UL recognized for
Canada to CAN/CSA C22.2 No. 234-M90.
The units have been evaluated for:
Building in,
Operational insulation from input to output and input/out-
put to case,
The use in an overvoltage category II environment,
The use in a pollution degree 2 environment.
The switching regulators are subject to manufacturing sur-
veillance in accordance with the above mentioned UL and
CSA and with ISO 9001 standards.
Isolation
Electric strength test voltage between input interconnected
with output and case: 750 VDC, 1 s.
This test is performed as factory test in accordance with
IEC/EN 60950 and UL 1950 and should not be repeated in
the field. Power-One will not honour any guarantee claims
resulting from electric strength field tests.
Safety of Operator Accessible Output Circuit
If the output circuit of a switching regulator is operator-ac-
cessible, it shall be an SELV circuit according to IEC/EN
60950 related safety standards
The following table shows some possible installation con-
figurations, compliance with which causes the output circuit
of the switching regulator to be an SELV circuit according to
IEC/EN 60950 up to a nominal output voltage of 30 V, or
48 V if option C is fitted.
However, it is the sole responsibility of the installer or user
to assure the compliance with the relevant and applicable
safety regulations.
More information is given in:
Technical Information: Safety
& EMC.
相關PDF資料 |
PDF描述 |
|---|---|
| PSB245-7LIR | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| PSB5A6-9IP | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| PSB5A7-9IPC | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| PSB2120-T | SWITCHING CONTROLLER, 250 kHz SWITCHING FREQ-MAX, PDSO24 |
| PSB2121-T | 0.005 A SWITCHING CONTROLLER, 250 kHz SWITCHING FREQ-MAX, PDSO20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PSB156-2 | 功能描述:SWITCHING REGULATOR 90W 15V RoHS:是 類別:電源 - 板載 >> DC DC Converters 系列:* 標準包裝:5 系列:* |
| PSB156-2IR | 制造商:Power-One 功能描述:DC/DC PS SGL-OUT 15V 6A 90W 7PIN - Bulk |
| PSB16 | 制造商:Pentair Technical Products / Hoffman 功能描述:Panel Support Brace 1600mm |
| PSB-161 | 制造商:PMI 制造商全稱:PMI 功能描述:SPLIT BOBBIN HIGH ISOLATION POWER TRANSFORMERS |
| PSB-1612 | 制造商:PMI 制造商全稱:PMI 功能描述:SPLIT BOBBIN HIGH ISOLATION POWER TRANSFORMERS |
發布緊急采購，3分鐘左右您將得到回復。