- 您現在的位置：買賣IC網 > PDF目錄69123 > PSC5A12-9LIR (POWER-ONE INC) 1-OUTPUT DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | PSC5A12-9LIR |
| 廠商： | POWER-ONE INC |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| 文件頁數： | 3/13頁 |
| 文件大?。?/td> | 223K |
| 代理商： | PSC5A12-9LIR |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁
PSC Series Extended Data Sheet
Positive Switching Regulators (Industrial)
REV. MAY 12, 2004
Page 11 of 13
Description of Options
-9
Extended Temperature Range
The operational ambient temperature range is extended to
TA = –40 to 71°C. (TC = –40 to 95°C, TS = –55 to 100°C.)
P
Potentiometer
Option P excludes R function. The output voltage
Vo can be
adjusted with a screwdriver in the range from 0.92 - 1.08 of
the nominal output voltage
Vo nom.
However, the minimum differential voltage
DVio min between
input and output voltages as specified in:
Electrical Input
Data should be maintained.
L
Input Filter
Option L is recommended to reduce superimposed inter-
ference voltages and to prevent oscillations, if input lines
exceed approx. 5 m in total length. The fundamental wave
(approx. 120 kHz) of the reduced interference voltage be-
tween Vi+ and Gi– has, with an input line inductance of
5 H, a maximum magnitude of 4 mVAC. A reduction can
be achieved by insertion of a capacitor across the input
(e.g. plastic foil between Vi+ and Gi–).
The input impedance of the switching regulator at 120 kHz
is about 3.5
.The harmonics are small in comparison with
the fundamental wave. See also:
Electrical Input Data: RFI.
C
Crowbar
This option is recommended to protect the load against
power supply malfunction, but it is not designed to sink ex-
ternal currents.
A fixed-value monitoring circuit checks the output voltage
Vo. When the trigger voltage Vo c is reached, the thyristor
crowbar triggers and disables the output. It may be deacti-
vated by removal of the input voltage. In case of a switching
transistor defect, an internal fuse prevents excessive cur-
rent.
Note: As a central overvoltage protection device, the crow-
bar is usually connected to the external load via distributed
inductance of the lines. For this reason, the overvoltage at
the load can temporarily exceed the trigger voltage
Voc. De-
pending on the application, further decentralized over-
voltage protection elements may have to be used addition-
ally.
With option L, the maximum permissible additionally su-
perimposed ripple
ui of the input voltage (rectifier mode) at
a specified input frequency
f i has the following values:
Units with max input voltage 40 V:
ui max = 12 Vpp at 100 Hz or Vpp = 1200 Hz/f i 1V
Units with max input voltage 80 V:
ui max = 22 Vpp at 100 Hz or Vpp = 2200 Hz/f i 1V
D
Save Data Input Undervoltage Monitor
Note: Output instead of input undervoltage monitor is
available on request (Option D1).
Terminal D and Go– are connected to a normally conduct-
ing field effect transistor (JFET). The switching characteris-
tics of the option D output are shown in fig. Definition of
Vt
and
VH. A 0.5 W Zener diode provides protection against
overvoltages.
The voltage
Vt can be externally adjusted with a trim poten-
tiometer by means of a screwdriver. The hysteresis
VH of Vt
is <2 %. Terminal D stays low for a minimum time
tlow min, in
order to prevent any oscillation.
Vt can be set to a value
between
Vi min and Vi max. Please note that the JFET be-
comes conductive when
VD increases above 7 V approx.
Fig. 13
Test circuit with definition of voltage VD and current ID
Vi +
Gi –
Go –
8.2 V
D
VD
+5 V
100 pF
ID
10 k
JFET
Vt
11025
Table 10: Crowbar trigger levels
Characteristics
Conditions
5.1 V
12 V
15 V
24 V
36 V
Unit
min
max
min
max
min
max
min
max
min
max
Vo c
Trigger voltage
Vi min - Vi max
5.8
6.8
13.5
16
16.5
19
27
31
40
45.5
V
Io = 0 - Io nom
t s
Delay time
TC min - TC max
1.5
s
相關PDF資料 |
PDF描述 |
|---|---|
| PSC128-7IRCD | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| PSC128-7LIRCD | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| PSC128-9LIRC | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| PSC368-9LIPD1 | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| PSC368-9LIRD | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PSC6.3VB1500MJ11 | 制造商:CHEMI-CON 制造商全稱:United Chemi-Con, Inc. 功能描述:Conductive polymer Aluminum solid capacitors |
| PSC6.3VB470MH08 | 制造商:CHEMI-CON 制造商全稱:United Chemi-Con, Inc. 功能描述:Conductive polymer Aluminum solid capacitors |
| PSC6.3VB820MJ11 | 制造商:CHEMI-CON 制造商全稱:United Chemi-Con, Inc. 功能描述:Conductive polymer Aluminum solid capacitors |
| PSC-60 | 功能描述:線性和開關式電源 RoHS:否 制造商:TDK-Lambda 產品:Switching Supplies 開放式框架/封閉式:Enclosed 輸出功率額定值:800 W 輸入電壓:85 VAC to 265 VAC 輸出端數量:1 輸出電壓（通道 1）:20 V 輸出電流（通道 1）:40 A 商用/醫用: 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:Rack 長度: 寬度: 高度: |
| PSC-60_11 | 制造商:MEANWELL 制造商全稱:Mean Well Enterprises Co., Ltd. 功能描述:60W Single Output with Battery Charger(UPS Function) |
發布緊急采購，3分鐘左右您將得到回復。