- 您現在的位置：買賣IC網 > PDF目錄69129 > PSL366-7RCDA 1-OUTPUT DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | PSL366-7RCDA |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| 封裝： | METAL, CASE L04, MODULE |
| 文件頁數： | 4/11頁 |
| 文件大?。?/td> | 247K |
| 代理商： | PSL366-7RCDA |
Rugged Environment
Switching Regulators 19"
PSL-Family
Edition 2/96 - Melcher AG
5 - 3
MELCHER
The Power Partners.
5.1
Control circuit
P (option)
Go–
Vo+
Gi–
Vi+
Input
Filter
L (option)
R/i
Io
Uo
I i
Ui
Ce
C (option)
D (option)
+
–
A (option)
Fig. 1
Block diagram
Note: Check for hazardous voltages before altering
any connections. Do not open the module. The input
and the output circuitry are not separated, i.e. the nega-
tive path is internally interconnected!
Safety and Installation Instructions
Safety
If the output circuit of a switching regulator is operator-ac-
cessible according to the IEC 950 related safety standards,
it shall be an SELV circuit (Safety Extra Low Voltage circuit,
i.e. a circuit, separated from mains by at least basic insula-
tion, that is so designed and protected that under normal
and single fault conditions, the voltage between any two
conductors and between any conductor and earth does not
exceed 60 V DC).
In the following section an interpretation is provided of the
IEC 950 safety standard with respect to the safety status of
the output circuit. However, it is the sole responsibility of the
installer or user to assure the compliance with the relevant
and applicable safety standards.
If the following table is observed, the output of any switch-
ing regulator is considered to be an SELV circuit up to a
nominal output voltage of 36 V, or up to 48 V if option C is
fitted.
Table 2: Insulation concept for SELV circuits
Nominal
Minimum required grade
Maximum
Minimum required
Measures to achieve the
Resulting safety
mains
of isolation, to be
output
safety status of the
specified safety status
status of the
supply
provided by the AC-DC
voltage
front end output circuit
of the output circuit
switching
voltage
front end, including mains from the
regulator output
(AC)
supplied battery charger
front end
circuit
None
Battery supply completely
≤60 V
SELV battery circuit
None
SELV circuit
separated from mains
≤144 V
Hazardous voltage battery
Input fuse 1 and unearthed,
SELV circuit
circuit 2
non operator-accessible case 2
Hazardous voltage battery
Input fuse 1 and earthed output Earthed SELV
circuit
circuit 3 and earthed 3 or non
circuit
operator-accessible case
≤250 V
Basic
≤60 V
Earthed SELV circuit
Earthed input circuit 3
SELV circuit
ELV circuit
Input fuse 1 and
Earthed SELV
earthed output circuit 3
circuit
≤144 V
Hazardous voltage
Input fuse 1 and earthed output Earthed SELV
secondary circuit
circuit 3 and earthed 3 or non
circuit
operator-accessible case
Double or reinforced
≤60 V
SELV circuit
None
SELV circuit
≤144 V
Double or reinforced insu-
Input fuse 1 and unearthed and SELV circuit
lated unearthed hazardous non operator-accessible case 2
voltage secondary circuit 2
1 The installer shall provide an approved fuse (slow blow type with lowest rating suitable for the application, max. 12.5 A) in the positive
or negative input conductor directly at the input of the switching regulator. For UL's purpose, the fuse needs to be UL-listed. If option C
is fitted, a suitable fuse is built-in.
2 Has to be insulated from earth by double or reinforced insulation according to the relevant safety standard, based on the maximum in-
put voltage of the switching regulator (contrary to case marking: "This apparatus must be earthed.").
3 The earth connection has to be provided by the installer according to the relevant safety standards, e.g. IEC 950.
相關PDF資料 |
PDF描述 |
|---|---|
| PSL246-9IPCDA | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| PSL366-9LIRPCDA | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| PSL156-9LIRPCDA | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| PSL126-9IPCDA | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| PSL126-7LIPD1A | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PSL366-9R | 制造商:Power-One 功能描述:DC/DC PS SGL-OUT 36V 6A 216W 11PIN - Bulk |
| PSL-368 | 功能描述:標準環形連接器 3.6MM SURLOK LUG RoHS:否 制造商:Hirose Connector 系列:EM-W 產品類型:Accessories 位置/觸點數量:1 觸點類型: 觸點電鍍: 安裝風格:Cable 外殼材質: 端接類型:Clamp 電壓額定值: |
| PSL368-7R | 功能描述:SWITCHING REGULATOR 288W 36V RoHS:是 類別:電源 - 板載 >> DC DC Converters 系列:* 標準包裝:5 系列:* |
| PSL368-9R | 制造商:Power-One 功能描述:DC/DC PS SGL-OUT 36V 8A 288W 11PIN - Bulk |
| PSL-368K | 功能描述:標準環形接頭 3.6MM PLASTIC SURLOK RADSOK 8AWG 70 AMPS RoHS:否 制造商:TE Connectivity / AMP 系列:Multimate III+ 觸點尺寸: 觸點類型:Pin (Male) 觸點材料: 觸點電鍍:Tin over Nickel 觸點類型2: 電流額定值:13 A 電壓額定值: |
發布緊急采購，3分鐘左右您將得到回復。