參數資料
型號: PSR242-7-7IP
廠商: POWER-ONE INC
元件分類: 電源模塊
英文描述: 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
文件頁數: 7/11頁
文件大?。?/td> 652K
代理商: PSR242-7-7IP
Industrial Environment
Switching Regulators, PCB & Chassis
PSR Series
Edition 4/4.99
5/11
MELCHER
The Power Partners.
Thermal Considerations
When a switching regulator is located in free, quasi-sta-
tionary air (convection cooling) at a temperature
TA = 71
°C
and is operated at its nominal output current
Io nom, the
case temperature
TC will be about 95
°C after the warm-up
phase, measured at the
Measuring point of case tempera-
ture TC (see: Mechanical Data).
Under practical operating conditions, the ambient tem-
perature
TA may exceed 71
°C, provided additional meas-
ures (heat sink, fan, etc.) are taken to ensure that the case
temperature
TC does not exceed its maximum value of
95
°C.
Example: Sufficient forced cooling allows
TA max = 85
°C. A
simple check of the case temperature
TC (TC
≤ 95°C) at
full load ensures correct operation of the system.
1.2
1.0
0.8
0.6
0.4
0
0.2
0.4
1.0
1.2
0.2
0.6
0.8
1.4
Uo/Uo nom
Io/Io nom
I o
nom
Io L
05033
Fig. 5
Overload, short-circuit behaviour Uo versus Io.
0
0.1
0.2
0.3
0.4
0.5
0.6
0.7
0.8
50
60
70
80
90
100
Io/Io nom
TA [°C]
0.9
1.0
Forced cooling
05031
TA min
TC max
Convection cooling
Parallel and Series Connection
Outputs of equal nominal voltages can be parallel-con-
nected. However, the use of a single unit with higher out-
put power, because of its power dissipation, is always a
better solution.
In parallel-connected operation, one or several outputs
may operate continuously at their current limit knee-point
which will cause an increase of the heat generation. Con-
sequently, the max. ambient temperature value should be
reduced by 10 K.
Outputs can be series-connected with any other module.
In series-connection the maximum output current is limited
by the lowest current limitation. Electrically separated
source voltages are needed for each module!
Short Circuit Behaviour
A constant current limitation circuit holds the output cur-
rent almost constant whenever an overload or a short cir-
cuit is applied to the regulator's output. It acts self-protect-
ing and recovers – in contrary to the fold back method –
automatically after removal of the overload or short circuit
condition.
Fig. 4
Output current derating versus temperature
Output Protection
A voltage suppressor diode which in worst case conditions
fails into a short circuit, protects the output against an in-
ternally generated overvoltage. Such an overvoltage could
occur due to a failure of either the control circuit or the
switching transistor. The output protection is not designed
to withstand externally applied overvoltages. The user
should ensure that systems with Melcher power supplies,
in the event of a failure, do not result in an unsafe condi-
tion (fail-safe).
Auxiliary Functions
LED Output Voltage Indicator
A yellow output indicator LED shines when the output volt-
age is higher than approx. 3 V.
The LED output voltage indicator is not available for
PSR 52.
相關PDF資料
PDF描述
PSR242-7-9R 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
PSR53-7-9R 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
PSR54-7-7R 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
PSR54-7-9P 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
PSR152.5-7-9PY 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
相關代理商/技術參數
參數描述
PSR-24282-2 功能描述:可復位保險絲 - RoHS:否 制造商:Bourns 電流額定值: 電阻:7.5 Ohms 最大直流電壓: 保持電流:0.1 A 安裝風格:SMD/SMT 端接類型:SMD/SMT 跳閘電流:0.6 A 引線間隔: 系列:MF-PSHT 工作溫度范圍:- 40 C to + 125 C
PSR-24282F-2 功能描述:可復位保險絲 - RoHS:否 制造商:Bourns 電流額定值: 電阻:7.5 Ohms 最大直流電壓: 保持電流:0.1 A 安裝風格:SMD/SMT 端接類型:SMD/SMT 跳閘電流:0.6 A 引線間隔: 系列:MF-PSHT 工作溫度范圍:- 40 C to + 125 C
PSR242-9 制造商:Power-One 功能描述:DC/DC PS SGL-OUT 24V 2A 48W 6PIN - Bulk
PSR-24292 功能描述:可復位保險絲 - RoHS:否 制造商:Bourns 電流額定值: 電阻:7.5 Ohms 最大直流電壓: 保持電流:0.1 A 安裝風格:SMD/SMT 端接類型:SMD/SMT 跳閘電流:0.6 A 引線間隔: 系列:MF-PSHT 工作溫度范圍:- 40 C to + 125 C
PSR242-9IR 制造商:Power-One 功能描述: