- 您現在的位置：買賣IC網 > PDF目錄69175 > PT6507F (TEXAS INSTRUMENTS INC) 20 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, SMA14 PDF資料下載
參數資料
| 型號： | PT6507F |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 20 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, SMA14 |
| 封裝： | SURFACE MOUNT PACKAGE-14 |
| 文件頁數： | 9/11頁 |
| 文件大小： | 231K |
| 代理商： | PT6507F |
Application Notes
For technical support and more information, see inside back cover or visit www.ti.com/powertrends
PT6500 Series
Using the Standby Function on the
PT6500 5V/3.3V Bus Converters
For applications requiring output voltage On/Off control,
the 14-pin PT6500 ISR series incorporates a standby
function. This function may be used in applications that
require power-up/shutdown sequencing, and wherever
there is a requirement for the output status of the module
to be controlled by external circuitry.
The standby function is provided by the STBY* control,
pin 3. If pin 3 is left open-circuit the regulator operates
normally, and provides a regulated output when a valid
supply voltage is applied to V
in (pins 4, 5, & 6) with re-
spect to GND (pins 7-10). If a low voltage2 is then
applied to pin-3 the regulator output will be disabled and
the input current drawn by the ISR will drop to less than
50mA4. The standby control may also be used to hold-off
the regulator output during the period that input power is
applied.
The standby control pin is ideally controlled using an
open-collector (or open-drain) discrete transistor (See
Figure 1). It may also be driven directly from a dedicated
TTL3 compatible gate. Table 1 provides details of the
threshold requirements.
Table 1 Inhibit Control Thresholds (2,3)
Parameter
Min
Max
Enable (VIH)
1V
5V
Disable (VIL)
–0.1V
0.35V
Notes:
1. The Standby/Inhibit control logic is similar for all Power
Trends’ modules, but the flexibility and threshold
tolerances will be different. For specific information on
this function for other regulator models, consult the
applicable application note.
2. The Standby control pin is ideally controlled using an
open-collector (or open-drain) discrete transistor and
requires no external pull-up resistor. The control input has
an open-circuit voltage of about 1Vdc. To disable the
regulator output, the control pin must be pulled to less
than 0.35Vdc with a low-level 0.5mA sink to ground.
3. The Standby input on the PT6500 series may be driven by
a differential output device, making it compatible with
TTL logic. A standard TTL logic gate will meet the
0.35V VIL(max) requirement (Table 1 ) at 0.5mA IOL.
Do not use devices that can drive the Standby control input
above 5Vdc.
4. When the regulator output is disabled the current drawn
from the input source is reduced to approximately 30–
40mA (50mA maximum).
Figure 1
Turn-On Time:
In the circuit of Figure 1, turning Q
1 on applies a
low voltage to the Standby control (pin 3) and disables the
regulator ouput. Correspondingly, turning Q
1 off releases the
low-voltage signal and enables the output. The PT6500 ISR
series regulators have a fast response and will provide a fully
regulated output voltage within 250
sec. The actual turn-on
time will vary with load and the total amount of output capaci-
tance. The waveform of Figure 2 shows the typical output
voltage response of a PT6501 (3.3V) following the turn-off of
Q
1 at time t = 0.0 secs. The waveform was measured with a
5Vdc input voltage, and 0.6
load.
Figure 2
C
in
+
C
out
+
Inhibit
V
in
V
o
COM
PT6500
11,12,13
14
7,8,9,10
4,5,6
Vin
V o
G N D
Vo(adj)
STBY
3
Vo(sense)
1
Q1
BSS138
+5V V
in
-50
0
50
100
150
200
250
300
350
t (
s )
Vo (2V / Div)
相關PDF資料 |
PDF描述 |
|---|---|
| PT6508F | 20 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, SMA14 |
| PT6502A | 20 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, SMA14 |
| PT6503B | 20 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, SMA14 |
| PT6502G | 20 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, SMA14 |
| PT6504Q | 20 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, PSMA14 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PT6508 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:8 AMP ADJUSTABLE ISR WITH SHORT-CIRCUIT PROTECTION |
| PT6508A | 功能描述:REG 1.7V 8A ADJ 14PSIP HORZ RoHS:是 類別:電源 - 板載 >> DC DC Converters 系列:PT6500 標準包裝:10 系列:PT4570 類型:隔離 輸出數:1 電壓 - 輸入（最?。?36V 電壓 - 輸入（最大）:75V Voltage - Output 1:9V Voltage - Output 2:- Voltage - Output 3:- 電流 - 輸出（最大）:3.3A 電源（瓦） - 制造商系列:30W 電壓 - 隔離:1.5kV（1500V） 特點:- 安裝類型:表面貼裝 封裝/外殼:19-SIP SMD 模塊 尺寸/尺寸:3.00" L x 1.19" W x 0.50" H（76.2mm x 30.2mm x 12.7mm） 包裝:托盤 工作溫度:-40°C ~ 85°C 效率:84% 電源（瓦特）- 最大:30W |
| PT6509/BMH | 制造商:Lorlin 功能描述:SWITCH 3POLE 3 POS 制造商:Lorlin 功能描述:SWITCH, 3POLE, 3 POS 制造商:Lorlin 功能描述:ROTARY SWITCH, 500mA, 250V; No. of Poles:3; No. of Switch Positions:3; Angle of Throw:30; Contact Current AC Max:500mA; Contact Current DC Max:500mA; Contact Voltage AC Max:250V; Contact Voltage DC Max:250V; Series:PT ;RoHS Compliant: Yes |
| PT6509/BMH | 制造商:Lorlin 功能描述:SWITCH 3 POLE 3 POS |
| PT6510 | 制造商:Lorlin 功能描述:SWITCH + 4P 2W |
發布緊急采購，3分鐘左右您將得到回復。