- 您現在的位置：買賣IC網 > PDF目錄368347 > PT6715N 20V Single N-Channel HEXFET Power MOSFET in a TO-262 package; A IRL3714L with Standard Packaging PDF資料下載
參數資料
| 型號： | PT6715N |
| 英文描述： | 20V Single N-Channel HEXFET Power MOSFET in a TO-262 package; A IRL3714L with Standard Packaging |
| 中文描述： | 開關電源控制器 |
| 文件頁數： | 4/8頁 |
| 文件大?。?/td> | 205K |
| 代理商： | PT6715N |
For technical support and more information, see inside back cover or visit www.ti.com
Application Notes
Using the On/Off Standby Function on the
PT6705/6715 Excalibur Series of ISRs
The PT6705 and PT6715 regulator series are non-
programmable (preset voltage) versions of the PT6701,
PT6702, and PT6703 products.
The PT6705/6715 series of products incorporate an on/
off ‘standby’ function, which may be used disable the
regulator output. The standby function is provided by
the
STBY*
control, pin 2. If pin 2 is left open-circuit the
regulator operates normally, and provides a regulated
output when a valid supply voltage is applied to V
in
(pins 4–6) with respect to GND (pins 8–12). If pin 2 is
connected to ground, the regulator output is disabled
and the input current drawn by the ISR typically drops
to its idle value
1
. The standby control may also be used
to hold-off the regulator output during the period that
input power is applied.
Pin 2 is ideally controlled with an open-collector (or
open-drain) discrete transistor (See Figure 1-1
2
). The
open-circuit voltage will be approximately 12.0V. Table 1-1
gives the circuit parameters for this control input.
Table 1-1 Standby Control Requirements
(3, 4)
Parameter
Enable (V
IH
)
Disable (V
IL
)
I
stby
(pin 2 =ground)
V
stby
(open circuit)
Min
—
–0.2V
Typ
Max
Open Circuit
0.4V
–0.5mA
12.0V
15.0V
Figure 1-1
Turn-On Time:
In the circuit of Figure 1-1, turning Q
1
on
applies a low voltage to pin 2 and disables the regulator
output. Correspondingly, turning Q
1
off removes the low-
voltage signal and enables the output
5
. Once enabled, the
output will typically experience a 10–15ms delay followed
by a predictable ramp-up of voltage. The regulator pro-
vides a fully regulated output within 40ms. The waveforms
of Figure 1-2 show the rise of both the output voltage
and input current for a PT6706 (2.5V). The turn off of
Q
1
corresponds to the rise of V
stby
. The waveform was
measured with a 5-Vdc input voltage and an 8-ADC load.
Figure 1-2
PT6705 & PT6715 Series
PT6705
Sns(+)
Sns(-)
7
V
OUT
GND
Vo(adj)
V
IN
Stby*
V
Bias
13–16
17
1
8–12
4,5,6
2
3
C
OUT
+
C
IN
+
STBY
+V
in
GND
GND
V
out
Q1
BSS138
+12V
(PT6705 Series Only)
Notes:
1. When the regulator output is disabled the current drawn
from the +V
in
input source is typically reduced to 25mA
for the PT671x series, and to less than 100μA for the
PT670x series.
2. Figure 1-1 is an application schematic for the PT670x
models. This shows the requirement for an external +12V
bias supply. The +12V bias is not required for the PT671x
models. For more details, consult the applicable product
data sheet.
3. The standby control input requires no external pull-up
resistor. The open-circuit voltage of the STBY* pin is
approximately 12.0V.
4. The standby control input is
Not
compatible with TTL
devices that incorporate a totem-pole output drive. Use
only a true open-collector device, preferably a discrete
bipolar transistor (or MOSFET). To ensure the regulator
output is disabled, the control pin must be pulled to less
than 0.4Vdc with a low-level 0.5mA sink to ground.
5 After Q
1
in Figure 1-1 is turned off and before the
output begins to rise, the regulator output will assert a low
impedance to ground. If an external voltage is applied to
the output it will sink current and possibly over-stress the
part.
/DIV
Vo (1V / DIV)
Iin (2A / DIV)
Vstby (10V / DIV)
相關PDF資料 |
PDF描述 |
|---|---|
| PT6716 | 30V Single N-Channel HEXFET Power MOSFET in a I-Pak package; Similar to IRLU7821 with Lead Free Packaging |
| PT6717 | 30V Single N-Channel HEXFET Power MOSFET in a D2-Pak package; A IRF3707ZCS with Standard Packaging |
| PT6718 | 1.5Vout 13 Amp 5V/3.3V-Input Adjustable ISR. CU Case |
| PT6719 | 1.2V 13A 5V/3.3V-Input Adjustable ISR |
| PT6724C | Analog IC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PT6716 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:2.5Vout 13 Amp 5V-Input Adjustable ISR. CU Case |
| PT6716A | 功能描述:開關變換器、穩壓器與控制器 2.5Vout 13A 5V-Inp CU Case Adj ISR RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
| PT6716C | 功能描述:REG 5V TO 2.5V 12A BIAS SMD RoHS:否 類別:電源 - 板載 >> DC DC Converters 系列:PT6710 標準包裝:10 系列:PT4570 類型:隔離 輸出數:1 電壓 - 輸入（最?。?36V 電壓 - 輸入（最大）:75V Voltage - Output 1:9V Voltage - Output 2:- Voltage - Output 3:- 電流 - 輸出（最大）:3.3A 電源（瓦） - 制造商系列:30W 電壓 - 隔離:1.5kV（1500V） 特點:- 安裝類型:表面貼裝 封裝/外殼:19-SIP SMD 模塊 尺寸/尺寸:3.00" L x 1.19" W x 0.50" H（76.2mm x 30.2mm x 12.7mm） 包裝:托盤 工作溫度:-40°C ~ 85°C 效率:84% 電源（瓦特）- 最大:30W |
| PT6716N | 功能描述:開關變換器、穩壓器與控制器 2.5Vout 13A 5V-Inp CU Case Adj ISR RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
| PT6717 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:1.8Vout 13 Amp 5V/3.3V-Input Adjustable ISR. CU Case |
發布緊急采購，3分鐘左右您將得到回復。