- 您現在的位置：買賣IC網 > PDF目錄69181 > PT6937C (TEXAS INSTRUMENTS INC) 10 A SWITCHING REGULATOR, 400 kHz SWITCHING FREQ-MAX, SMA23 PDF資料下載
參數資料
| 型號： | PT6937C |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 10 A SWITCHING REGULATOR, 400 kHz SWITCHING FREQ-MAX, SMA23 |
| 封裝： | SMD-23 |
| 文件頁數： | 14/14頁 |
| 文件大小： | 267K |
| 代理商： | PT6937C |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁
Application Notes
For technical support and more information, see inside back cover or visit www.ti.com
Adjusting the Output Voltage of the PT6935
Dual Output Voltage ISRs
Each output voltage from the PT6935 series of ISRs can be
independantly adjusted higher or lower than the factory
trimmed pre-set voltage. The voltages, Vo1 and Vo2 may
each be adjusted either up or down using a single external
resistor 1. Table 1 gives the adjustment range for both Vo1
and Vo2 for each model in the series as Va(min) and Va(max).
Note that Vo2 must always be lower than Vo1 2.
Vo1 Adjust Up:
To increase the output, add a resistor R4
between pin 16 (V1 Adjust) and pins 7-11 (GND) 1.
Vo1 Adjust Down: Add a resistor (R3), between pin 16
(Vo1 Adjust) and pin 1 (Vo1 Sense) 1.
Vo2 Adjust Up:
Add a resistor R2 between pin 23
(Vo2 Adjust) and pins 7-11 (GND) 1.
Vo2 Adjust Down: Add a resistor (R1) between pin 23
(Vo2 Adjust) and pin 22 (Vo2 Sense) 1.
Refer to Figure 1 and Table 2 for both the placement and value of
the required resistor.
Notes:
1. Use only a single 1% resistor in either the (R3) or R4
location to adjust Vo1, and in the (R1) or R2 location to
adjust Vo2. Place the resistor as close to the ISR as
possible.
2.Vo2 must always be at least 0.2V lower than Vo1.
3. Both the Vo1 and Vo2 may be adjusted down to an
alternative bus voltage by making, (R3) or (R1)
respectively, a zero ohm link. Refer to the Table 1
footnotes for guidance.
Figure 1
C
1
+
C
2
+
C
3
+
R4
(R3)
(R1)
R2
L
O
A
D
L
O
A
D
Adj Down
Adjust Up
V
IN
COM
Vo
2
Vo
1
PT6935
18 - 21
23
7 - 11
4,5,6
Vin
Vo
2
GND
Vo
2(adj)
Vo
1(sns)
1
16
Vo
1 (adj)
12 - 15
Vo
1
Vo
2(sns)
22
STBY
3
Adjust Vo
1
Adjust Vo
2
4. Adjusting the Vo1 output voltage of either the PT6935
(2.5V/1.8V model) or PT6939 (2.5V/1.2V) higher than
the factory pre-trimmed output voltage, may increase
the minimum input voltage specified for the part. These
models must comply with the following requirements.
PT6935/PT6939:
Vin(min) =(Va + 0.6)V or 3.1V,
whichever is greater.
5. Never connect capacitors to either the Vo1 Adjust or
Vo2 Adjust pins. Any capacitance added to these control
pins will affect the stability of the respective regulated
output.
6. Adjusting either voltage (Vo1 or Vo2) may increase the
power dissipation in the regulator, and change the
maximum current available at either output. Consult
the note on p.2 of the data sheet regarding Vo1/Vo2
loading.
The adjust up and adjust down resistor values can also be
calculated using the following formulas. Be sure to select
the correct formula parameter from Table 1 for the output
and model being adjusted.
(R1) or (R3)
=
10 (Va – Vr )
– Rs
k
Vo – Va
(R2) or (R4)
=
10 Vr
– Rs
k
Va – Vo
Where: Vo = Original output voltage, (Vo1 or Vo2)
Va = Adjusted output voltage
Vr = The reference voltage from Table 1
Rs = The series resistance from Table 1
PT6935 Series
相關PDF資料 |
PDF描述 |
|---|---|
| PT6937N | 10 A SWITCHING REGULATOR, 400 kHz SWITCHING FREQ-MAX, SMA23 |
| PT6938N | 8.6 A SWITCHING REGULATOR, 400 kHz SWITCHING FREQ-MAX, SMA23 |
| PT6935A | 9.5 A SWITCHING REGULATOR, 400 kHz SWITCHING FREQ-MAX, SMA23 |
| PT6937A | 10 A SWITCHING REGULATOR, 400 kHz SWITCHING FREQ-MAX, SMA23 |
| PT6943A | 6 A SWITCHING REGULATOR, 400 kHz SWITCHING FREQ-MAX, SMA27 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PT6937N | 功能描述:開關變換器、穩壓器與控制器 3.3V/1.8V 10Amp 5V-In Dual Otpt ISR RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
| PT6938 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:11-A 5V/3.3V-Input Dual Output Integrated Switching Regulator |
| PT6938A | 功能描述:REGULATOR 3.3/1.2V 5VIN HORZ RoHS:是 類別:電源 - 板載 >> DC DC Converters 系列:PT6930 設計資源:Maxi/Mini/Micro Design Guide, Appl Manual 標準包裝:1 系列:Maxi 類型:隔離 輸出數:1 電壓 - 輸入（最小）:43V 電壓 - 輸入（最大）:110V Voltage - Output 1:15V Voltage - Output 2:- Voltage - Output 3:- 電流 - 輸出（最大）:* 電源（瓦） - 制造商系列:400W 電壓 - 隔離:* 特點:* 安裝類型:通孔 封裝/外殼:模塊 尺寸/尺寸:4.60" L x 2.20" W x 0.54" H（116.8mm x 55.9mm x 13.7mm） 包裝:散裝 工作溫度:-55°C ~ 100°C 效率:* 電源（瓦特）- 最大:* |
| PT6938C | 功能描述:DC/DC轉換器 11A 5V/3.3V-Inp Dual Output Int Swtch Reg RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| PT6938N | 功能描述:DC/DC轉換器 11A 5V/3.3V-Inp Dual Output Int Swtch Reg RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
發布緊急采購，3分鐘左右您將得到回復。