參數資料
型號: PT9120
廠商: Princeton Technology Corporation
英文描述: GPS Receiver RF Front End IC
中文描述: GPS接收機射頻前端IC
文件頁數: 9/18頁
文件大?。?/td> 575K
代理商: PT9120
Tel: 886-2-66296288
Fax: 886-2-29174598
URL: http://www.princeton.com.tw
The RF application circuit shown in Typical PT9120 RF application circuit schematic has been
successfully interfaced with the PTC GPS base-band processor. Since the base-band processor
requires a 2-bit IF input, the PT9120’s SGN and MAG digital outputs are both fed to the base-band
processor. Note that the SGN and MAG output pins are only capable of driving a small load,
e.g.
a
typical digital input (2 to 4pF), and hence, they will drive neither a clock distribution tree nor a common
15pF oscilloscope probe. Overall performance degradation of the PT9120 caused by increased
switching noise leading to excessive power line interference may result from high capacitive loading.
This interference may be reduced by inserting series damping resistors (220 to 470
) at the interface
between the PT9120’s SGN and MAG outputs and the base-band processor inputs. As a rule of thumb,
PCB traces connected to the PT9120’s digital output pins should be kept short and routed away from
the external IF filter components.
CRYSTAL OSCILLATOR
The reference frequency for the PLL and the clock signal for the 2-bit A/D converter may be generated
by either the on-chip crystal oscillator, or supplied externally. An external reference clock signal (such
as the low amplitude signal from a typical TCXO as shown in the application circuit in Typical PT9120
RF application circuit schematic) should only be ac-coupled to the XO pin when the on-chip crystal
oscillator is enabled (XEN is set to TVDD) since the on-chip oscillator device will serve as a buffer for
the external signal. The external reference clock signal should have a minimum voltage swing of
400mV
P-P
.
The on-chip crystal oscillator uses a Pierce topology and requires external crystal resonator and shunt
load capacitances. The crystal oscillator is enabled by setting XEN to TVDD and disabled by setting
XEN to logic LOW. The XEN pin should never be left floating. For interfacing to the PTC base-band
processor, the crystal oscillator should be set to 16.368MHz.
SUPPORTED FREQUENCY PLANS
The PT9120 supports separate frequency plans for eight different reference frequencies. The selection
of the reference frequency is determined by logic input level at the MODE pin (which should be
hardwired to either AVDD or AVSS) and also the logic levels at the internal IC metal layer M1 and M2
pads. Supported frequency plans shows the relationship among the reference frequencies,
MODE/M1/M2 logic levels, 1st and 2nd IF and LO frequencies, and N-divider divide ratios.
Reference
Frequency (MHz)
Low
16.367
20.55
Low
Low
High
13.000 (GSM)
16.58
Low
19.800(CDMA)
24.42
19.200(CDMA)
23.25
High
Low
High
19.680 (CDMA)
15.55
Low
14.400(PDC)
18.18
High
High
High
12.600(PDC)
21.87
Low
16.367
20.55
Low
High
High
15.360(WCDMA)
18.94
PT9120 PRE1.0
- 9 -
August, 2007
GPS Receiver RF Front End IC
Preliminary
PT9120
M1
M2
Mode
1
st
IF (MHz)
2
nd
IF (MHz)
Lo Frequency
(MHz)
1554.86
1592
1599.84
1552.17
1590.97
1593.6
1597.29
1554.86
1556.48
N-driver
Divide Ratio
1520
1592
1616
1536
1536
1328
1648
1520
1520
4.188
3.58
4.62
4.051
4.127
3.78
3.328
4.188
3.58
相關PDF資料
PDF描述
PT9120-QF24 GPS Receiver RF Front End IC
PT9120-QF28 GPS Receiver RF Front End IC
PT9202 DVD Analog Front-End
PT9202-LQ DVD Analog Front-End
PT9202-LQL DVD Analog Front-End
相關代理商/技術參數
參數描述
PT9120_10 制造商:PTC 制造商全稱:Princeton Technology Corp 功能描述:GPS Receiver RF Front End IC
PT9120-24QF 制造商:PTC 制造商全稱:Princeton Technology Corp 功能描述:GPS Receiver RF Front End IC
PT9120-QF24 制造商:PTC 制造商全稱:Princeton Technology Corp 功能描述:GPS Receiver RF Front End IC
PT9120-QF28 制造商:PTC 制造商全稱:Princeton Technology Corp 功能描述:GPS Receiver RF Front End IC
PT9121B 制造商:EVERLIGHT 制造商全稱:Everlight Electronics Co., Ltd 功能描述:1.9mm Round Subminiature Axial Phototransistor