- 您現在的位置：買賣IC網 > PDF目錄69251 > PTB48511AAH (TEXAS INSTRUMENTS INC) 2-OUTPUT 65 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | PTB48511AAH |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 電源模塊 |
| 英文描述： | 2-OUTPUT 65 W DC-DC REG PWR SUPPLY MODULE |
| 封裝： | DIP-8 |
| 文件頁數： | 11/17頁 |
| 文件大?。?/td> | 544K |
| 代理商： | PTB48511AAH |
www.ti.com
ELECTRICAL CHARACTERISTICS
SLTS219F – FEBRUARY 2004 – REVISED MARCH 2007
(Unless otherwise stated, TA = 25°C, VI = 48 V, CI = 0 F, CO = 0 F, IO1 = IO2 = 3.25 A maximum)
PTB4851xA
PARAMETER
TEST CONDITIONS
MIN
TYP
MAX
UNIT
PO
Output Power
Total output power from VO1 or VO2
0
65 (1)
W
IO1, IO2
Output Current
Over VI range, IO1 ≤ 0.1 A or IO2 ≤ 0.1 A
0
6.5(2)
A
IO1 - IO2
Output Load Imbalance
IO1 ≤ 0.1 A or IO2 ≤ 0.1 A
0
1(3)
A
Includes set point, line, load, IO1 ≤ 0.1 A or IO2 ≤ 0.1 A
VO1, VO2
Output Voltage
4.75(2)
5
5.25(2)
V
–40
°C ≤ T
A ≤ 85°C
VO1
±1
–40
°C ≤ T
A ≤ 85°C, IO1 ≤ 0.1 A or IO2 ≤ 0.1
ΔRegtemp
Temperature Variation
%VO
A
VO2
±1
ΔRegline
Line Regulation
Over VI range, balanced load
VO1 or VO2
±0.1
±0.4
%VO
ΔRegload
Load Regulation
Over IO1, IO2range, balanced load
VO1 or VO2
±0.2
±0.4
%VO
η
Efficiency
86%
Vr
VO Ripple (pk-pk)
20 MHz bandwidth, CO = 10-F tantalum capacitor
20
30(4)
mVpp
ttr
0.11 A/
s load step, 50% to 75% I
O1 or IO2 maximum
30
s
Transient Response
ΔVtr
VO1 or VO2 overshoot/undershoot
±1.0
%VO
IOtrip
Overcurrent Threshold
VI = 36 V, reset followed by auto-recovery
6.8
7.5
10
A
PTB48510
NA
VO1(trip),
Overvoltage Threshold
Outputs latched off (5)
V
VO2(trip)
PTB48511
5.9
7
IO1(pk) IO2(pk)
12.5
A
Short Circuit Current
Continuous overcurrent trip, IO1 = IO2
Duty
10%
VO1(adj),
Output Voltage Adjust
VO1 or VO2 adjust simultaneously
3.5
5.5
V
VO2(adj)
Range
f S
Switching Frequency
Over VI and IO ranges
440
470(6)
500
kHz
VI on
VI increasing
33
Undervoltage lockout
V
VI off
VI decreasing
32
On/Off Enable (pin 3)
VIH
High-level input voltage
3.6
75(7)
Referenced to VI (pin 4)
V
VIL
Low-level input voltage
–0.2
0.8
IIL
Low-level input current
–1
mA
II standby
Standby Input Current
Pin 3 connected
2
mA
tON
Start-up Time
IO1 ≤ 0.1 A or IO2 ≤ 0.1 A, VO1 or VO2 rising 0 to 0.95 (typ)
6
10
22
ms
CI
Internal Input Capacitance
3
F
External Output
5000(8
CO
Capacitance from either output to COM (pin 6)
0
F
Capacitance
)
PTB48510A
2.7
Per Telcordia SR-332 50% stress,
MTBF
Reliability
106 hrs
TA = 40°C, ground benign
PTB48511A
2.5
(1)
See Safe Operating Area curves or contact the factory for the appropriate derating.
(2)
Under balanced load conditions, load current flowing out of VO1 is balanced to within ±0.1 A of that flowing into VO2.
(3)
A load imbalance is the difference in current flowing from VO1 to VO2. The module can operate with a higher imbalance but with reduced
specifications.
(4)
Output voltage ripple is measured with a 10-
F tantalum capacitor connected from V
O1 (pin 5) or VO2 (pin 8), to COM (pin 6).
(5)
If the overvoltage threshold is exceeded by either regulated output the module will shut down, turning both outputs off. This is a latched
condition, which can only by reset by removing and then re-applying the module's input power.
(6)
This is the free-running frequency. The module can be made to synchronize with the PTB48500 when both modules are used together
in a system.
(7)
The On/Off Enable (pin 3) has an internal pull-up and may be controlled with an open-collector (or open-drain) transistor. The input is
diode protected and may be connected to VI. The open-circuit voltage is 5 V maximum. If it is left open circuit the converter operates
when input power is applied.
(8)
Electrolytic capacitors with very low equivalent series resistance (ESR) may induce instability when used on the output. Consult the
factory before using capacitors with organic, or polymer-aluminum type electrolytes.
Copyright 2004–2007, Texas Instruments Incorporated
3
相關PDF資料 |
PDF描述 |
|---|---|
| PTB48510BAZ | 2-OUTPUT 72 W DC-DC REG PWR SUPPLY MODULE |
| PTB48510AAS | 2-OUTPUT 65 W DC-DC REG PWR SUPPLY MODULE |
| PTB48511AAS | 2-OUTPUT 65 W DC-DC REG PWR SUPPLY MODULE |
| PTB48511AAZ | 2-OUTPUT 65 W DC-DC REG PWR SUPPLY MODULE |
| PTB48511BAH | 2-OUTPUT 72 W DC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PTB48511AAS | 功能描述:DC/DC轉換器 65W+/- 5V Dual Comp Outp DC/DC Converter RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| PTB48511AAZ | 功能描述:直流/直流開關轉換器 65W+/- 5V Dual Comp Outp DC/DC Converter RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| PTB48511B | 制造商:TI 制造商全稱:Texas Instruments 功能描述:Dual Complementary-Output DC/DC Converter for DSL |
| PTB48511BAH | 功能描述:DC/DC轉換器 72W+/-12V Dual Comp Outp DC/DC Converter RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| PTB48511BAS | 功能描述:直流/直流開關轉換器 72W+/-12V Dual Comp Outp DC/DC Converter RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。