參數資料
型號： PTH04040WAH
廠商： TEXAS INSTRUMENTS INC
元件分類： 電源模塊
英文描述： 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
封裝： DIP-20
文件頁數： 9/25頁
文件大小： 535K
代理商： PTH04040WAH
t Time 20 ms/div
VTRK (1 V/div)
V01 (1 V/div)
V02 (1 V/div)
t Time 200
s/div
VTRK (1 V/div)
V01 (1 V/div)
V02 (1 V/div)
www.ti.com
SLTS238C – SEPTEMBER 2005 – REVISED JUNE 2010
Figure 15 shows the output voltage waveforms from the circuit of Figure 17 after input voltage is applied to the
circuit. The waveforms, VO1 and VO2, represent the output voltages from the two power modules, U1 (3.3 V) and
U2 (1.8 V), respectively. VTRK, VO1, and VO2 are shown rising together to produce the desired simultaneous
power-up characteristic.
The same circuit also provides a power-down sequence. When the input voltage falls below U3's voltage
threshold, the ground signal is re-applied to the common Track control. This pulls the Track inputs to zero volts,
forcing the output of each module to follow, as shown in Figure 16. In order for a simultaneous power-down to
occur, the Track inputs must be pulled low before the input voltage has fallen below the modules' undervoltage
lockout. This is an important constraint. Once the modules recognize that a valid input voltage is no longer
present, their outputs can no longer follow the voltage applied at their Track input. During a power-down
sequence, the fall in the output voltage from the modules is limited by the maximum output capacitance and the
Auto-Track slew rate.
NOTES ON USE OF Auto-Track
1. The Track pin voltage must be allowed to rise above the module’s set-point voltage before the module can
regulate at its adjusted set-point voltage.
2. The Auto-Track function tracks almost any voltage ramp during power up, and is compatible with ramp
speeds of up to 1 V/ms.
3. The absolute maximum voltage that may be applied to the Track pin is VI.
4. The module does not follow a voltage at its Track input until it has completed its soft-start initialization. This
takes at least 10 ms from the time that the module has sensed that a valid voltage is present. During this
period, the Track input should be held at ground potential.
5. The module is capable of both sinking and sourcing current when following a voltage at its Track input.
Therefore startup into an output prebias is not supported when the module is under Auto-Track control.
Prebias hold off is not necessary when all supply voltages simultaneously under the control of Auto-Track.
6. The Auto-Track function can be disabled by connecting the Track pin to the input voltage (VI). With
Auto-Track disabled, the output voltage rises at a quicker and more linear rate after input power is applied.
Figure 15. Auto-Track Simultaneous Power Up
Figure 16. Auto-Track Simultaneous Power Down
Waveforms
Copyright 2005–2010, Texas Instruments Incorporated
17
Product Folder Link(s): PTH04040W
相關PDF資料
PDF描述
PTH04070WAZ 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
PTH04T220WAS 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
PTH04T220WAZT 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
PTH04T221WAD 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
PTH04T220WAZ 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
相關代理商/技術參數
參數描述
PTH04040WAS 功能描述:DC/DC轉換器 60A 3.3/5V-In Wide Output Adj Pwr Mdl RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸:
PTH04040WAST 功能描述:DC/DC轉換器 2.95-5.5Vin 0.8-3.6V 60A RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸:
PTH04040WAZ 功能描述:DC/DC轉換器 60A 3.3/5V-In Wide Output Adj Pwr Mdl RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸:
PTH04040WAZT 功能描述:DC/DC轉換器 2.95-5.5Vin 0.8-3.6V 2.045" x1.045"x0.357 RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸:
PTH04070W 制造商:TI 制造商全稱:Texas Instruments 功能描述:3-A, 3.3/5-V INPUT ADJUSTABLE SWITCHING REGULATOR
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*