- 您現在的位置：買賣IC網 > PDF目錄368376 > PW-82520R0-830 Industrial Control IC PDF資料下載
參數資料
| 型號： | PW-82520R0-830 |
| 英文描述： | Industrial Control IC |
| 中文描述： | 工業控制IC |
| 文件頁數： | 8/16頁 |
| 文件大小： | 191K |
| 代理商： | PW-82520R0-830 |
8
Data Device Corporation
www.ddc-web.com
PW-82520/21N
A-11/01-1000
“
1
”
(or HIGH ) is defined by an input greater than 3.5Vdc or an
open circuit to the controller; Logic
“
0
”
(or LOW) is defined as any
Hall voltage input less than 1.5Vdc. Internal to the PW-
82520/21N are 10K pull-up resistors tied to +5Vdc on each Hall
input.
The PW-82520/21N will alternately operate with Hall phasing of
60
°
electrical spacing. If 60
°
commutation is used, then the out-
put of HC must be inverted as shown in FIGURES 4 and 5.
FIGURE 4 illustrates the Hall sensor outputs along with the cor-
responding back emf voltage they are in phase with.
HALL INPUT SIGNAL CONDITIONING
When the motor is located more than two feet away from the PW-
82520/21N controller or is in a noisy electrical environment the
Hall inputs require filtering from noise. It is recommended to use
a 1K
resistor in series with the Hall signal and a 2000 pF
capacitor from the Hall input pin to the Hall supply ground pin as
shown in FIGURES 6 and 7.
PHASE A, B, C
These are the power drive outputs to the motor and switch
between VBUS+ Input and VBUS- Input or become high imped-
ance (see TABLE 3).
VDR (+15V SUPPLY)
This input is used to power the gate driver circuitry for the output
MOSFETs. There is no power consumption from V
DR
when the
hybrid is disabled.
V
DD
(+5V TO +15V SUPPLY), V
EE
(-5V TO -15V SUPPLY)
These inputs can vary from ±5V to ±15V as long as they are
symmetrical. V
DD
and V
EE
are used to power the small signal
analog circuitry of the hybrid. Please note that using ±5V supply
will reduce the quiescent power consumption by approximately
60% when compared to ±15V operation.
SUPPLY GND
This pin is the return for the V
DR
, V
EE
, V
DD
supplies. The phase
current sensing technique of the PW-82520N/21N requires that
VBUS- and SUPPLY GND (see FIGURES 6 and 7) be connect-
ed together externally (see VBUS- supply).
CASE GND
This pin is internally connected to the hybrid case. In some applica-
tions the user may want to tie this to Ground for EMI considerations.
HALL A, B, C SIGNALS
These are logic signals from the motor Hall-effect sensors.They
use a phasing convention referred to as 120 degree spacing;that
is, the output of HA is in phase with motor back EMF voltage
VAB, HB is in phase VBC, and HC is in phase with VCA. Logic
HALL-EFFECT SENSOR PHASING vs.
MOTOR BACK EMF FOR CW ROTATION (120
°
Commutations)
300
°
0
°
60
°
120
°
180
°
V
AB
V
BC
ROTATING
CW
240
°
300
°
360
°
/0
°
60
°
V
CA
CW
HA
HB
HC
HC
with V
AB
with V
BC
with V
CA
with V
AC
(60)
FIGURE 4. HALL PHASING
S
HC
HA
120
°
N
HB
120
°
N
HC
120
°
REMOTE POSITION SENSOR (HALL) SPACING FOR
120 DEGREE COMMUTATION
60
°
60
°
REMOTE POSITION SENSOR (HALL) SPACING FOR
60 DEGREE COMMUTATION
S
HA
HB
HC
FIGURE 5. HALL SENSOR SPACING
相關PDF資料 |
PDF描述 |
|---|---|
| PW-82520R0-840 | Industrial Control IC |
| PW-82520R0-850 | Industrial Control IC |
| PW-82520R0-860 | Industrial Control IC |
| PW-82520R0-870 | Industrial Control IC |
| PW-82520R0-880 | Industrial Control IC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PW848USX | 制造商:Pyramid 功能描述:Rubber Surround 8 Ohm 175W Rms Woofer 8 Poly Coated Paper |
| PW855USX | 制造商:Pyramid 功能描述:Rubber Surround 4 Ohm 175W Rms Woofer 8 Poly Coated Paper 制造商:PYRAMID 功能描述:WOOFER 8 POLY COATED PAPER RUBBER SURROUND 4 OHM 175W RMS |
| PW856430 | 功能描述:罩類、盒類及殼類產品 33.3x25x11.8 RoHS:否 制造商:Bud Industries 產品:Boxes 外部深度:6.35 mm 外部寬度:6.35 mm 外部高度:2.56 mm NEMA 額定值: IP 等級: 材料:Acrylonitrile Butadiene Styrene (ABS) 顏色:Red |
| PW9125 OL 1KVA 700W | 制造商:Powerware 功能描述:_ |
| PW9125OL1KVA700W | 制造商:Powerware 功能描述:_ |
發布緊急采購，3分鐘左右您將得到回復。