參數資料
型號: Q67106-H6423
廠商: SIEMENS AG
英文描述: BiCMOS Low-Power Current Mode PWM Controller 8-SOIC -40 to 105
中文描述: 鎖相環頻率合成PMB2306R/PMB2306T版本2.2
文件頁數: 4/22頁
文件大?。?/td> 865K
代理商: Q67106-H6423
Semiconductor Group
4
SLB 0587
Functional Description
With the SLB 0587 it is possible to generate one defined current pulse per line half cycle.
Together with a triac and a few extra passive components, a line-powered phase-control circuit
can be designed. The phase-control angle (turn-ON time of the triac) can be set on the two
control inputs, pins 5 and 6, of the IC.
The voltage supply to the IC in a two-wire connection is ensured by limiting the angle of current
flow to approx. 152
°.
This makes it simple to exchange mechanical wall switches in conven-
tional lighting installations. The IC’s internal logic is synchronized with the line by PLL. Thus a
phase control range independent of the line frequency is obtained.
Operation with Low-Voltage Halogen Lamps
In normal, resistive operation of a phase control circuit there is alternately part of the positive
and negative line-voltage half cycle applied to the load via the triac that has started to conduct
because of the trigger pulse. Operation of the circuit with a transformer and low-voltage
halogen lamp connected is largely identical to the operation of a normal filament lamp due to
the primarily resistive nature of the load. In operation with resistive and inductive portions of
load, the zero crossing of the current compared to that of the line voltage line is delayed.
In operation with heavily inductive loads (eg an idling transformer after lamp failure), a highly
lossy state (half cycle operation) can occur after a fault, leading to thermal destruction of the
transformer. Control mechanisms integrated into the SLB 0587 serve to protect the load from
this situation.
If, for instance, a trigger pulse is missing in a half cycle because of a fault, there will be a con-
siderable increase in current in the transformer into the line shortly after the zero crossing of a
voltage wave – after the next firing of the triac at large phase-control angles. If the next trigger
pulse comes into phase when the triac is still conducting because of the inductive current lag,
it has no effect. It is only the subsequent trigger pulse that will fire the triac again.
The case described above, where only one trigger pulse per line cycle leads to firing of the
triac, can turn into a steady-state condition in the absence of further measures.
The SLB 0587 provides the following features to prevent Steady-State Half-Cycle
Operation:
1)
Allowance for the conducting state of the triac when setting the trigger pulses. If a
trigger pulse, determined by the set firing angle and status of the internal PLL, coin-
cides with the conducting phase of the triac, the trigger pulse will not be output to the
triac until after the zero crossing of the current wave.
2)
Detection of high saturation currents at angles of current flow of more than 180
°
by
sampling the synchronizing input levels.
If the frequency of such peak situation current exceeds a value defined in the IC,
there will be a safety cut-out.
相關PDF資料
PDF描述
Q67107-H5167-A703 DDC-PLUS-Deflection Controller
Q67120-C1056SAB-C501G-1EP IC-8-BIT CPU
Q67120-C508 IC-SM-8-BIT CPU 12-MHZ
Q67121C2168A1 IC-SM-16 BIT CPU
Q67121C452 IC-SM-8-BIT CPU-12MHZ
相關代理商/技術參數
參數描述
Q-67106-H6514 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:PLL-Frequency Synthesizer PMB2306R/PMB2306T Version 2.2
Q67107-H5167-A703 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:DDC-PLUS-Deflection Controller
Q67120-C0508 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit CMOS Single-Chip Microcontroller
Q67120-C0509 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit CMOS Single-Chip Microcontroller
Q67120-C0510 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit CMOS Single-Chip Microcontroller