
1
SCOPE
1.1
Scope. This specification establishes the detail requirements for hybrid, hermetically sealed, crystal
oscillators for use in space flight missions.
1.2
Part number. The part number shall be as specified in Table I herein.
2
APPLICABLE DOCUMENTS
2.1
Specifications and standards. Unless otherwise specified, the following documents shall be applicable to
this specification to the extent specified herein.
SPECIFICATIONS
401-0298-001
Hybrid Crystal Oscillators, Class S, General Specification For
3
REQUIREMENTS
3.1
General requirements. The individual item requirements shall be as specified in the General Specification
with the exceptions, modifications, and additions specified herein.
3.2
Approved manufacturer. Hybrid crystal oscillators shall be supplied from the manufacturer specified in
paragraph 7.1 herein.
3.3
Design and construction.
3.3.1.
Outline dimensions and terminal connections. The outline dimensions and terminal connections shall be
as shown in Figure 1 herein.
3.3.2.
Package body and lead finish. The package body and lead finish shall be gold in accordance with
MIL-PRF-38534.
3.3.3.
Active Devices. The microcircuit used in this part shall use CMOS technology and shall be from a wafer
proven to be radiation tolerant to 100 kRad (Si) total ionizing dose.
3.3.3.1
CMOS microcircuit usage.
For frequencies below 12 MHZ the output microcircuit shall be Intersil
Corporation 54ACS/HCS family, Silicon on Sapphire CMOS technology. For frequencies greater than or
equal to 12 MHZ, the CMOS microcircuit shall be 54AC00, see DSSC SMD 5962-87549. This
microcircuit is specified to be single event latchup free for LET up to 93 MeV-cm
2/mg. For output
frequencies from 12 MHZ to 100 MHZ, the manufacturer shall be ST Microelectronics Corporation; for
output frequencies greater than or equal to 100 MHZ, the manufacturer shall be National Semiconductor
Corporation.
3.4
Performance requirements.
3.4.1.
Maximum ratings. The maximum ratings shall be as specified in Table II herein.
3.4.2.
Electrical performance characteristics and limits. The electrical performance requirements and limits
shall be in accordance with Table III herein.
3.4.3.
Delta limits. Except for frequency aging (refer to Table III), delta limits shall be in accordance with the
General Specification.
3.4.4.
Total dose radiation limits. Hybrid crystal oscillators supplied in accordance with this specification shall
be capable of meeting the performance requirements after being exposed to 100 krad total dose radiation
levels.
4
QUALITY ASSURANCE PROVISIONS
Q-Tech Corporation
10150 W. Jefferson Blvd.
Culver City, CA. 90232
Specification number: QT725C rev -
Sheet 2 of 5