- 您現在的位置：買賣IC網 > PDF目錄296947 > R1127NC32V (WESTCODE SEMICONDUCTORS LTD) 2247 A, 3200 V, SCR PDF資料下載
參數資料
| 型號： | R1127NC32V |
| 廠商： | WESTCODE SEMICONDUCTORS LTD |
| 元件分類： | 晶閘管 |
| 英文描述： | 2247 A, 3200 V, SCR |
| 文件頁數： | 6/12頁 |
| 文件大小： | 680K |
| 代理商： | R1127NC32V |
WESTCODE
WESTCODE An IXYS Company
Distributed Gate Thyristor Types R1127NC32# to R1127NC36#
Data Sheet. Type R1127NC32# to R1127NC36# Issue 2
Page 3 of 12
February, 2003
Notes on Ratings and Characteristics
1.0 Voltage Grade Table
Voltage Grade
VDRM VDSM VRRM
V
VRSM
V
VD VR
DC V
32
3200
3300
1800
34
3400
3500
1850
36
3600
3700
1900
2.0 Extension of Voltage Grades
This report is applicable to other and higher voltage grades when supply has been agreed by
Sales/Production.
3.0 Extension of Turn-off Time
This Report is applicable to other tq/re-applied dv/dt combinations when supply has been agreed by
Sales/Production.
4.0 Repetitive dv/dt
Higher dv/dt selections are available up to 1000V/s on request.
5.0 De-rating Factor
A blocking voltage de-rating factor of 0.13%/°C is applicable to this device for Tj below 25°C.
6.0 Snubber Components
When selecting snubber components, care must be taken not to use excessively large values of snubber
capacitor or excessively small values of snubber resistor. Such excessive component values may lead to
device damage due to the large resultant values of snubber discharge current. If required, please consult
the factory for assistance.
7.0 Rate of rise of on-state current
The maximum un-primed rate of rise of on-state current must not exceed 1500A/s at any time during
turn-on on a non-repetitive basis. For repetitive performance, the on-state rate of rise of current must not
exceed 1000A/s at any time during turn-on. Note that these values of rate of rise of current apply to the
total device current including that from any local snubber network.
8.0 Gate Drive
The nominal requirement for a typical gate drive is illustrated below. An open circuit voltage of at least 30V
is assumed. This gate drive must be applied when using the full di/dt capability of the device.
IGM
IG
tp1
4A/s
The magnitude of IGM should be between five and ten times IGT, which is shown on page 2. Its duration
(tp1) should be 20s or sufficient to allow the anode current to reach ten times IL, whichever is greater.
Otherwise, an increase in pulse current could be needed to supply the necessary charge to trigger. The
‘back-porch’ current IG should remain flowing for the same duration as the anode current and have a
magnitude in the order of 1.5 times IGT.
相關PDF資料 |
PDF描述 |
|---|---|
| R1127NC36V | 2247 A, 3600 V, SCR |
| R1127NC34V | 2247 A, 3400 V, SCR |
| R1127NC34T | 2247 A, 3400 V, SCR |
| R1127NC34S | 2247 A, 3400 V, SCR |
| R114.664.100 | BOARD TERMINATED, FEMALE, SMB CONNECTOR, SURFACE MOUNT, RECEPTACLE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| R1128 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Optoelectronic |
| R11-2-8.00A-38798-3-V | 制造商:Airpax 功能描述:CIRCUIT BREAKER MAG-HYDR ROCKER 制造商:Sensata Technologies 功能描述:R11-2-8.00A-38798-3-V /Pole # 1 /Prod Family: 0213 |
| R11-2-8.00A-B01IV-V | 制造商:Sensata Technologies 功能描述:Circuit Breaker Magnetic Circuit Protectors 1Pole 8A |
| R11-2-8.00A-B06IV-V | 制造商:Sensata Technologies 功能描述:1 Pole |
| R11-2-8.00A-B102IV-V | 制造商:Sensata Technologies 功能描述:Circuit Breaker Magnetic Circuit Protectors 1Pole 8A |
發布緊急采購，3分鐘左右您將得到回復。