- 您現在的位置：買賣IC網 > PDF目錄385768 > RF2422PCBA (RF Micro Devices, Inc.) 2.5GHZ DIRECT QUADRATURE MODULATOR PDF資料下載
參數資料
| 型號： | RF2422PCBA |
| 廠商： | RF Micro Devices, Inc. |
| 英文描述： | 2.5GHZ DIRECT QUADRATURE MODULATOR |
| 中文描述： | 2.5GHz的直接正交調制器 |
| 文件頁數： | 3/6頁 |
| 文件大?。?/td> | 68K |
| 代理商： | RF2422PCBA |
5-31
RF2422
Rev A5 010817
5
M
U
Pin
1
Function
I REF
Description
Reference voltage for the I mixer. This voltage should be the same as
the DC voltage supplied to the I SIG pin. A voltage of 3.0V is recom-
mended. The SIG and REF inputs are inputs of a differential amplifier.
Therefore the REF and SIG inputs are interchangeable. If swapping the
I SIG and I REF pins, the Q SIG and Q REF also need to be swapped
to maintain the correct phase. It is also possible to drive the SIG and
REF inputs in a balanced mode. This will increase the gain.
Interface Schematic
2
Q REF
Reference voltage for the Q mixer. This voltage should be the same as
the DC voltage supplied to the Q SIG pin. A voltage of 3.0V is recom-
mended.
3
GND2
Ground connection of the LO phase shift network. This pin should be
connected directly to the ground plane.
Same as pin 3.
4
5
6
GND2
GND2
LO
Same as pin 3.
The input of the phase shifting network. This pin has an internal DC-
blocking capacitor. At frequencies higher than 2GHz this port is well-
matched to 50
. This port is voltage driven so matching at lower fre-
quencies is not required.
Power supply for all circuits except the RF output stage. An external
capacitor is needed if no other low frequency bypass capacitor is
nearby.
Power Down control. When this pin is "low", all circuits are shut off. A
"low" is typically 1.2V or less at room temperature.When this pin is
"high" (V
CC
), all circuits are operating normally. If PD is below V
CC
, out-
put power and performance will be degraded. Operating in this region
is not recommended, although it might be useful in some applications
where power control is required.
This is the 50
RF Output. This pin has an internal DC-blocking capac-
itor. At frequencies higher than 2GHz this port is well-matched. Typical
impedances at lower frequencies are: 24-j30
@ 1GHz, 27-j10
@
1.4GHz, 31-j3
@ 1.8GHz. At those frequencies, external matching
may be needed to optimize output power.
7
VCC1
8
PD
9
RF OUT
10
GND3
Ground connection for the RF output stage. This pin should be con-
nected directly to the ground plane.
Power supply for the RF Output amplifier. An external capacitor is
needed if no other low frequency bypass capacitor is near by.
Ground connection for the LO and baseband amplifiers, and for the
mixers. This pin should be connected directly to the ground plane.
Same as pin 12.
11
VCC2
12
GND1
13
14
15
GND1
GND1
Q SIG
Same as pin 12.
Baseband input to the Q mixer. This pin is DC-coupled. Maximum out-
put power is obtained when the input signal has a peak to peak ampli-
tude of 2V. The recommended DC level for this pin is 3.0V. The peak
minimum voltage on this pin (V
REF
- peak modulation amplitude)
should never drop below 2.0V. The peak maximum voltage on this pin
(V
REF
+ peak modulation amplitude) should never exceed 4.0V.
See pin 2.
425
425
100
100
Q REF
Q SIG
425
425
100
100
Q REF
Q SIG
LO
200
PD
V
CC
RF OUT
相關PDF資料 |
PDF描述 |
|---|---|
| RF2423 | 100mW SPREAD-SPECTRUM TRANSMITTER IC |
| RF2424 | UHF QUADRATURE MODULATOR |
| RF2425 | 4-PORT TRANSFER SWITCH |
| RF2436 | TRANSMIT/RECEIVE SWITCH |
| RF2442 | HIGH-LINEARITY LOW NOISE AMPLIFIER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| RF2422PCBA-41X | 制造商:RFMD 制造商全稱:RF Micro Devices 功能描述:2.5GHZ DIRECT QUADRATURE MODULATOR |
| RF2422TR7 | 制造商:RF Micro Devices Inc 功能描述:IC DIRECT QUAD MODULATOR 16-SOIC |
| RF2423 | 制造商:RFMD 制造商全稱:RF Micro Devices 功能描述:100mW SPREAD-SPECTRUM TRANSMITTER IC |
| RF2423-000 | 功能描述:可復位保險絲 RoHS:否 制造商:Bourns 電流額定值: 電阻:7.5 Ohms 最大直流電壓: 保持電流:0.1 A 安裝風格:SMD/SMT 端接類型:SMD/SMT 跳閘電流:0.6 A 引線間隔: 系列:MF-PSHT 工作溫度范圍:- 40 C to + 125 C |
| RF2424 | 制造商:RFMD 制造商全稱:RF Micro Devices 功能描述:UHF QUADRATURE MODULATOR |
發布緊急采購，3分鐘左右您將得到回復。