參數資料
型號: RF2713
廠商: RF MICRO DEVICES INC
元件分類: 衰減器
英文描述: 887667300
中文描述: 0.1 MHz - 265 MHz RF/MICROWAVE QUADRAPHASE MODEM
封裝: ROHS COMPLIANT, SOIC-14
文件頁數: 7/12頁
文件大?。?/td> 135K
代理商: RF2713
Preliminary
7-23
RF2713
Rev A2 010129
5
M
U
Pin
7
8
Function
Q IF OUT
Q OUT
Description (Modulator Configuration)
Same as pin 6, except complementary input.
Interface Schematic
Same as pin 6.
Pins 8 and 9 are not used in a normal quadrature modulator applica-
tion, and are left unconnected. Note, however, that the outputs of each
of these pins are independent upconverted I and Q channels. These
signals may be useful in other applications where independent IF chan-
nels are needed. Also note that these outputs are optimized as base-
band outputs for the demodulator configuration. As a result, the gain
rolls-off quickly with increasing frequency. This gain roll-off will limit the
usefulness of these pins as independent I and Q upconverters. If these
outputs are to be used, please refer to the Demodulator pin descrip-
tions regarding load impedances.
Same as pin 8, except Q Mixer’s Output.
9
I OUT
GND
Same as pin 8.
10
Ground connection. Keep traces physically short and connect immedi-
ately to ground plane for best performance.
Same as pin 10.
11
12
13
GND
GND
Same as pin 10.
LO INPUT
High impedance, single-ended modulator LO input. The LO applied to
this pin is frequency divided by a factor of 2 and becomes the "Carrier".
For modulation, the Carrier is the center of the modulated output spec-
trum (except in the case of SSB/SC). The input impedance is deter-
mined by an internal 500
bias resistor to V
CC
. An external blocking
capacitor should be provided if the pin is connected to a device with DC
present. Matching the input impedance is typically achieved by adding
a 51
resistor to ground on the source side of the AC coupling capaci-
tor. For the LO input, maximum power transfer is not critical. The inter-
nal LO switching circuits are controlled by the voltage, not power, into
the part. In cases where the LO source does not have enough available
voltage, a reactive match (voltage transformer) can be used. The LO
circuitry consists of a limiting amplifier followed by a digital divider. The
limiting amp ensures that the flip-flop type divider is driven with a
square wave over a wide range of input levels. Because the flip-flop
uses the rising and falling edges of the limiter output, the quadrature
accuracy of the Carrier supplied to the mixers is directly related to the
duty cycle, or equivalently to the even harmonic content, of the input LO
signal. In particular, care should be taken to ensure that the 2xLO level
input to this pin is at least 20dB below the LO level. Otherwise, the LO
input is not sensitive to the type of input wave form, except for IF fre-
quencies below ~2.5MHz, in which case the LO input should be a
square wave, in order to ensure proper triggering of the flip-flops. IF fre-
quencies below 100kHz are attainable if the LO is a square wave and
sufficiently large DC blocking capacitors are used.
Voltage supply for the entire device. This pin should be well bypassed
at all frequencies (IF, LO, Carrier, Baseband) that are present in the
part.
14
VCC
I/Q OUT
2 k
V
CC
500
500
LO IN
V
CC
V
CC
相關PDF資料
PDF描述
RF2721 QUADRATURE DEMODULATOR
RF2909 3V 915MHZ SPREAD-SPECTRUM TRANSMITTER IC
RF2915 433/868/915MHZ FSK/ASK/OOK TRANSCEIVER
RF2917 433/868/915MHZ FM/FSK RECEIVER
RF2919 433/868/915MHZ ASK/OOK RECEIVER
相關代理商/技術參數
參數描述
RF2713_06 制造商:RFMD 制造商全稱:RF Micro Devices 功能描述:QUADRATURE MODULATOR/DEMODULATOR
RF2713_1 制造商:RFMD 制造商全稱:RF Micro Devices 功能描述:QUADRATURE MODULATOR/DEMODULATOR
RF2713-000 制造商:TE Connectivity 功能描述:TOOLING,RESETTABLE FUSE - Bag
RF2713PCBA-D 制造商:RFMD 制造商全稱:RF Micro Devices 功能描述:QUADRATURE MODULATOR/DEMODULATOR
RF2713PCBA-M 制造商:RFMD 制造商全稱:RF Micro Devices 功能描述:QUADRATURE MODULATOR/DEMODULATOR