- 您現在的位置：買賣IC網 > PDF目錄385769 > RF2915 (RF MICRO DEVICES INC) 433/868/915MHZ FSK/ASK/OOK TRANSCEIVER PDF資料下載
參數資料
| 型號： | RF2915 |
| 廠商： | RF MICRO DEVICES INC |
| 元件分類： | 通信及網絡 |
| 英文描述： | 433/868/915MHZ FSK/ASK/OOK TRANSCEIVER |
| 中文描述： | SPECIALTY TELECOM CIRCUIT, PQFP32 |
| 封裝： | 5 X 5 MM, PLASTIC, LQFP-32 |
| 文件頁數： | 6/18頁 |
| 文件大?。?/td> | 386K |
| 代理商： | RF2915 |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁
11-116
RF2915
Rev A7 001011
11
T
Pin
14
Function
IF1 BP+
Description
DC feedback node for the 40dB limiting amplifier strip. A 10nF bypass
capacitor from this pin to ground is required.
Same as pin 14.
Interface Schematic
See pin 13.
15
IF1 BP-
See pin 13.
16
IF1 OUT
IF output from the 40dB limiting amplifier. The IF1 OUT output presents
a nominal 330
output resistance and interfaces directly to 10.7MHz
ceramic filters.
17
IF2 IN
IF input to the 60dB limiting amplifier strip. A 10nF DC blocking capaci-
tor is required on this input. The IF2 IN input presents a nominal 330
input resistance and interfaces directly to 10.7MHz ceramic filters.
18
IF2 BP+
DC feedback node for the 60dB limiting amplifier strip. A 10nF bypass
capacitor from this pin to ground is required.
Same as pin 18.
See pin 17.
19
20
IF2 BP-
GND6
See pin 17.
Ground connection for 60dB IF limiting amplifier. Keep traces physically
short and connect immediately to ground plane for best performance.
This pin is the input to the FM demodulator. This pin is NOT AC-cou-
pled. Therefore, a DC blocking capacitor is required on this pin to avoid
shorting the demodulator input with the LC tank. A ceramic discrimina-
tor or DC blocked LC tank resonant at the IF should be connected to
this pin.
21
DEMOD IN
22
IF2 OUT
IF output from the 60dB limiting amplifier strip. This pin is intended to
be connected to pin 21 through a 5pF capacitor and an FM discrimina-
tor circuit.
23
MOD IN
FM analog or digital modulation can be imparted to the VCO through
this pin. The VCO varies in accordance to the voltage level presented
to this pin. To set the deviation to a desired level, a voltage divider refer-
enced to VCC is the recommended. This deviation is also dependent
upon the overall capacitance of the external resonant circuit.
This port is used to supply DC voltage to the VCO as well as to tune the
center frequency of the VCO. Equal value inductors should be con-
nected to this pin and pin 25 although a small imbalance can be used
to tune in the proper frequency range.
See pin 24.
24
RESNTR+
25
26
RESNTR-
VCO OUT
See RESNTR+ description.
See pin 24.
This pin is used is supply a buffered VCO output to go to the PLL chip.
This pin has a DC bias and needs to be AC-coupled.
27
GND4
GND4 is the ground shared on chip by the VCO, prescaler, and PLL
electronics.
IF1 OUT
IF2 IN
330
330
60 k
60 k
IF2 BP+
IF2 BP-
DEMOD IN
10 k
V
CC
IF2 OUT
RESNTR-
RESNTR+
4 k
MOD IN
VCO OUT
相關PDF資料 |
PDF描述 |
|---|---|
| RF2917 | 433/868/915MHZ FM/FSK RECEIVER |
| RF2919 | 433/868/915MHZ ASK/OOK RECEIVER |
| RF2926 | UHF DUAL CONVERSION TRANSCEIVER |
| RF2938 | 2.4GHZ SPREAD-SPECTRUM TRANSCEIVER |
| RF2942 | UHF QUADRATURE MODULATOR AND TRANSMITTER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| RF2917 | 制造商:RFMD 制造商全稱:RF Micro Devices 功能描述:433/868/915MHZ FM/FSK RECEIVER |
| RF2919 | 制造商:RFMD 制造商全稱:RF Micro Devices 功能描述:433/868/915MHZ ASK/OOK RECEIVER |
| RF2926 | 制造商:RFMD 制造商全稱:RF Micro Devices 功能描述:UHF DUAL CONVERSION TRANSCEIVER |
| RF2926-000 | 制造商:TE Connectivity 功能描述:FEMTOSMDC005F-2 - Tape and Reel |
| RF2926PCBA | 制造商:RFMD 制造商全稱:RF Micro Devices 功能描述:UHF DUAL CONVERSION TRANSCEIVER |
發布緊急采購，3分鐘左右您將得到回復。