- 您現在的位置：買賣IC網 > PDF目錄385776 > RT9188-K8PB (Richtek Technology Corporation) Dual, Ultra-Low Quiescent, 100mA CMOS LDO Regulator PDF資料下載
參數資料
| 型號： | RT9188-K8PB |
| 廠商： | Richtek Technology Corporation |
| 英文描述： | Dual, Ultra-Low Quiescent, 100mA CMOS LDO Regulator |
| 中文描述： | 雙路，超低靜態，100mA的LDO穩壓器的CMOS |
| 文件頁數： | 8/10頁 |
| 文件大?。?/td> | 168K |
| 代理商： | RT9188-K8PB |
RT9188
Preliminary
8
DS9188-08 March 2007
www.richtek.com
Aluminum electrolytics also typically have large
temperature variation of capacitance value.
Equally important to consider is a capacitor's ESR change
with temperature: this is not an issue with ceramics, as
their ESR is extremely low. However, it is very important
in Tantalum and aluminum electrolytic capacitors. Both
show increasing ESR at colder temperatures, but the
increase in aluminum electrolytic capacitors is so severe
they may not be feasible for some applications.
Ceramic:
For values of capacitance in the 10
μ
F to 100
μ
F range,
ceramics are usually larger and more costly than
tantalums but give superior AC performance for by-
passing high frequency noise because of very low ESR
(typically less than 10m
). However, some dielectric
types do not have good capacitance characteristics as a
function of voltage and temperature.
Z5U and Y5V dielectric ceramics have capacitance that
drops severely with applied voltage. A typical Z5U or Y5V
capacitor can lose 60% of its rated capacitance with half
of the rated voltage applied to it. The Z5U and Y5V also
exhibit a severe temperature effect, losing more than 50%
of nominal capacitance at high and low limits of the
temperature range.
X7R and X5R dielectric ceramic capacitors are strongly
recommended if ceramics are used, as they typically
maintain a capacitance range within
±
20% of nominal
over full operating ratings of temperature and voltage.
Of course, they are typically larger and more costly than
Z5U/Y5U types for a given voltage and capacitance.
Tantalum:
Solid tantalum capacitors are recommended for use on
the output because their typical ESR is very close to the
ideal value required for loop compensation. They also
work well as input capacitors if selected to meet the ESR
requirements previously listed.
Tantalums also have good temperature stability: a good
quality tantalum will typically show a capacitance value
that varies less than 10~15% across the full temperature
range of 125
°
C to -40
°
C. ESR will vary only about 2X
going from the high to low temperature limits.
The increasing ESR at lower temperatures can cause
oscillations when marginal quality capacitors are used
(if the ESR of the capacitor is near the upper limit of the
stability range at room temperature).
Aluminum:
This capacitor type offers the most capacitance for the
money. The disadvantages are that they are larger in
physical size, not widely available in surface mount, and
have poor AC performance (especially at higher
frequencies) due to higher ESR and ESL.
Compared by size, the ESR of an aluminum electrolytic
is higher than either Tantalum or ceramic, and it also
varies greatly with temperature. A typical aluminum
electrolytic can exhibit an ESR increase of as much as
50X when going from 25
°
C down to -40
°
C.
It should also be noted that many aluminum electrolytics
only specify impedance at a frequency of 120Hz, which
indicates they have poor high frequency performance.
Only aluminum electrolytics that have an impedance
specified at a higher frequency (between 20kHz and
100kHz) should be used for the device. Derating must
be applied to the manufacturer's ESR specification, since
it is typically only valid at room temperature.
Any applications using aluminum electrolytics should be
thoroughly tested at the lowest ambient operating
temperature where ESR is maximum.
相關PDF資料 |
PDF描述 |
|---|---|
| RT9193-15PB | 300mA, Ultra-Low Noise, Ultra-Fast CMOS LDO Regulator |
| RT9193 | 300mA, Ultra-Low Noise, Ultra-Fast CMOS LDO Regulator |
| RT9193-15GB | 300mA, Ultra-Low Noise, Ultra-Fast CMOS LDO Regulator |
| RT9193-15GQW | 300mA, Ultra-Low Noise, Ultra-Fast CMOS LDO Regulator |
| RT9193-15GU5 | 300mA, Ultra-Low Noise, Ultra-Fast CMOS LDO Regulator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| RT9193-15GB | 功能描述:IC REG LDO 1.5V .3A SOT23-5 RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:3,000 系列:- 穩壓器拓撲結構:正，固定式 輸出電壓:2.5V 輸入電壓:2.5 V ~ 5.5 V 電壓 - 壓降（標準）:- 穩壓器數量:1 電流 - 輸出:300mA（最小值） 電流 - 限制（最?。?360mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 供應商設備封裝:TSOT-23-5 包裝:帶卷 (TR) |
| RT9193-15GU5 | 功能描述:IC REG LDO 1.5V .3A SC70-5 RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:3,000 系列:- 穩壓器拓撲結構:正，固定式 輸出電壓:2.5V 輸入電壓:2.5 V ~ 5.5 V 電壓 - 壓降（標準）:- 穩壓器數量:1 電流 - 輸出:300mA（最小值） 電流 - 限制（最?。?360mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 供應商設備封裝:TSOT-23-5 包裝:帶卷 (TR) |
| RT9193-15PB | 制造商:Richtek Technology Corporation 功能描述: |
| RT9193-16GB | 功能描述:IC REG LDO 1.6V .3A SOT23-5 RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:3,000 系列:- 穩壓器拓撲結構:正，固定式 輸出電壓:2.5V 輸入電壓:2.5 V ~ 5.5 V 電壓 - 壓降（標準）:- 穩壓器數量:1 電流 - 輸出:300mA（最小值） 電流 - 限制（最小）:360mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 供應商設備封裝:TSOT-23-5 包裝:帶卷 (TR) |
| RT9193-18GB | 功能描述:IC REG LDO 1.8V .3A SOT23-5 RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 其它有關文件:LM317M View All Specifications 標準包裝:1 系列:- 穩壓器拓撲結構:正，可調式 輸出電壓:1.2 V ~ 37 V 輸入電壓:- 電壓 - 壓降（標準）:- 穩壓器數量:1 電流 - 輸出:500mA 電流 - 限制（最?。?500mA 工作溫度:0°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:TO-252-3，DPak（2 引線+接片），SC-63 供應商設備封裝:D-Pak 包裝:剪切帶 (CT) 產品目錄頁面:1190 (CN2011-ZH PDF) 其它名稱:497-1574-1 |
發布緊急采購，3分鐘左右您將得到回復。