- 您現在的位置：買賣IC網 > PDF目錄372099 > SA2411DH (NXP SEMICONDUCTORS) +20 dBm single chip linear amplifier for WLAN PDF資料下載
參數資料
| 型號： | SA2411DH |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 衰減器 |
| 英文描述： | +20 dBm single chip linear amplifier for WLAN |
| 中文描述： | 2400 MHz - 2500 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER |
| 封裝： | PLASTIC, TSSOP-16, SOT-403-1 |
| 文件頁數： | 6/17頁 |
| 文件大?。?/td> | 117K |
| 代理商： | SA2411DH |
Philips Semiconductors
Product data
SA2411
+20 dBm single chip linear amplifier for WLAN
2003 Feb 07
6
8. OPERATION
The SA2411 linear amplifier is intended for operation in the 2.4 GHz band, specifically for IEEE 802.11 1 and 2 Mbits/s DSSS, and 5.5 and 11
Msymbols/s CCK standards. Throughout this document, the operating RF frequency refers to the ISM band between 2.4 and 2.5 GHz.
Amplifier Output Power
The SA2411 linear amplifier is designed to give at least 19 dBm output power for an 11 Msymbols/s CCK modulated input carrier. At 19 dBm
output power the ACPR specs are met. The fixed gain amplifier amplifies the input signal by 14.5 dB typically.
Power Mode
The biasing can be adjusted to change the gain and therefore the maximum linear output power. For high supply voltages (>3.2 V) the low-gain
mode is advised. For low supply voltages (<3.3 V) the high-gain mode is advised.
Power Mode
Pin 9 =
Typical output power
Typical small
signal Gain
Typical DC current
(no RF signal)
Typical Current
consumption
High
Floating
20.0 dBm
14.5 dB
35 mA
185 mA @ 20 dBm
Low
Grounded
20.0 dBm
13 dB
28 mA
185 mA @ 20 dBm
Power detector
The power detector current output is linear proportional with the RF output voltage. The RF output power is quadratic proportional to the RF
output voltage. Therefore, the detector is quadratic proportional to the output power. The following relation can be expressed:
P
out
k
V
n
detector
P
out
is output power in mWatt, V
detector
is detector voltage in Volt, k = sensitivity in mWatt/V
2
, n = quadratic factor.
The quadratic factor is 1.5. The sensitivity is then 49 mWatt/V
2
.
P
out
20 dBm = 100 mW
V
detector
(5.6 k
load)
1.7 V
I
detector
(5.6 k
in series)
300 uA
19 dBm = 79 mW
1.4 V
250 uA
17 dBm = 50 mW
1.0 V
175 uA
15 dBm = 32 mW
0.7 V
125 uA
9 dBm = 8 mW
0.3 V
50 uA
The loading of the detector can be different in the application. The highest accuracy is achieved with 5.6 k
. But other values can be used to
adapt to the maximum input sensitivity of other circuits. Other detector loading values result in other k-factors. The maximum detector voltage is
limited to about 2.4 V.
DC feed at input
There is a possibility to add a DC voltage at the input pins (pin 4 and pin 5) by feeding pin 2. This option should be used in case the SA2411 is
lined up with the SA2400A.
相關PDF資料 |
PDF描述 |
|---|---|
| SA2420DH | Low voltage RF transceiver . 2.45GHz |
| SA2420 | Low voltage RF transceiver . 2.45GHz |
| SA2421 | 2.45 GHz low voltage RF transceiver |
| SA2421DH | CABLE ASSEMBLY; BNC MALE TO UHF MALE; 50 OHM, PE-B4199, LOW LOSS COAX; 12" CABLE LENGTH |
| SA305E105MA4001 | KONDENSATOR AXIAL 1UF 63/50V |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SA24-120-16-WB | 功能描述:ANT VPOL SECT 16DBI 2.3-2.7G NF RoHS:是 類別:RF/IF 和 RFID >> RF 天線 系列:* 標準包裝:1 系列:* |
| SA24-120-9 | 功能描述:ANT VPOL SECTOR 9DBI 2.4G N FEM RoHS:是 類別:RF/IF 和 RFID >> RF 天線 系列:* 標準包裝:1 系列:* |
| SA24-180-14 | 功能描述:ANT VPOL SECTOR 14DBI 2.4G N FEM RoHS:是 類別:RF/IF 和 RFID >> RF 天線 系列:* 標準包裝:1 系列:* |
| SA2420 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low voltage RF transceiver . 2.45GHz |
| SA2420DH | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low voltage RF transceiver . 2.45GHz |
發布緊急采購，3分鐘左右您將得到回復。