- 您現在的位置：買賣IC網 > PDF目錄376335 > SAB80C537-M16 (SIEMENS A G) 8-Bit CMOS Single-Chip Microcontroller PDF資料下載
參數資料
| 型號： | SAB80C537-M16 |
| 廠商： | SIEMENS A G |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-Bit CMOS Single-Chip Microcontroller |
| 中文描述： | 8-BIT, 16 MHz, MICROCONTROLLER, PQFP100 |
| 封裝： | PLASTIC, MQFP-100 |
| 文件頁數： | 34/56頁 |
| 文件大?。?/td> | 668K |
| 代理商： | SAB80C537-M16 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁當前第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁
SAB 80C515/80C535
Semiconductor Group
33
When idle mode is used, pin PE must be held on low level. The idle mode is then entered by
two consecutive instructions. The first instruction sets the flag bit IDLE (PCON.0) and must not
set bit IDLS (PCON.5), the following instruction sets the start bit IDLS (PCON.5) and must not
set bit IDLE (PCON.0). The hardware ensures that a concurrent setting of both bits, IDLE and
IDLS, does not initiate the idle mode. Bits IDLE and IDLS will automatically be cleared after
being set. If one of these register bits is read the value that appears is 0 (see table 4). This
double instruction is implemented to minimize the chance of an unintentional entering of the
idle mode which would leave the watchdog timer’s task of system protection without effect.
Note that PCON is not a bit-addressable register, so the above mentioned sequence for
entering the idle mode is obtained by byte-handling instructions, as shown in the following
example:
ORL
PCON,#00000001
B
;Set bit IDLE, bit IDLS must not be set
ORL
PCON,#00100000
B
The instruction that sets bit IDLS is the last instruction executed before going into idle mode.
There are two ways to terminate the idle mode:
– The idle mode can be terminated by activating any enable interrupt. This interrupt will
be serviced and normally the instruction to be executed following the RETI instruction
will be the one following the instruction that sets the bit IDLS.
;
Set bit IDLS, bit IDLE must not be set
– The other way to terminate the idle mode, is a hardware reset. Since the oscillator
is still running, the hardware reset must be held active only for two machine cycles
for a complete reset.
Power-Down Mode
In the power-down mode, the on-chip oscillator is stopped. Therefore all functions are stopped;
only the contents of the on-chip RAM and the SFR's are maintained.The port pins controlled by
their port latches output the values that are held by their SFR's.
The port pins which serve the alternate output functions show the values they had at the end
of the last cycle of the instruction which initiated the power-down mode; when the clockout
signal (CLKOUT, P1.6) is enabled, it will stop at low level. ALE and PSEN hold at logic low
level (see table 5).
To enter the power-down mode the pin PE must be on low level. The power-down mode then
is entered by two consecutive instructions. The first instruction has to set the flag bit PDE
(PCON.1) and must not set bit PDS (PCON.6), the following instruction has to set the start bit
PDS (PCON.6) and must not set bit PDE (PCON.1). The hardware ensures that a concurrent
setting of both bits, PDE and PDS, does not initiate the power-down mode. Bits PDE and PDS
will automatically be cleared after having been set and the value shown by reading one of these
bits is always 0 (see table 4). This double instruction is implemented to minimize the chance of
unintentionally entering the power-down mode which could possibly "freeze" the chip's activity
in an undesired status.
相關PDF資料 |
PDF描述 |
|---|---|
| SAB80C537-N | 8-Bit CMOS Single-Chip Microcontroller |
| SAB80C537-N16 | 8-Bit CMOS Single-Chip Microcontroller |
| SAB80C517-M16 | 8-Bit CMOS Single-Chip Microcontroller |
| SAB80C32-20-N | High-Performance 8-Bit Single Chip Microcontroller |
| SAB80C32-20-P | High-Performance 8-Bit Single Chip Microcontroller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SAB80C537-M-T40/85 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit CMOS Single-Chip Microcontroller |
| SAB80C537N | 制造商:Infineon Technologies AG 功能描述:MCU 8-Bit C500 8051 CISC ROMLess 5V 84-Pin PLCC 制造商:Infineon Technologies AG 功能描述:8BIT CPU 12MHZ SMD 80C537 PLCC84 |
| SAB80C537-N | 功能描述:IC MIRCROCONTROLLER 8BIT 84PLCC RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:260 系列:73S12xx 核心處理器:80515 芯體尺寸:8-位 速度:24MHz 連通性:I²C，智能卡，UART/USART，USB 外圍設備:LED，POR，WDT 輸入/輸出數:9 程序存儲器容量:64KB（64K x 8） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:2K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 5.5 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:68-VFQFN 裸露焊盤 包裝:管件 |
| SAB80C537-N16 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit CMOS Single-Chip Microcontroller |
| SAB80C537-N-T40/85 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit CMOS Single-Chip Microcontroller |
發布緊急采購，3分鐘左右您將得到回復。