參數資料
型號: SAK-XC164CB-32F40F
廠商: INFINEON TECHNOLOGIES AG
元件分類: 微控制器/微處理器
英文描述: 16-BIT, FLASH, 40 MHz, RISC MICROCONTROLLER, PQFP100
封裝: 0.0197 INCH PITCH, PLASTIC, TQFP-100
文件頁數: 63/80頁
文件大?。?/td> 1163K
代理商: SAK-XC164CB-32F40F
XC164-32
Derivatives
Electrical Parameters
Data Sheet
64
V1.0, 2005-06
CPU and EBC are clocked with the CPU clock signal
f
CPU. The CPU clock can have the
same frequency as the master clock (
f
CPU = fMC) or can be the master clock divided by
two:
f
CPU = fMC / 2. This factor is selected by bit CPSYS in register SYSCON1.
The specification of the external timing (AC Characteristics) depends on the period of the
CPU clock, called “TCP”.
The other peripherals are supplied with the system clock signal
f
SYS which has the same
frequency as the CPU clock signal
f
CPU.
Bypass Operation
When bypass operation is configured (PLLCTRL = 0xB) the master clock is derived from
the internal oscillator (input clock signal XTAL1) through the input- and output-
prescalers:
f
MC = fOSC / ((PLLIDIV+1) × (PLLODIV+1)).
If both divider factors are selected as ‘1’ (PLLIDIV = PLLODIV = ‘0’) the frequency of
f
MC
directly follows the frequency of
f
OSC so the high and low time of fMC is defined by the duty
cycle of the input clock
f
OSC.
The lowest master clock frequency is achieved by selecting the maximum values for both
divider factors:
f
MC = fOSC / ((3 + 1) × (14 + 1)) = fOSC / 60.
Phase Locked Loop (PLL)
When PLL operation is configured (PLLCTRL = 11B) the on-chip phase locked loop is
enabled and provides the master clock. The PLL multiplies the input frequency by the
factor F (
f
MC = fOSC × F) which results from the input divider, the multiplication factor, and
the output divider (F = PLLMUL+1 / (PLLIDIV+1
× PLLODIV+1)). The PLL circuit
synchronizes the master clock to the input clock. This synchronization is done smoothly,
i.e. the master clock frequency does not change abruptly.
Due to this adaptation to the input clock the frequency of
f
MC is constantly adjusted so it
is locked to
f
OSC. The slight variation causes a jitter of fMC which also affects the duration
of individual TCMs.
The timing listed in the AC Characteristics refers to TCPs. Because
f
CPU is derived from
f
MC, the timing must be calculated using the minimum TCP possible under the respective
circumstances.
The actual minimum value for TCP depends on the jitter of the PLL. As the PLL is
constantly adjusting its output frequency so it corresponds to the applied input frequency
(crystal or oscillator) the relative deviation for periods of more than one TCP is lower than
for one single TCP (see formula and Figure 16).
This is especially important for bus cycles using waitstates and e.g. for the operation of
timers, serial interfaces, etc. For all slower operations and longer periods (e.g. pulse train
相關PDF資料
PDF描述
SAM100S-011-2 100 CONTACT(S), FEMALE, RIGHT ANGLE TWO PART BOARD CONNECTOR, SURFACE MOUNT
SAP-17401400 SINGLE MODE, SIMPLEX FC CONNECTOR
SAP-17402000 SINGLE MODE, SIMPLEX FC CONNECTOR
SAP-17402100 SINGLE MODE, SIMPLEX FC CONNECTOR
SAP-17402200 SINGLE MODE, SIMPLEX FC CONNECTOR
相關代理商/技術參數
參數描述
SAK-XC164CL-32F20F 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16-Bit Single-Chip Microcontroller with C166SV2 Core
SAK-XC164CL-32F40F 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16-Bit Single-Chip Microcontroller with C166SV2 Core
SAK-XC164CM-16F20F BA 功能描述:16位微控制器 - MCU 16 BIT SINGLE CHIP W/ C166SV2 CORE RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
SAK-XC164CM-16F20FBA 制造商:Infineon Technologies AG 功能描述: 制造商:Rochester Electronics LLC 功能描述:
SAK-XC164CM-16F40F BA 功能描述:16位微控制器 - MCU MICROCONTROLLER 16-BIT RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT