參數資料
型號: SAK-XC164CS-32F40F
廠商: INFINEON TECHNOLOGIES AG
元件分類: 微控制器/微處理器
英文描述: 16-BIT, FLASH, 40 MHz, RISC MICROCONTROLLER, PQFP100
封裝: 0.50 MM PITCH, GREEN, PLASTIC, TQFP-100
文件頁數: 66/81頁
文件大?。?/td> 1106K
代理商: SAK-XC164CS-32F40F
XC164-32
Derivatives
Electrical Parameters
Data Sheet
67
V1.1, 2006-08
4.4.2
On-chip Flash Operation
The XC164CS’s Flash module delivers data within a fixed access time (see Table 17).
Accesses to the Flash module are controlled by the PMI and take 1 + WS clock cycles,
where WS is the number of Flash access waitstates selected via bitfield WSFLASH in
register IMBCTRL. The resulting duration of the access phase must cover the access
time
t
ACC of the Flash array. Therefore, the required Flash waitstates depend on the
available speed grade as well as on the actual system frequency.
Note: The Flash access waitstates only affect non-sequential accesses. Due to
prefetching mechanisms, the performance for sequential accesses (depending on
the software structure) is only partially influenced by waitstates.
In typical applications, eliminating one waitstate increases the average
performance by 5% … 15%.
Example: For an operating frequency of 40 MHz (clock cycle = 25 ns), Standard devices
must be operated with 2 waitstates: ((2 + 1)
× 25 ns) ≥ 70 ns.
Grade A devices can be operated with 1 waitstate: ((1 + 1)
× 25 ns) ≥ 50 ns.
indicates the interrelation of waitstates, system frequency, and speed grade.
Note: The maximum achievable system frequency is limited by the properties of the
respective derivative, i.e. 40 MHz (or 20 MHz for xxx-32F20F devices).
Table 17
Flash Characteristics
(Operating Conditions apply)
Parameter
Symbol
Limit Values
Unit
Min.
Typ.
Max.
Flash module access time (Standard)
t
ACC
CC
701)
1) The actual access time is also influenced by the system frequency, so the frequency ranges are not fully linear.
ns
Flash module access time (Grade A)
t
ACC
CC
ns
Programming time per 128-byte block
t
PR
CC
22)
2) Programming and erase time depends on the system frequency. Typical values are valid for 40 MHz.
5ms
Erase time per sector
t
ER
CC
2002)
500
ms
Table 18
Flash Access Waitstates
Required Waitstates
Frequency Range for
Standard Flash Speed
Frequency Range for
Flash Speed Grade A
0 WS (WSFLASH = 00B)
f
CPU ≤ 16 MHz
f
CPU ≤ 20 MHz
1 WS (WSFLASH = 01B)
f
CPU ≤ 28 MHz
f
CPU ≤ 40 MHz
2 WS (WSFLASH = 10B)
f
CPU ≤ 40 MHz
f
CPU ≤ 40 MHz
相關PDF資料
PDF描述
SAK-XC164CS-32F20F 16-BIT, FLASH, 20 MHz, RISC MICROCONTROLLER, PQFP100
SAK-XC2267M-104F80LAA 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP100
SAK-XC2285M-104F80LAA RISC MICROCONTROLLER, PQFP144
SAK-XC2285M-56F80LAA RISC MICROCONTROLLER, PQFP144
SAF-XC2287M-72F80LAA RISC MICROCONTROLLER, PQFP144
相關代理商/技術參數
參數描述
SAK-XC164CS-32F40F BB 制造商:Infineon Technologies AG 功能描述:MCU 16-Bit XC166 CISC/DSP/RISC 256KB Flash 2.5V/5V 100-Pin TQFP
SAK-XC164CS-32F40F BB-A 功能描述:16位微控制器 - MCU 16 BIT FLASH RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
SAK-XC164CS-32F40FBB 制造商:Rochester Electronics LLC 功能描述:- Bulk
SAK-XC164CS-32F40FBB-A 功能描述:16位微控制器 - MCU MICROCONTROLLER 16-BIT RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
SAK-XC164CS-32F40FBB-A TR 制造商:Infineon Technologies AG 功能描述: