- 您現在的位置：買賣IC網 > PDF目錄98076 > SAK-XC2388C-104F80L (INFINEON TECHNOLOGIES AG) 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP144 PDF資料下載
參數資料
| 型號： | SAK-XC2388C-104F80L |
| 廠商： | INFINEON TECHNOLOGIES AG |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP144 |
| 封裝： | 0.50 MM PITCH, GREEN, PLASTIC, LQFP-144 |
| 文件頁數： | 127/147頁 |
| 文件大小： | 1798K |
| 代理商： | SAK-XC2388C-104F80L |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁當前第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁
XC2387C, XC2388C
XC2000 Family Derivatives / High Line
Functional Description
Data Sheet
80
V1.2, 2010-09
3.16
System Timer
The System Timer consists of a programmable prescaler and two concatenated timers
(10 bits and 6 bits). Both timers can generate interrupt requests. The clock source can
be selected and the timers can also run during power reduction modes.
Therefore, the System Timer enables the software to maintain the current time for
scheduling functions or for the implementation of a clock.
3.17
Watchdog Timer
The Watchdog Timer is one of the fail-safe mechanisms which have been implemented
to prevent the controller from malfunctioning for longer periods of time.
The Watchdog Timer is always enabled after an application reset of the chip. It can be
disabled and enabled at any time by executing the instructions DISWDT and ENWDT
respectively. The software has to service the Watchdog Timer before it overflows. If this
is not the case because of a hardware or software failure, the Watchdog Timer
overflows, generating a prewarning interrupt and then a reset request.
The Watchdog Timer is a 16-bit timer clocked with the system clock divided by 16,384
or 256. The Watchdog Timer register is set to a prespecified reload value (stored in
WDTREL) in order to allow further variation of the monitored time interval. Each time it
is serviced by the application software, the Watchdog Timer is reloaded and the
prescaler is cleared.
Time intervals between 3.2
μs and 13.4 s can be monitored (@ 80 MHz).
Time intervals between 2.56
μs and 10.71 s can be monitored (@ 100 MHz).
The default Watchdog Timer interval after power-up is 6.5 ms (@ 10 MHz).
3.18
Clock Generation
The Clock Generation Unit can generate the system clock signal
f
SYS for the XC238xC
from a number of external or internal clock sources:
External clock signals with pad voltage or core voltage levels
External crystal or resonator using the on-chip oscillator
On-chip clock source for operation without crystal/resonator
Wake-up clock (ultra-low-power) to further reduce power consumption
The programmable on-chip PLL with multiple prescalers generates a clock signal for
maximum system performance from standard crystals, a clock input signal, or from the
on-chip clock source. See also Section 4.7.2.
The Oscillator Watchdog (OWD) generates an interrupt if the crystal oscillator frequency
falls below a certain limit or stops completely. In this case, the system can be supplied
with an emergency clock to enable operation even after an external clock failure.
All available clock signals can be output on one of two selectable pins.
相關PDF資料 |
PDF描述 |
|---|---|
| SAH-XC2712X-8F66R | 32-BIT, FLASH, 66 MHz, RISC MICROCONTROLLER, PDSO38 |
| SAK-XC2712X-8F66R | 32-BIT, FLASH, 66 MHz, RISC MICROCONTROLLER, PDSO38 |
| SAK-C164CH-8FM | 16-BIT, FLASH, 25 MHz, MICROCONTROLLER, PQFP80 |
| SAK-C164CI-8EMCB | 16-BIT, OTPROM, 20 MHz, MICROCONTROLLER, PQFP80 |
| SAK-C164SV-2RF | 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PQFP64 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SAK-XC2388C-200F100L AA | 制造商:Infineon Technologies AG 功能描述: |
| SAK-XC2388C-200F100L AB | 制造商:Infineon Technologies AG 功能描述: |
| SAK-XC2388E-136F128L AA | 制造商:Infineon Technologies AG 功能描述: |
| SAK-XC2712X-8F40R AA | 功能描述:16位微控制器 - MCU 16/32b Sngl Chip MCU 32Bit Perform 40MHz RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT |
| SAK-XC2722X-8F40V AA | 功能描述:16位微控制器 - MCU 16/32b Sngl Chip MCU 32Bit Perform 40MHz RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。