參數資料
型號： SC16C550BIB48,157
廠商： NXP Semiconductors
文件頁數： 8/48頁
文件大小： 0K
描述： IC UART SINGLE W/FIFO 48-LQFP
標準包裝： 1,250
特點： 可編程
通道數： 1，UART
FIFO's： 16 字節
電源電壓： 2.5V，3.3V，5V
帶自動流量控制功能： 是
帶故障啟動位檢測功能： 是
帶調制解調器控制功能： 是
帶CMOS： 是
安裝類型： 表面貼裝
封裝/外殼： 48-LQFP
供應商設備封裝： 48-LQFP（7x7）
包裝： 管件
其它名稱： 935274388157
SC16C550BIB48
SC16C550BIB48-ND
SC16C550B_5
NXP B.V. 2008. All rights reserved.
Product data sheet
Rev. 05 — 1 October 2008
16 of 48
NXP Semiconductors
SC16C550B
5 V, 3.3 V and 2.5 V UART with 16-byte FIFOs
6.7 Loopback mode
The internal loopback capability allows on-board diagnostics. In the loopback mode, the
normal modem interface pins are disconnected and recongured for loopback internally.
MCR[3:0] register bits are used for controlling loopback diagnostic testing. In the loopback
mode, OUT1 (bit 2) and OUT2 (bit 3) in the MCR register control the modem RI and DCD
inputs, respectively. MCR signals DTR and RTS (bits 0:1) are used to control the modem
CTS and DSR inputs, respectively. The transmitter output (TX) and the receiver input (RX)
are disconnected from their associated interface pins, and instead are connected together
internally (see Figure 11). The inputs CTS, DSR, DCD, and RI are disconnected from
their normal modem control input pins, and instead are connected internally to DTR, RTS,
OUT1 and OUT2. Loopback test data is entered into the transmit holding register via the
user data bus interface, D0 to D7. The transmit UART serializes the data and passes the
serial data to the receive UART via the internal loopback connection. The receive UART
converts the serial data back into parallel data that is then made available at the user data
interface D0 to D7. The user optionally compares the received data to the initial
transmitted data for verifying error-free operation of the UART TX/RX circuits.
In this mode, the receiver and transmitter interrupts are fully operational. The Modem
Control Interrupts are also operational. However, the interrupts can only be read using the
lower four bits of the Modem Status Register (MSR[3:0]) instead of the four Modem Status
Register bits 7:4. The interrupts are still controlled by the IER.
相關PDF資料
PDF描述
SC16C554DBIA68,529 IC UART QUAD W/FIFO 68-PLCC
SC16C554IB80,528 IC UART QUAD SOT315-1
SC16C650BIB48,151 IC UART SINGLE W/FIFO 48-LQFP
SC16C652BIB48,157 IC ENCODER/DECODER IRDA 48LQFP
SC16C654BIBS,557 IC QUAD UART 64BYTE 48HVQFN
相關代理商/技術參數
參數描述
SC16C550BIB48-S 功能描述:UART 接口集成電路 1CH. UART 16B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C550BIBS 功能描述:UART 接口集成電路 16CB 2.5V-5V 1CH UART 16B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C550BIBS,128 功能描述:UART 接口集成電路 16CB 2.5V-5V 1CH RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C550BIBS,151 功能描述:UART 接口集成電路 16CB 2.5V-5V 1CH RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C550BIBS,157 功能描述:UART 接口集成電路 16CB 2.5V-5V 1CH RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*