- 您現在的位置：買賣IC網 > PDF目錄379352 > SC16C750BIBS (NXP Semiconductors N.V.) 5 V, 3.3 V and 2.5 V UART with 64-byte FIFOs PDF資料下載
參數資料
| 型號： | SC16C750BIBS |
| 廠商： | NXP Semiconductors N.V. |
| 元件分類： | 收發器 |
| 英文描述： | 5 V, 3.3 V and 2.5 V UART with 64-byte FIFOs |
| 封裝： | SC16C750BIA44<SOT187-2 (PLCC44)|<<http://www.nxp.com/packages/SOT187-2.html<1<week 41, 2004,;SC16C750BIA44<SOT187-2 (PLCC44)|<<http://www.nxp.com/packages/SOT187-2.html&l |
| 文件頁數： | 13/44頁 |
| 文件大小： | 212K |
| 代理商： | SC16C750BIBS |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁
SC16C750B_5
NXP B.V. 2008. All rights reserved.
Product data sheet
Rev. 05 — 17 October 2008
13 of 44
NXP Semiconductors
SC16C750B
5 V, 3.3 V and 2.5 V UART with 64-byte FIFOs
6.7 Sleep mode
The SC16C750B is designed to operate with low power consumption. A special Sleep
mode is included to further reduce power consumption (the internal oscillator driver is
disabled) when the chip is not being used. With IER[4] enabled (set to a logic 1), the
SC16C750B enters the Sleep mode, but resumes normal operation when a start bit is
detected, a change of state of RX or on any of the modem input pins RI, CTS, DSR, DCD,
or a transmit data is provided by the user. If the Sleep mode is enabled and the
SC16C750B is awakened by one of the conditions described above, it will return to the
Sleep mode automatically after the last character is transmitted or read by the user. In any
case, the Sleep mode will not be entered while an interrupt(s) is pending. The
SC16C750B will stay in the Sleep mode of operation until it is disabled by setting IER[4] to
a logic 0.
6.8 Low power mode
In Low power mode the oscillator is still running and only the clock to the UART core is
cut off. This helps to reduce the operating current to about
1
3
. The UART wakes up under
the same conditions as in Sleep mode.
6.9 Loopback mode
The internal loopback capability allows on-board diagnostics. In the Loopback mode, the
normal modem interface pins are disconnected and reconfigured for loopback internally.
MCR[3:0] register bits are used for controlling loopback diagnostic testing. In the
Loopback mode, OUT1 and OUT2 in the MCR register (bit 2 and bit 3) control the modem
RI and DCD inputs, respectively. MCR signals DTR and RTS (bit 0 and bit 1) are used to
control the modem DSR and CTS inputs, respectively. The transmitter output (TX) and the
receiver input (RX) are disconnected from their associated interface pins, and instead are
connected together internally (see
Figure 6
). The CTS, DSR, DCD, and RI are
disconnected from their normal modem control input pins, and instead are connected
internally to RTS, DTR, OUT2 and OUT1. Loopback test data is entered into the Transmit
Holding Register via the user data bus interface, D0 to D7. The transmit UART serializes
the data and passes the serial data to the receive UART via the internal loopback
connection. The receive UART converts the serial data back into parallel data that is then
made available at the user data interface D0 to D7. The user optionally compares the
received data to the initial transmitted data for verifying error-free operation of the UART
TX/RX circuits.
相關PDF資料 |
PDF描述 |
|---|---|
| SC16C751BIBS | 5 V, 3.3 V and 2.5 V UART with 64-byte FIFOs |
| SC16C752BIB48 | 5 V, 2.2 V and 2.5 V dual UART, 5 Mbit-s (max.), with 64-byte FIFOs |
| SC16C752BIBS | 5 V, 2.2 V and 2.5 V dual UART, 5 Mbit-s (max.), with 64-byte FIFOs |
| SC16C754BIA68 | 5 V, 3.3 V and 2.5 V quad UART, 5 Mbit-s (max.) with 64-byte FIFOs |
| SC16C754BIB80 | 5 V, 3.3 V and 2.5 V quad UART, 5 Mbit-s (max.) with 64-byte FIFOs |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SC16C750BIBS,128 | 功能描述:UART 接口集成電路 16CB 2.5V-5V 1CH RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| SC16C750BIBS,151 | 功能描述:UART 接口集成電路 1CH. UART 64B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| SC16C750BIBS,157 | 功能描述:UART 接口集成電路 16CB 2.5V-5V 1CH RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| SC16C750BIBS-F | 功能描述:UART 接口集成電路 16CB 2.5V-5V 1CH UART 64B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| SC16C750BIBS-S | 制造商:NXP Semiconductors 功能描述:UART 1-CH 64Byte FIFO 2.5V/3.3V/5V 32-Pin HVQFN EP Tray |
發布緊急采購，3分鐘左右您將得到回復。