參數資料
| 型號： | SC16IS741IPW,112 |
| 廠商： | NXP Semiconductors |
| 文件頁數： | 2/17頁 |
| 文件大小： | 0K |
| 描述： | IC UART 16TSSOP |
| 標準包裝： | 96 |
| 特點： | RS-485 |
| 通道數： | 1，UART |
| FIFO's： | 64 字節(jié) |
| 規(guī)程： | RS232，RS485 |
| 電源電壓： | 2.5V, 3.3V |
| 帶自動流量控制功能： | 是 |
| 帶IrDA 編碼器/解碼器： | 是 |
| 帶調制解調器控制功能： | 是 |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 16-TSSOP |
| 包裝： | 管件 |
| 其它名稱： | 568-5784 SC16IS741IPW,112-ND |
SC16IS741_1
NXP B.V. 2010. All rights reserved.
Product data sheet
Rev. 01 — 29 April 2010
10 of 52
NXP Semiconductors
SC16IS741
Single UART with I2C-bus/SPI interface, 64-byte FIFOs, IrDA SIR
7.4 Hardware reset, Power-On Reset (POR) and software reset
These three reset methods are identical and will reset the internal registers as indicated in
Table 4 summarizes the state of register.
[1]
Registers DLL, DLH, SPR, XON1, XON2, XOFF1, XOFF2 are not reset by the top-level reset signal
RESET, POR or Software Reset, that is, they hold their initialization values during reset.
Table 5 summarizes the state of registers after reset.
Table 4.
Register reset[1]
Register
Reset state
Interrupt Enable Register
all bits cleared
Interrupt Identification Register
bit 0 is set; all other bits cleared
FIFO Control Register
all bits cleared
Line Control Register
reset to 0001 1101 (0x1D)
Modem Control Register
all bits cleared
Line Status Register
bit 5 and bit 6 set; all other bits cleared
Modem Status Register
bits 0:3 cleared; bits 4:7 input signals
Enhanced Feature Register
all bits cleared
Receiver Holding Register
pointer logic cleared
Transmitter Holding Register
pointer logic cleared
Transmission Control Register
all bits cleared.
Trigger Level Register
all bits cleared.
Transmit FIFO level
reset to 0100 0000 (0x40)
Receive FIFO level
all bits cleared
Extra Feature Register
all bits cleared
Table 5.
Output signals after reset
Signal
Reset state
TX
HIGH
RTS
HIGH
IRQ
HIGH by external pull-up
相關PDF資料 |
PDF描述 |
|---|---|
| SC16IS750IBS,151 | IC UART I2C/SPI 24-HVQFN |
| SC16IS762IBS,151 | IC UART DUAL I2C/SPI 32-HVQFN |
| SC26C92A1N,112 | IC UART 40-DIP |
| SC28C94A1A,512 | IC UART QUAD W/FIFO 52-PLCC |
| SC28L198A1A,512 | IC UART OCTAL W/FIFO 84-PLCC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SC16IS74Q900 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Single UART with I2C-bus/SPI interface, 64 bytes of transmit and receive FIFOs |
| SC16IS750 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Single UART with I2C-bus/SPI interface, 64 bytes of transmit and receive FIFOs, IrDA SIR built-in support |
| SC16IS750IBS | 功能描述:UART 接口集成電路 I2C/SPI-UARTBRIDGE W/IRDA AND GPIO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| SC16IS750IBS,128 | 功能描述:UART 接口集成電路 I2C/SPI-UARTBRIDGE W/IRDA AND GPIO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| SC16IS750IBS,151 | 功能描述:UART 接口集成電路 UART I2C/SPI RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
發(fā)布緊急采購，3分鐘左右您將得到回復。