參數資料
型號: SE9174
廠商: Electronic Theatre Controls, Inc.
英文描述: 2.0A Bus Termmination Regulator
中文描述: 安培的電流調節巴士Termmination
文件頁數: 3/5頁
文件大?。?/td> 184K
代理商: SE9174
All contents are subject to change without prior notice
Seaward Electronics Inc., 2005. www.seawardinc.com Page 3
R0
R1
R2
R3
R4
R5
R6
R7
R8
R9
RN
RN1
Terminator Resis
REFEN
SE9174
SE9174
VOUT
VOUT
BUS(0)
BUS(1)
BUS(2)
BUS(3)
BUS(4)
BUS(5)
BUS(6)
BUS(7)
BUS(8)
BUS(9)
BUS(N+1)
BUS(N)
Application Information
Internal parasitic diode
Avoid forward-bias internal parasitic diode,
V
OUT
to V
CNTL
, and V
OUT
to V
IN
, the V
OUT
should not
be forced same voltage respect to ground on this
pin while the V
CNTL
or V
IN
is disappeared.
Consideration while designs the resistance of
voltage divider
Make sure the sinking current capability of
pull-down NMOS if the lower resistance was chosen
so that the voltage on V
REFEN
is below 0.2V.
In addition to item1, the capacitor and voltage
divider form the low-pass filter. There are two
reasons doing this design; one is for output voltage
soft-start while another is for noise immunity.
Layout Consideration
The SE9174 regulator is packaged in
thermally enhanced plastic SOP-8 package. This
small footprint package is unable to convectively
dissipate the heat generated when the regulator is
operating at high current levels. In order to control
die operating temperatures, the PC board layout
should allow for maximum possible copper area at
the V
CNTL
pins of the SE9174.
The multiple V
CNTL
pins on the SOP-8 package
are internally connected, but lowest thermal
resistance will result if these pins are tightly
connected on the PC board. This will also aid heat
dissipation at high power levels.
If the large copper around the IC is
unavailable, a buried layer may be used as a heat
spreader, Use via to conduct the heat into the
buried or backside of PCB layer. The via should be
small enough to retain solder when the board is
wave-soldered.
Thermal Consideration
SE9174 regulators have internal thermal
limiting circuitry designed to protect the device
during overload conditions. For continuous normal
load conditions however, the maximum junction
temperature rating of 150°C must not be exceeded.
Higher continuous currents or ambient temperature
require additional heatsinking. Heat sinking to the
IC package must consider the worst case power
dissipation which may occur.
It should also be noted that with the V
CNTL
equal to 5V, the point of thermal shutdown will be
degraded by approx. 20°C compared to the V
CNTL
equipped with 3.3V. It is highly recommended that
to use the 3.3V rail acting as the V
CNTL
so as to
minimize the thermal concern of the SE9174 in the
SOP-8 package.
相關PDF資料
PDF描述
SED1351F CMOS GRAPHIC LCD CONTROLLER
SED1606D CMOS LCD SEGMENT DRIVER
SED1606D0A CMOS LCD SEGMENT DRIVER
SED1606D0B CMOS LCD SEGMENT DRIVER
SED9420CAC CMOS DATA SEPARATOR FOR FDD
相關代理商/技術參數
參數描述
SE9174C 制造商:SEAWARD 制造商全稱:SEAWARD 功能描述:2A Sink/Source Bus Termination Regulator
SE91FA06C2-1-34 制造商:MISCELLANEOUS 功能描述:
SE920, BK 制造商:SERPAC Electronic Enclosures 功能描述:STORAGE CASE, POLYPROPYLENE; External Height - Imperial:10.1"; External Height - Metric:256mm; External Width - Imperial:16"; External Width - Metric:406mm; External Depth - Imperial:23.96"; External Depth - Metric:609mm; Color:Black;RoHS Compliant: Yes
SE920, GM 制造商:SERPAC Electronic Enclosures 功能描述:STORAGE CASE, POLYPROPYLENE, Carrying Case Material:(Not Available), External He 制造商:SERPAC Electronic Enclosures 功能描述:STORAGE CASE, POLYPROPYLENE, Carrying Case Material:-, External Height - Imperial:10.1", External Height - Metric:256mm, External Width - Imperial:16", External Width - Metric:406mm, External Depth - Imperial:23.96" , RoHS Compliant: Yes
SE920, OR 制造商:SERPAC Electronic Enclosures 功能描述:STORAGE CASE, POLYPROPYLENE; External Height - Imperial:10.1"; External Height - Metric:256mm; External Width - Imperial:16"; External Width - Metric:406mm; External Depth - Imperial:23.96"; External Depth - Metric:609mm ;RoHS Compliant: Yes