參數資料
型號: SI4136-F-BT
廠商: Silicon Laboratories Inc
文件頁數: 11/34頁
文件大?。?/td> 0K
描述: SYNTH WLAN SAT RADIO(RF1/RF2/IF)
標準包裝: 62
類型: *
驅動器/接收器數: *
規(guī)程: *
電源電壓: 2.7 V ~ 3.6 V
安裝類型: 表面貼裝
封裝/外殼: 24-TSSOP(0.173",4.40mm 寬)
供應商設備封裝: 24-TSSOP
包裝: 管件
Si4136/Si4126
Rev. 1.41
19
(Register 0) can be set to 1 to reduce the bias currents
and therefore reduce the power dissipated by the IF
amplifier. For loads less than 500
LPWR should be
set to 0 to maximize the output level.
For IF frequencies greater than 500 MHz, a matching
network is required in order to drive a 50
load. See
below.
The
value
of
LMATCH can be
determined by Table 9.
Typical values range between 8 nH and 40 nH.
Figure 15. IF Frequencies > 500 MHz
For frequencies less than 500 MHz, the IF output buffer
can directly drive a 200
resistive load or higher. For
resistive loads greater than 500
(f < 500 MHz) the
LPWR bit can be set to reduce the power consumed by
the IF output buffer. See Figure 16 below.
Figure 16. IF Frequencies < 500 MHz
Figure 17. Typical IF Output Voltage vs.
Load Resistance at 550 MHz
2.7. Reference Frequency Amplifier
The Si4136 provides a reference frequency amplifier. If
the driving signal has CMOS levels, it can be connected
directly to the XIN pin. Otherwise, the reference
frequency signal should be AC coupled to the XIN pin
through a 560 pF capacitor.
2.8. Powerdown Modes
Table 10 summarizes the powerdown functionality. The
Si4136 can be powered down by taking the PWDN pin
low or by setting bits in the Powerdown register
(Register 2). When the PWDN pin is low, the Si4136 will
be powered down regardless of the Powerdown register
settings.
When
the
PWDN
pin
is
high,
power
management is under control of the Powerdown register
bits.
The IF and RF sections of the Si4136 circuitry can be
individually powered down by setting the Powerdown
register bits PDIB and PDRB low. The reference
frequency amplifier will also be powered up if either the
PDRB and PDIB bits are high. Also, setting the
AUTOPDB bit to 1 in the Main Configuration register
(Register 0) is equivalent to setting both bits in the
Powerdown register to 1.
The serial interface remains available and can be
written in all power-down modes.
2.9. Auxiliary Output (AUXOUT)
The signal appearing on AUXOUT is selected by setting
the AUXSEL bits in the Main Configuration register
(Register 0).
The LDETB signal can be selected by setting the
AUXSEL bits to 011. This signal can be used to indicate
that the IF or RF PLL is about to lose lock due to
excessive ambient temperature drift and should be re-
tuned.
Table 9. LMATCH Values
Frequency
LMATCH
500–600 MHz
40 nH
600–800 MHz
27 nH
800–1 GHz
18 nH
IFO UT
L
MATCH
>500 pF
50
IFO UT
>500 pF
>200
0
50
100
150
200
250
300
350
400
450
0
200
400
600
800
1000
1200
Load Resistance (
)
Output
Voltage
(mVrms)
LPWR=0
LPWR=1
相關PDF資料
PDF描述
MK1491-09FILN IC CLK SRC AMD GEODE GX2 28SSOP
V300B24M150BF CONVERTER MOD DC/DC 24V 150W
D38999/24FH53PB CONN RCPT 53POS JAM NUT W/PINS
V300B24M150B3 CONVERTER MOD DC/DC 24V 150W
ICS557GI-05ALF IC CLK SOURCE QUAD PCI 20-TSSOP
相關代理商/技術參數
參數描述
SI4136-F-GM 功能描述:射頻無線雜項 WLAN SATELITE RADIO MLP-28 RoHS:否 制造商:Texas Instruments 工作頻率:112 kHz to 205 kHz 電源電壓-最大:3.6 V 電源電壓-最小:3 V 電源電流:8 mA 最大功率耗散: 工作溫度范圍:- 40 C to + 110 C 封裝 / 箱體:VQFN-48 封裝:Reel
SI4136-F-GMR 功能描述:時鐘發(fā)生器及支持產品 WLAN Satellite Radio Synthesizer RoHS:否 制造商:Silicon Labs 類型:Clock Generators 最大輸入頻率:14.318 MHz 最大輸出頻率:166 MHz 輸出端數量:16 占空比 - 最大:55 % 工作電源電壓:3.3 V 工作電源電流:1 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-56
SI4136-F-GT 功能描述:射頻無線雜項 WLAN SATELITE RADIO TSSOP-24 RoHS:否 制造商:Texas Instruments 工作頻率:112 kHz to 205 kHz 電源電壓-最大:3.6 V 電源電壓-最小:3 V 電源電流:8 mA 最大功率耗散: 工作溫度范圍:- 40 C to + 110 C 封裝 / 箱體:VQFN-48 封裝:Reel
SI4136-F-GTR 功能描述:射頻無線雜項 WLAN Satellite Radio Synthesizer RoHS:否 制造商:Texas Instruments 工作頻率:112 kHz to 205 kHz 電源電壓-最大:3.6 V 電源電壓-最小:3 V 電源電流:8 mA 最大功率耗散: 工作溫度范圍:- 40 C to + 110 C 封裝 / 箱體:VQFN-48 封裝:Reel
SI4136M-EVB 功能描述:開發(fā)板和工具包 - 無線 802.11b and ISM Band RoHS:否 制造商:Arduino 產品:Evaluation Boards 工具用于評估:AT32UC3L 核心:AVR32 頻率: 接口類型:USB 工作電源電壓:5 V