![](http://datasheet.mmic.net.cn/300000/SN74LVC16240_datasheet_16215578/SN74LVC16240_3.png)
SN74LVC16240
16-BIT BUFFER/DRIVER
WITH 3-STATE OUTPUTS
SCAS312A – NOVEMBER 1993 – REVISED JULY 1995
3
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
absolute maximum ratings over operating free-air temperature range (unless otherwise noted)
Supply voltage range, V
CC
Input voltage range, V
I
Voltage range applied to any output in the high-impedance state
or power-off state, V
O
(see Note 1)
Voltage range applied to any output in the high
or low state, V
O
(see Notes 1 and 2)
Input clamp current, I
IK
(V
I
< 0)
Output clamp current, I
OK
(V
O
< 0 or V
O
> V
CC
)
Continuous output current, I
O
(V
O
= 0 to V
CC
)
Continuous current through V
CC
or GND
Maximum power dissipation at T
A
= 55
°
C (in still air) (see Note 3):DGG package
–0.5 V to 6.5 V
–0.5 V to 6.5 V
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
–0.5 V to 6.5 V
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
–0.5 V to V
CC
+ 0.5 V
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
–50 mA
±
50 mA
±
50 mA
±
100 mA
0.85 W
1.2 W
. . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . .
DL package
Storage temperature range, T
stg
Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and
functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not
implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTES:
1. The input and output negative-voltage ratings may be exceeded if the input and output clamp-current ratings are observed.
2. This value is limited to 4.6 V maximum.
3. The maximum package power dissipation is calculated using a junction temperature of 150
°
C and a board trace length of 750 mils.
For more information, refer to the Package Thermal Considerationsapplication note in the 1994 ABT Advanced BiCMOS Technology
Data Book literature number SCBD002B.
–65
°
C to 150
°
C
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
recommended operating conditions (see Note 4)
MIN
MAX
3.6
UNIT
VCC
Supply voltage
Operating
2
V
Data retention only
1.5
VIH
VIL
VI
VO
High-level input voltage
VCC = 2.7 V to 3.6 V
VCC = 2.7 V to 3.6 V
2
V
Low-level input voltage
0.8
V
Input voltage
0
VCC
5.5
V
Output voltage
0
V
IOH
High-level output current
VCC = 2.7 V
VCC = 3 V
VCC = 2.7 V
VCC = 3 V
–12
mA
–24
IOL
Low-level output current
12
mA
24
t/
v
TA
NOTE 4: Unused control inputs must be held high or low to prevent them from floating.
Input transition rise or fall rate
0
10
ns/V
°
C
Operating free-air temperature
–40
85
P