- 您現在的位置：買賣IC網 > PDF目錄372169 > SP200ET 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors PDF資料下載
參數資料
| 型號： | SP200ET |
| 元件分類： | RS-232 |
| 英文描述： | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| 中文描述： | 5V的高速RS - 232收發器與0.1uF電容 |
| 文件頁數： | 7/15頁 |
| 文件大?。?/td> | 213K |
| 代理商： | SP200ET |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁
7
REV: A DATE:12/03/2003
+5V High-Speed RS232 Transceivers
Copyright 2000 Sipex Corporation
Figure 3. Charge Pump Waveforms
+10V
a) C
2
+
GND
GND
b) C
2
–
–10V
pump. Each model within the Series incorpo-
rates variations of these circuits to achieve the
desired configuration and performance.
Transmitter/Driver
The drivers are inverting transmitters, which ac-
cept either TTL or CMOS inputs and output the
RS-232 signals with an inverted sense relative to
the input logic levels. Typically, the RS-232 out-
put voltage swing is
±
9V with no load, and
±
5V
minimum with full load. The transmitter outputs
are protected against infinite short–circuits to
ground without degradation in reliability. The
drivers of the
SP200
,
SP205
,
SP205B
,
SP206
,
SP206B
,
SP207B, SP211
,
SP211B
and
SP213
can be tri–stated by using the SHUTDOWN
function.
In the “power off” state, the output impedance will
remain greater than 300 Ohms, again satisfying the
RS-232 specifications. Should the input of the
driver be left open, an internal 400kOhm pullup
resistor to V
forces the input high, thus commit-
ting the output to a low state. The slew rate of the
transmitter output is internally limited to a maxi-
mum of 30V/
μ
s in order to meet the EIA standards
(EIA RS-232D 2.1.7, Paragraph 5). The transition
of the loaded output from high to low also meets
the monotonicity requirements of the standard.
Receivers
The receivers convert RS-232 input signals to
inverted TTL signals. Since the input is usually
from a transmission line where long cable lengths
and system interference can degrade the signal,
the inputs have a typical hysteresis margin of
500mV. This ensures that the receiver is virtu-
ally immune to noisy transmission lines. Should
an input be left unconnected, a 5kOhm pulldown
resistor to ground will commit the output of the
receiver to a high state.
Figure 4. Charge Pump — Phase 3
V
CC
= +5V
–5V
+5V
–5V
V
SS
Storage Capacitor
V
DD
Storage Capacitor
C
1
C
2
C
3
C
4
+
+
+
+
–
–
–
–
相關PDF資料 |
PDF描述 |
|---|---|
| SP208EHCA | High Speed 5V High Performance RS232 Transceivers |
| SP208EHCP | High Speed 5V High Performance RS232 Transceivers |
| SP208EHCT | High Speed 5V High Performance RS232 Transceivers |
| SP208EHEA | High Speed 5V High Performance RS232 Transceivers |
| SP208EHEP | High Speed 5V High Performance RS232 Transceivers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SP200ET/TR | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:+5V High-Speed RS-232 Transceivers with 0.1mF Capacitors |
| SP200F | 制造商:VMI 制造商全稱:VMI 功能描述:12,500 V - 25,000 V Rectifier Stacks 0.5 A Forward Current 150 ns Recovery Time |
| SP200-RNKIT | 功能描述:烙鐵 NEW SP HAND PIECE NEW SLEEPER STAND RoHS:否 制造商:Weller 產品:Soldering Stations 類型:Digital, Iron, Stand, Cleaner 瓦特:50 W 最大溫度:+ 850 F 電纜類型:US Cord Included |
| SP200S | 制造商:VMI 制造商全稱:VMI 功能描述:15,000 V - 30,000 V Rectifier Stacks 0.5 A Forward Current 3000 ns Recovery Time |
| SP200UF | 制造商:VMI 制造商全稱:VMI 功能描述:High Voltage Rectifier Stacks |
發布緊急采購，3分鐘左右您將得到回復。