<ol id="qtea9"></ol>
  • 參數資料
    型號: SP3232EBCN
    元件分類: RS-232
    英文描述: 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors
    中文描述: 5V的高速RS - 232收發器與0.1uF電容
    文件頁數: 8/19頁
    文件大小: 138K
    代理商: SP3232EBCN
    Date: 06/22/04 SP3222EH/3232EH 3.3V, 460 Kbps RS-232 Transceivers
    Copyright 2004 Sipex Corporation
    8
    DESCRIPTION
    The
    SP3222EH
    and
    SP3232EH
    are 2-driver/
    2-receiver devices ideal for portable or hand-held
    applications. The
    SP3222EH
    features a 1
    μ
    A
    shutdown mode that reduces power consumption
    and extends battery life in portable systems.
    Its receivers remain active in shutdown mode,
    allowing external devices such as modems to be
    monitored using only 1
    μ
    A supply current.
    The
    SP3222EH/3232EH
    transceivers meet the
    EIA/TIA-232 and V.28/V.24 communication
    protocols. They feature
    Sipex's
    proprietary
    on-board charge pump circuitry that generates
    2 x V
    for RS-232 voltage levels from a single
    +3.0V to +5.5V power supply. The
    SP3222EH/
    3232EH
    drivers operate at a minimum data
    rate of 460Kbps.
    THEORY OF OPERATION
    The
    SP3222EH/3232EH
    are made up of three
    basic circuit blocks: 1. Drivers, 2. Receivers, and 3.
    the Sipex proprietary charge pump.
    Drivers
    The drivers are inverting level transmitters that
    convert TTL or CMOS logic levels to +5.0V
    EIA/TIA-232 levels inverted relative to the input
    logic levels. Typically, the RS-232 output voltage
    swing is +5.5V with no load and at least +5V
    minimum fully loaded. The driver outputs are
    protected against infinite short-circuits to ground
    without degradation in reliability. Driver outputs
    will meet EIA/TIA-562 levels of +3.7V with
    supply voltages as low as 2.7V.
    The drivers have a minimum data rate of
    460Kbps fully loaded with 3K
    in parallel with
    1000pF, ensuring compatibility with PC-to-PC
    communication software.
    The slew rate of the driver output is internally
    limited to a maximum of 30V/
    μ
    s in order to meet
    the EIA standards (EIA RS-232D 2.1.7,
    Paragraph 5). The transition of the loaded output
    from HIGH to LOW also meets the monotonicity
    requirements of the standard.
    Figure 8
    shows a loopback circuit used to test the
    RS-232 drivers.
    Figure 9
    shows the test results
    of the loopback circuit with all drivers active at
    120Kbps and RS-232 loads in parallel with
    1000pF capacitors.
    Figure 10
    shows the test
    results where one driver is active at 460Kbps and
    all drivers are loaded with an RS-232 receiver
    in parallel with a 1000pF capacitor.
    The
    SP3222EH
    driver's output stages are
    tri-stated in shutdown mode. When the power is
    off, the
    SP3222EH
    device permits the outputs to
    be driven up to +12V. Because the driver's
    inputs do not have pull-up resistors, unused
    inputs should be connected to V
    CC
    or GND.
    In the shutdown mode, the supply current is less
    than 1
    μ
    A, where SHDN = LOW. When the
    SP3222EH
    device is shut down, the device's
    driver outputs are disabled (tri-stated) and the
    charge pumps are turned off with V+ pulled
    down to V
    and V- pulled to GND. The time
    required to exit shutdown is typically 100
    μ
    s.
    SHDN is connected to V
    if the shutdown mode
    is not used. SHDN has no effect on RxOUT or
    RxOUTB.
    As they become active, the two driver
    outputs go to opposite RS-232 levels: one driver
    input is HIGH and the other LOW. Note that the
    drivers are enabled only when the magnitude of
    V- exceeds approximately 3V.
    相關PDF資料
    PDF描述
    SP3232EBCP 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors
    SP3232EBCT 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors
    SP3232EBCY 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors
    SP3222ECP 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors
    SP3222ECT 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors
    相關代理商/技術參數
    參數描述
    SP3232EBCN/TR 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:CorporationTrue +3.0V to +5.5V RS-232 Transceivers
    SP3232EBCN-L 功能描述:RS-232接口集成電路 RS232 250 kbps temp 0C to 70C RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝:
    SP3232EBCN-L/TR 功能描述:RS-232接口集成電路 TRUE +3V-+5.5V RS-232 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝:
    SP3232EBCP 制造商:Exar Corporation 功能描述:Line Transceiver, 2-Driver, 2-Receiver, 16 Pin, Plastic, DIP
    SP3232EBCP-L 功能描述:RS-232接口集成電路 TRUE +3V-+5.5V RS-232 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: