- 您現在的位置：買賣IC網 > PDF目錄10193 > SP3244ECA-L/TR (Exar Corporation)IC TXRX RS232 28SSOP PDF資料下載
參數資料
| 型號： | SP3244ECA-L/TR |
| 廠商： | Exar Corporation |
| 文件頁數： | 5/22頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TXRX RS232 28SSOP |
| 標準包裝： | 1,500 |
| 類型： | 收發器 |
| 驅動器/接收器數： | 3/5 |
| 規程： | RS232 |
| 電源電壓： | 3 V ~ 5.5 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-SSOP（0.209"，5.30mm 寬） |
| 供應商設備封裝： | 28-SSOP |
| 包裝： | 帶卷 (TR) |
3
Exar Corporation 48720 Kato Road, Fremont CA, 94538 50-668-707 www.exar.com
SP3244E_SP3245E_00_2509
DESCRIPTION
±15KV ESD PROTECTION
ESD-protection structures are incorporated
on all pins to protect against electrostatic
discharges encountered during handling and
assembly. The driver output and receiver inputs
of the SP3244E/3245E have extra protection
against static electricity. Exar uses state-of-the-
art structures to protect these pins against ESD
of ±15kV without damage. The ESD structures
withstand high ESD in all states: normal opera-
tion, shutdown, and powered down. After an
ESD event, the SP3244E/3245E keep working
without latch-up or damage.
ESD protection can be tested in various ways.
The transmitter outputs and receiver inputs of
the SP3244/3245 are characterized for protec-
tion to the following limits:
±15kV using the Human Body Model
Auto On-Line Plus provides greater power
savings in typical operation because the trans-
ceiver will go into low power standby mode
unless a communication link is in use. Signals
such as CTS, RTS, DTR, DSR, or RI will typi-
cally change signal-state to establish hand-
shaking before any actual data-communication
takes place. Transitions on these handshake
signals will wake up the Auto On-Line Plus
transceiver to prepare it for sending data
(tONLINE 100μs typical).
Receivers remain active to detect incoming
signals in Auto On-Line Plus standby mode.
Receiver outputs may be disabled by enter-
ing manual shutdown by driving SHUTDOWN
pin to logic 0. A special non-inverted receiver
output R2OUT remains active in all modes,
including SHUTDOWN pin at logic 0.
In some applications if there is a significant
delay (greater than tOFFLINE) between the
handshaking transitions and the start of data
communication the transceiver may enter
Auto On-Line Plus standby mode before data
communication begins. The tOFFLINE interval
is at least 5 seconds and no longer than 60
seconds.
In applications where the transceiver needs to
remain active anytime it is connected to live
RS-232 signals, even if those signals remain
idle for longer than tOFFLINE, then the STATUS
output may be used to drive the ONLINE pin.
The STATUS output pin functions the same
in both Auto On-Line and Auto On-line Plus
devices. STATUS will output logic 1 if any of
the receiver inputs are driven greater than
±2.7V magnitude by incoming RS-232 signals
and drives logic 0 if receiver inputs are float-
ing or driven to ground (see page 4). Driv-
ing the ONLINE pin with the STATUS output
disables Auto On-line Plus (Forced On-Line)
whenever RS-232 voltages are seen on any
receiver inputs. If no RS-232 voltages are seen
on the receiver inputs the Auto On-Line Plus
transceiver will still activate its charge pump
and driver outputs when the driver inputs are
active. This allows the transceiver to signal a
remote Auto On-Line or Auto On-Line Plus,
on the other end of the data cable, to wake up.
The STATUS output pin remains active in all
modes, including SHUTDOWN pin at logic 0.
Connecting STATUS output to drive both
ONLINE and SHUTDOWN will wake the trans-
ceiver if any receiver inputs are driven greater
than ±2.7V magnitude and put the transceiver
into Forced Shutdown mode if all receiver inputs
are floating or driven to ground.
相關PDF資料 |
PDF描述 |
|---|---|
| VE-B61-IV-S | CONVERTER MOD DC/DC 12V 150W |
| T 3638 100 | CONN FMALE RCPT 12PS REAR PNL MT |
| VE-B4Y-IU-S | CONVERTER MOD DC/DC 3.3V 132W |
| VE-2WK-MY | CONVERTER MOD DC/DC 40V 50W |
| LTC1487CN8 | IC TXRX RS485 LOW EMI LOPWR 8DIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SP3244ECY-L | 功能描述:RS-232接口集成電路 Int. +3V to +5.5V RS232 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| SP3244ECY-L/TR | 功能描述:RS-232接口集成電路 Int. +3V to +5.5V RS232 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| SP3244EEA-L | 功能描述:RS-232接口集成電路 Int. +3V to +5.5V RS232 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| SP3244EEA-L/TR | 功能描述:RS-232接口集成電路 Int. +3V to +5.5V RS232 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| SP3244EER1-L | 功能描述:RS-232接口集成電路 Transceiver with Auto On-Line Plus RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
發布緊急采購，3分鐘左右您將得到回復。