- 您現在的位置：買賣IC網 > PDF目錄16863 > SP3508EB (Exar Corporation)BOARD EVALUATION FOR SP3508 PDF資料下載
參數資料
| 型號： | SP3508EB |
| 廠商： | Exar Corporation |
| 文件頁數： | 19/36頁 |
| 文件大?。?/td> | 0K |
| 描述： | BOARD EVALUATION FOR SP3508 |
| 標準包裝： | 1 |
| 主要目的： | 接口，收發器，RS-232，RS-449，EIA-530（A），X.21 |
| 嵌入式： | 否 |
| 已用 IC / 零件： | SP3508 |
| 主要屬性： | 內部線路或數字回路測試 |
| 次要屬性： | 8 個驅動器和 8 個接收器 |
| 已供物品： | 板 |
| 其它名稱： | 1016-1626 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
26
Exar Corporation 48720 Kato Road, Fremont CA, 94538 (50)668-707 www.exar.com
SP3508_00_072208
These drivers are current sources that
drive loop current through a differential pair
resulting in a 550mV differential voltage at
the receiver. These drivers also incorporate
fixed termination networks for each driver in
order to set the V
OH and VOL depending on
load conditions. This termination network is
basically a “Y” configuration consisting of
two 51 resistors connected in series and
a 124 resistor connected between the two
50 resistors to GND. Filtering can be done
onthesepinstoreducecommonmodenoise
transmitted over the transmission line by
connecting a capacitor to ground.
The drivers also have separate enable pins
which simplifies half-duplex configurations
for some applications, especially program-
mable DTE/DCE. The enable pins will either
enable or disable the output of the drivers
according to the appropriate active logic
illustrated on Figure 44. The enable pins
have internal pull-up and pull-down devices,
depending on the active polarity of the re-
ceiver, that enable the driver upon power-on
if the enable lines are left floating. During
disabled conditions, the driver outputs will
be at a high impedance 3-state.
The driver inputs are both TTL or CMOS
compatible. All driver inputs have an internal
pull-up resistor so that the output will be at
a defined state at logic LOW (“0”). Unused
driver inputs can be left floating. The inter-
nal pull-up resistor value is approximately
500k.
Receivers
The SP3508 has eight enhanced inde-
pendent receivers. Control for the mode
selection is done via a three-bit con-
trol word that is the same as the driver
control word. Therefore, the modes for
the drivers and receivers are identical in the
application. Like the drivers, the receivers
areprearrangedforthespecificrequirements
of the synchronous serial interface. As the
operating mode of the receivers is changed,
the electrical characteristics will change
to support the required serial interface
protocols of the receivers. Table shows
the mode of each receiver in the different
interface modes that can be selected.
There are two basic types of receiver cir-
cuits—ITU-T-V.28(RS-232)andITU-T-V.,
(RS-422).
The RS-232 (V.28) receiver is single-ended
and accepts RS-232 signals from the RS-
232 driver. The RS-232 receiver has an
operating input voltage range of +5V and
can receive signals downs to +3V. The input
sensitivity complies with RS-232 and V.28
at +3V. The input impedance is 3k to 7k
in accordance to RS-232 and V.28. The re-
ceiver output produces a TTL/CMOS signal
with a +2.4V minimum for a logic “” and a
+0.4V maximum for a logic “0”. The RS-232
(V.28) protocol uses these receivers for all
data,clockandcontrolsignals.Theyarealso
used in V.35 mode for control line signals:
CTS, DSR, LL, and RL. The RS-232 receiv-
ers can operate over 20kbps.
The second type of receiver is a differential
type that can be configured internally to
support ITU-T-V.0 and CCITT-V.35
depending on its input conditions. This
receiver has a typical input impedance
of 10k and a differential threshold of
less than +200mV, which complies with
the ITU-T-V.11 (RS-422) specifications.
V. receivers are used in RS-449/V.36,
EIA-530, EIA-530A and X.2 as Category I
signals for receiving clock, data, and some
control line signals not covered by Category
II V.0 circuits. The differential V. trans-
ceiver has improved architecture that allows
over 20Mbps transmission rates.
Receiversdedicatedfordataandclock(RxD,
RxC, TxC) incorporate internal termination
for V.. The termination resistor is typi-
cally 120 connected between the A and
B inputs. The termination is essential for
minimizing crosstalk and signal reflection
over the transmission line . The minimum
value is guaranteed to exceed 100, thus
complying with the V. and RS-422 speci-
fications. This resistor is invoked when the
receiver is operating as a V. receiver, in
modes EIA-530, EIA-530A, RS-449/V.36,
and X.2.
FEATURES
相關PDF資料 |
PDF描述 |
|---|---|
| V110B15E150BG2 | CONVERTER MOD DC/DC 15V 150W |
| GBC19DRXS-S734 | CONN EDGECARD 38POS DIP .100 SLD |
| SRR7032-3R3M | INDUCTOR POWER 3.3UH 2.4A SMD |
| RT-555-1.0-3.75-A260-0 | HEATSHRINK HI TEMP 3.75X2X0.90" |
| SRR4018-680Y | INDUCTOR POWER 68UH 0.50A 4018 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SP3508EF | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Rugged 3.3V, 20Mbps, 8 Channel Multiprotocol Transceiver with Programmable DCE/DTE and Termination Resistors |
| SP3508EF-L | 功能描述:外圍驅動器與原件 - PCI 20MBPS 8CH MULTI 0-70C RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| SP350ACP | 制造商:Hammond Power Solutions 功能描述:Control Transformer, 350VA, 600,480-120x240 |
| SP350GYRA120 | 制造商:Banner Engineering 功能描述:EZ-LIGHT Traffic Series; 3-Indicator Daylight Visible Voltage; 85-130 VAC |
| SP350GYRNQ | 制造商:Banner Engineering 功能描述:EZ-LIGHT Traffic Series; 3-Indicator Daylight Visible Voltage; 15-30 VDC |
發布緊急采購，3分鐘左右您將得到回復。