- 您現在的位置：買賣IC網 > PDF目錄372181 > SP4412ACU Electroluminescent Lamp Driver PDF資料下載
參數資料
| 型號： | SP4412ACU |
| 英文描述： | Electroluminescent Lamp Driver |
| 中文描述： | 電致發光燈驅動器 |
| 文件頁數： | 4/10頁 |
| 文件大?。?/td> | 119K |
| 代理商： | SP4412ACU |
SP4412ADS/12
SP4412ACN Electroluminescent Lamp Driver
4
Copyright 2000 Sipex Corporation
Typical SP4412ACN Application Circuit
The external clock should have a 50% duty
cycle and range from V
-1V to ground. The
maximum external clock frequency is 128 kHz.
The coil is an external component connected
from V
to pin 5 of the
SP4412A
. Energy
is developed in the coil according to the equation
E
=1/2LI
2
where the current I is defined as
I=(V
-IR-V
)/R
. In order to maximize
the energy produced by the coil, V
should
represent the largest voltage in the system (up to
a maximum of 3.6 v); V
= 3.0 VDC with
a 35mH/125
coil is a typical example. It is not
necessary that V
=V
. The coil operation
is a function of the core material and winding
used -- performance variances may be noticeable
from different coil suppliers even though the
values are the same. The
Sipex
SP4412A
is
final tested using a 35 mH/135 ohm coil. For
suggested coil sources see
page 8
.
The f
signal controls a switch that connects
the end of the coil at pin 5 to ground or to open
circuit. The f
signal is a 94% duty cycle
square wave, switching at 1/4 the oscillator
frequency, (for a 32 kHz oscillator f
is 8
kHz). During the time when the f
signal is
high, the coil is connected from V
to
ground and a charged magnetic field is created
in the coil. During the low part of f
, the
ground connection is switched open, the field
collapses, and the energy in the inductor is forced
to flow toward the high voltage H-bridge
switches. f
will send 16 of these charge
pulses to the lamp, each pulse increases the
voltage drop across the lamp in discrete steps. As
the voltage potential approaches its maximum,
the steps become shorter (see
figure 1
on
page 7)
.
The H-bridge consists of two SCR structures that
act as high voltage switches. These two switches
control the polarity of how the lamp is charged.
The SCR switches are controlled by the f
signal which is the oscillator frequency divided
by 128. For a 32kHz oscillator, f
LAMP
= 250Hz.
When the energy from the coil is released, a high
voltage spike is created triggering the SCR
switches. The direction of current flow is
determined by which SCR is enabled. One full
cycle of the H-bridge will create 16 voltage steps
from ground to 80V (typical) on pins 6 and 7
which are 180 degrees out of phase with each
other (see
figure 3
on
page 7
). A differential view
of the outputs is shown in
figure 4
on
page 7
.
ELECTROLUMINESCENT TECHNOLOGY
What is electroluminescence
An EL lamp is basically a strip of plastic that is
coated with a phosphorous material which emits
light (fluoresces) when a high voltage (>40V)
which was first applied across it, is removed or
reversed. Long periods of DC voltages applied to
the material tend to breakdown the material and
reduce its lifetime. With these considerations in
mind, the ideal signal to drive an EL lamp is a
high voltage sine wave. Traditional approaches
to achieving this type of waveform included
discrete circuits incorporating a transformer,
transistors, and several resistors and capacitors.
This approach is large and bulky, and cannot be
implemented in most hand held equipment.
Sipex
now offers low power single chip driver circuits
specifically designed to drive small to medium
sized electroluminescent panels. All that is
required is an external inductor and an external
clock signal.
LAMP
Coil
32-64 Khz
3 VDC
HON
Clk
V
SS
V
DD
Lamp
Lamp
Coil
1
3
4
5
8
6
7
30 mH 125 ohm Coil
2
相關PDF資料 |
PDF描述 |
|---|---|
| SP4412ACX | Electroluminescent Lamp Driver |
| SP4414 | Low Cost Electroluminescent Lamp Driver |
| SP4414EN | Low Cost Electroluminescent Lamp Driver |
| SP4414EU | Low Cost Electroluminescent Lamp Driver |
| SP4414NEB | Low Cost Electroluminescent Lamp Driver |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SP4412ACX | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Electroluminescent Lamp Driver |
| SP4412CN | 制造商:Exar Corporation 功能描述:4412CN |
| SP4414 | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Low Cost Electroluminescent Lamp Driver |
| SP4414EN | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Low Cost Electroluminescent Lamp Driver |
| SP4414EU | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Low Cost Electroluminescent Lamp Driver |
發布緊急采購，3分鐘左右您將得到回復。