參數資料
型號: SP4414
英文描述: Low Cost Electroluminescent Lamp Driver
中文描述: 低成本電致發光燈驅動器
文件頁數: 5/14頁
文件大小: 137K
代理商: SP4414
SP4414DS/17
SP4414 Electroluminescent Lamp Driver
5
Copyright 2000 Sipex Corporation
Electroluminescent Technology
An EL lamp is basically a strip of plastic that is
coated with a phosphorous material which emits
light (fluoresces) when a high voltage (>40V)
which was first applied across it, is removed or
reversed. Long periods of DC voltages applied
to the material tend to breakdown the material
and reduce its lifetime. With these considerations
in mind, the ideal signal to drive an EL lamp is
a high voltage sine wave. Traditional approaches
to achieving this type of waveform included
discrete circuits incorporating a transformer,
transistors, and several resistors and capacitors.
This approach is large and bulky and can be
difficult to implement in some smaller hand
held equipment. Sipex now offers low power
single chip driver circuits specifically
designed to drive small to medium sized
electroluminescent panels.
Market Applications
Electroluminescent backlighting is ideal when
used with LCD displays, keypads, or other
backlit readouts. Its main use is to illuminate
displays in dim to dark conditions for momentary
periods of time. EL lamps typically consume
less power than LEDs or incandescent bulbs
making them ideal for battery powered products.
Also, EL lamps are able to evenly light an area
without creating any undesirable "hot spots" in
the display.
THEORY OF OPERATION
The
SP4414
is a DC-AC inverter made up of:
1. The Frequency Divider, 2. The Coil, and
3. The Switched H-bridge Network. Further
details of each element follow.
The Oscillator/Frequency Divider
The external oscillator provides the
SP4414
with a clock signal used to control the coil
switch (f
COIL
) and the H-bridge network (f
and f
COIL
/f
LAMP
will always
equal 32 for the
SP4414
.
The external clock frequency is 32kHz.
Figure 1
shows the external clock is internally divided
down by a flip flop to drive the coil at 8kHz.
This signal is divided down by 5 more flip flops
to drive the lamp at 250Hz.
The Coil
The supply V
BATTERY
can range from +2.2V to
+4.5V. V
BATTERY
such that I
coil current specification. The majority of the
current goes through the coil and is typically
much greater than I
DD
.
The coil is an external component connected
from V
to pin 4 of the
SP4414
. Energy is
stored in the coil according to the equation
E
=1/2LI
is the product I
= (tON) (VBATTERY - V
)/
L), where t
is the time it takes for the coil to
reach its peak current, V
is the voltage drop
across the internal NPN transistor for f
COIL
, and
L
the inductance of the coil. When the NPN
transistor switch is off, the energy is forced
through a diode which drives the switched
H-bridge network. This energy recovery is
directly related to the brightness of the EL
lamp output. There are many variations
among coils; magnetic material differences,
winding differences and parasitic capacitances.
For suggested coil suppliers, refer to
Page 7
.
2
where I
, to the first approximation,
is
Figure 2. Typical Application Circuit for the SP4414
V
SS
COIL
C
INT
SP4414
V
BATTERY
1C1
2.L1
4
7
8
5
2
ELEN
1*D1
INT
1C
*optional device
V
DD
EL2
EL1
EL Lamp
3
6
1
CLK
相關PDF資料
PDF描述
SP4414EN Low Cost Electroluminescent Lamp Driver
SP4414EU Low Cost Electroluminescent Lamp Driver
SP4414NEB Low Cost Electroluminescent Lamp Driver
SP4414UEB Low Cost Electroluminescent Lamp Driver
SP4415 Electroluminescent Lamp Driver with Selectable Level Outputs
相關代理商/技術參數
參數描述
SP4414EN 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Low Cost Electroluminescent Lamp Driver
SP4414EU 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Low Cost Electroluminescent Lamp Driver
SP4414NEB 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Low Cost Electroluminescent Lamp Driver
SP4414UEB 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Low Cost Electroluminescent Lamp Driver
SP4415 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Electroluminescent Lamp Driver with Selectable Level Outputs