- 您現在的位置：買賣IC網 > PDF目錄372185 > SP504MCF WAN Multi-Mode Serial Transceiver PDF資料下載
參數資料
| 型號： | SP504MCF |
| 英文描述： | WAN Multi-Mode Serial Transceiver |
| 中文描述： | 萬多模式串行收發器 |
| 文件頁數： | 17/31頁 |
| 文件大?。?/td> | 257K |
| 代理商： | SP504MCF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁
17
Rev: A Date:1/27/04
SP504 Multi–Mode Serial Transceivers
Copyright 2004 Sipex Corporation
tory for more information). The drivers are
controlled with the data bits labeled TDEC
–
TDEC
. All of the drivers can be put into tri-
state mode by writing 0000 to the driver decode
switch. The three drivers TxD, ST and TxC,
have a 150
pull-down resistor to ground con-
nected at the (b) output. This resistor is part of
the V.35 driver circuitry and should be con-
nected when in V.35 mode. Tri-state is possible
for all drivers in RS-232 mode. The receivers
are controlled with data bits RDEC
–RDEC
0
;
the code 0000 written to the receivers will place
the outputs into tri-state mode. The 0000 de-
coder word will override the enable control line
for the one receiver (SCT).
Using the V.35_STAT Pin
The
SP504
includes a V.35 status pin where the
V35_STAT pin (pin 18) is a logic HIGH ("1")
when the decoder is set to V.35 mode. The pin
is a logic LOW ("0") when in all other modes
including tri-state (decoder set at "0000"). Pin
18 allows the user to easily add FET switches or
solid state relays to connect the external 150
resistor for V.35 operation. V35_STAT can be
connected to the gate of the FET switches or the
control of the relays so that the 150
resistors
are connected to the non-inverting output of the
three V.35 drivers. The output current of the
V35_STAT pin is that of a typical TTL load of
–3.2mA. The electrical specifications are simi-
lar to the
SP504
receiver outputs. This feature
would reduce additional logic required by older
traditional methods.
NET1/NET2 Testing and Compliancy
Many system designers are required to certify
their system for use in the European public
network. Electrical testing is performed in ad-
herence to the NET (Norme Européenne de
Télécommunication) which specifies the ITU
Series V specifications. The
SP504
adheres to
all the required physical layer testing for NET1
and NET2. Consult factory for details.
相關PDF資料 |
PDF描述 |
|---|---|
| SP505 | WAN Multi-Mode Serial Transceiver |
| SP505AB | WAN Multi-Mode Serial Transceiver |
| SP505ACF | WAN Multi-Mode Serial Transceiver |
| SP505ACM | WAN Multi-Mode Serial Transceiver |
| SP505AN | Multi-Protocol Serial Transceivers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SP504MCF-L | 制造商:Exar Corporation 功能描述:TRANSCEIVER MULTIPROTOCOL SERIAL 制造商:Exar Corporation 功能描述:IC, WAN MULTIMODE SERIAL TXRX, MQFP-80; Device Type:Transceiver; IC Interface Type:RS232, RS422, RS449, RS485, EIA530, EIA530A; No. of Drivers:7; Supply Voltage Min:4.75V; Supply Voltage Max:5.25V; Driver Case Style:MQFP ;RoHS Compliant: Yes |
| SP504MCM-L | 功能描述:總線收發器 WAN Multi-Mode Serial RoHS:否 制造商:Fairchild Semiconductor 邏輯類型:CMOS 邏輯系列:74VCX 每芯片的通道數量:16 輸入電平:CMOS 輸出電平:CMOS 輸出類型:3-State 高電平輸出電流:- 24 mA 低電平輸出電流:24 mA 傳播延遲時間:6.2 ns 電源電壓-最大:2.7 V, 3.6 V 電源電壓-最小:1.65 V, 2.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TSSOP-48 封裝:Reel |
| SP504MCM-L/TR | 功能描述:LIN 收發器 WAN Multi-Mode Serial Transceiver RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8 |
| SP505 | 制造商:EXAR 制造商全稱:EXAR 功能描述:WAN Multi-Mode Serial Transceiver |
| SP5054 | 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:2.6GHz 3-Wire BUS Controlled Synthesiser |
發布緊急采購，3分鐘左右您將得到回復。