- 您現在的位置：買賣IC網 > PDF目錄372195 > SP804TEP 3.0V/3.3V Low Power Microprocessor Supervisory with Battery Switch-Over PDF資料下載
參數資料
| 型號： | SP804TEP |
| 英文描述： | 3.0V/3.3V Low Power Microprocessor Supervisory with Battery Switch-Over |
| 中文描述： | 3.0V/3.3V低功耗微處理器監控與電池開關過 |
| 文件頁數： | 16/20頁 |
| 文件大?。?/td> | 233K |
| 代理商： | SP804TEP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁
SP690T/S/R DS/10 SP690T/S/R, 802/T/S/R, 804T/S/R, 805T/S/R Low Power Microprocessor Supervisory
Copyright 2000 Sipex Corporation
16
Figure 24. Interfacing to Microprocessors with
Bidirectional RESET I/O
V
CC
GND
V
CC
GND
RESET
RESET
4.7K
μ
P
Buffered RESET connects to System Components
Monitoring an Additional Power Supply
These
μ
P supervisors can monitor either positive
or negative supplies using a resistor voltage
divider to PFI. PFO can be used to generate an
interrupt to the
μ
P, as seen in
Figure 23
.
Interfacing to
μ
Ps with Bidirectional
Reset Pins
Any
μ
Ps with bidirectional reset pins, such as
the Motorola 68HC11 series, can interface with
the
SP690_
and the
SP802_
RESET outputs.
For example, if the RESET output is driven
HIGH and the
μ
P wants to pull it LOW,
indeterminate logic levels may result. To correct
this, connect a 4.7k
resistor between the
RESET output and the
μ
P reset I/O, as in
Figure 24.
Buffer the RESET output to other
system components.
Negative-Going V
CC
Transients
While issuing resets to the
μ
P during power-up,
power-down, and brownout conditions, these
supervisors are relatively immune to short-
duration negative-going V
transients
(glitches). It is usually undesirable to reset the
μ
P when V
CC
experiences only small glitches.
Figure 25
shows maximum transient duration
vs. reset-comparator overdrive, for which reset
pulses are not generated. The data was generated
using negative-going V
pulses, starting at
3.3V and ending below the reset threshold by
the magnitude indicated (reset comparator
overdrive). The graph shows the maximum pulse
width a negative-going V
transient may
typically have without causing a reset pulse to
be issued. As the amplitude of the transient
increases (i.e. goes farther below the reset
threshold), the maximum allowable pulse width
decreases. Typically, a V
transient that goes
100mV below the reset threshold and lasts for
40
μ
s or less will not cause a reset pulse to be
issued. A 100nF bypass capacitor mounted close
to the V
CC
pin provides additional transient
immunity.
Figure 25. Maximum Transient Duration without
Causing a Reset Pulse vs. Reset Comparator Overdrive
1nF Capacitor
V
OUT
TO GND
ARESET
Generated
RNO
相關PDF資料 |
PDF描述 |
|---|---|
| SP802R | 3.0V/3.3V Low Power Microprocessor Supervisory with Battery Switch-Over(3.0V/3.3V帶電池轉換的低功耗μp監控) |
| SP802T | 3.0V/3.3V Low Power Microprocessor Supervisory with Battery Switch-Over(3.0V/3.3V帶電池轉換的低功耗μp監控) |
| SP690T | 3.0V/3.3V Low Power Microprocessor Supervisory with Battery Switch-Over(3.0V/3.3V帶電池轉換的低功耗μp監控) |
| SP805SCP | 3.0V/3.3V Low Power Microprocessor Supervisory with Battery Switch-Over |
| SP805SEN | 3.0V/3.3V Low Power Microprocessor Supervisory with Battery Switch-Over |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SP8050A | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:8 Channel, 150MHz Fully Integrated PDIC Receiver with Gain Switching |
| SP8051 | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:8 Channel, 140MHz Fully Integrated PDIC Receiver with Gain Switching |
| SP8052 | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:High Speed 12-channel Photo Detector IC |
| SP8052HRA4 WAF | 制造商:Intel 功能描述: |
| SP8053 | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:10 - Channel Photo Detector IC |
發布緊急采購，3分鐘左右您將得到回復。