- 您現在的位置：買賣IC網 > PDF目錄385872 > ST7538P (意法半導體) POWER LINE FSK TRANSCEIVER PDF資料下載
參數資料
| 型號： | ST7538P |
| 廠商： | 意法半導體 |
| 英文描述： | POWER LINE FSK TRANSCEIVER |
| 中文描述： | 電力線FSK收發器 |
| 文件頁數： | 15/30頁 |
| 文件大?。?/td> | 264K |
| 代理商： | ST7538P |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁
15/30
ST7538
Receiving Mode
The receive section is active when
RxTx
Pin =”1” and REG_DATA=0.
The input signal is read on RAI Pin using SGND as ground reference and then pre-filtered by a Band pass
Filter (+-10KHz). The Pre-Filter can be removed setting one bit in the Control Register. The Input Stage
features a wide dynamic range to receive Signal with a Very Low Signal to Noise Ratio. The Amplitude of
the applied waveform is automatically adapted by an Automatic Gain Control block (AGC) and then filtered
by a Narrow Band Band-Pass Filter centered around the Selected Channel Frequency (+-6K). The result-
ing signal is down-converted by a mixer using a sinewave generated by the FSK Modulator. Finally an
Intermediate Frequency Band Pass-Filter (IF Filter) improves the Signal to Noise ration before sending the
signal to the FSK demodulator. The FSK demodulator then send the signal to the RX Logic for final digital
filtering. Digital filtering Removes Noise spikes far from the BAUD rate frequency and Reduces the Signal
Jitter. RxD Line is forced at logic level “0” when neither mark or space frequencies are detected on RAI Pin.
Mark and Space Frequency in Receiving Mode must be distant at least BaudRate/2 to have a correct de-
modulation.
While ST7538 is in Receiving Mode (
RxTx
pin =”1”), the transmit circuitry, Power Line Interface included,
are turned off. This allows the device to achieve a very low current consumption (5 mA typ). In Receiving
mode ATOP2 pin is internally connected to PAVSS.
I
High Sensitivity Mode
It is possible to increase ST7538 Receiving Sensitivity setting to “1” the High Sensitivity Bit of Control
Register. This Function allows to increase the communication reliability when the ST7538 sensitivity is
the limiting factor.
I
Synchronization Recovery System (PLL)
ST7538 embeds a Clock Recovery System to feature a Synchronous data exchange with the Host
Controller.
The clock recovery system is realized by means of a second order PLL. Data on the data line (RxD) are
stable on CLR/T line rising edge (CLR/T Falling edge synchronized to RxD line transitions ± LOCK-IN
Range).
The PLL Lock-in and Lock-out Range is ±
π
/2. When the PLL is in the unlock condition, CLR/T and RxD
lines are forced to a low logic level.
When PLL is in unlock condition it is sensitive to RxD Rising and Falling Edges. The maximum number
of transition required to reach the lock-in condition is 5. When in lock-in condition the PLL is sensitive
only to RxD rising Edges to reduce the CLR/T Jitter.
ST7538 PLL is forced in the un-lock condition, when more than 32 equal symbols are received.
Figure 9.
CLR/T
RxD
D03IN1417
LOCK-IN RANGE
相關PDF資料 |
PDF描述 |
|---|---|
| ST7554 | V.90 USB WORLD MODEM CONTROLLER |
| ST7554TQF7 | V.90 USB WORLD MODEM CONTROLLER |
| ST7HUB | USB 1.1 HUB WITH 2 DOWNSTREAMS, FULL SPEED FUNCTION, 8-BIT MCU, 10-BIT ADC, 3 TIMERS, 2 PWMs |
| ST9293 | 48K ROM HCMOS MCUs WITH ON SCREEN DISPLAY AND A/D CONVERTER |
| ST9293J1 | 48K ROM HCMOS MCUs WITH ON SCREEN DISPLAY AND A/D CONVERTER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ST7538P013TR | 功能描述:電信集成電路 1/2 Duplex FSK Modem RoHS:否 制造商:STMicroelectronics 類型:Telecom IC - Various 工作電源電壓:4.75 V to 5.25 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-100 封裝:Tray |
| ST7538Q | 功能描述:電信線路管理 IC FSK power line transceiver RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray |
| ST7538QTR | 功能描述:電信線路管理 IC FSK power line transceiver RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray |
| ST7540 | 功能描述:電信線路管理 IC FSK powerline transceiver RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray |
| ST7540TR | 功能描述:電信線路管理 IC FSK powerline transceiver RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。