參數資料
型號: T5753
廠商: Atmel Corp.
英文描述: UHF ASK/FSK TRANSMITTER
中文描述: 超高頻ASK / FSK發射器
文件頁數: 4/13頁
文件大?。?/td> 213K
代理商: T5753
4
T5753
4510F–RKE–07/04
Functional
Description
If ENABLE = L and the PA_ENABLE = L, the circuit is in standby mode consuming only
a very small amount of current so that a lithium cell used as power supply can work for
several years.
With ENABLE = H the XTO, PLL and the CLK driver are switched on. If PA_ENABLE
remains L only the PLL and the XTO is running and the CLK signal is delivered to the
microcontroller. The VCO locks to 32 times the XTO frequency.
With ENABLE = H and PA_ENABLE = H the PLL, XTO, CLK driver and the power
amplifier are on. With PA_ENABLE the power amplifier can be switched on and off,
which is used to perform the ASK modulation.
ASK Transmission
The T5753 is activated by ENABLE = H. PA_ENABLE must remain L for
typically
3 ms, then the CLK signal can be taken to clock the microcontroller and the
output power can be modulated by means of Pin PA_ENABLE. After transmission
PA_ENABLE is switched to L and the microcontroller switches back to internal clocking.
The T5753 is switched back to standby mode with ENABLE = L.
FSK Transmission
The T5753 is activated by ENABLE = H. PA_ENABLE must remain L for
typically
3 ms, then the CLK signal can be taken to clock the microcontroller and the
power amplifier is switched on with PA_ENABLE = H. The chip is then ready for FSK
modulation. The microcontroller starts to switch on and off the capacitor between the
XTAL load capacitor and GND with an open-drain output port, thus changing the refer-
ence frequency of the PLL. If the switch is closed, the output frequency is lower than if
the switch is open. After transmission PA_ENABLE is switched to L and the microcon-
troller switches back to internal clocking. The T5753 is switched back to standby mode
with ENABLE = L.
The accuracy of the frequency deviation with XTAL pulling method is about ±25% when
the following tolerances are considered.
Figure 4.
Tolerances of Frequency Modulation
~
V
S
Using C
4
= 8.2 pF ± 5%, C
5
= 10 pF ± 5%, a switch port with C
Switch
= 3 pF ± 10%, stray
capacitances on each side of the crystal of C
Stray1
= C
Stray2
= 1 pF ± 10%, a parallel
capacitance of the crystal of C
0
= 3.2 pF ± 10% and a crystal with C
M
= 13 fF ± 10%, an
FSK deviation of ±21.5 kHz typical with worst case tolerances of ±16.25 kHz to
±28.01 kHz results.
CLK Output
An output CLK signal is provided for a connected microcontroller, the delivered signal is
CMOS compatible if the load capacitance is lower than 10 pF.
Clock Pulse Take-over
The clock of the crystal oscillator can be used for clocking the microcontroller. Atmel’s
ATARx9x has the special feature of starting with an integrated RC-oscillator to switch on
the T5753 with ENABLE = H, and after 1 ms to assume the clock signal of the transmis-
sion IC, so that the message can be sent with crystal accuracy.
~
XTAL
C
Stray1
C
M
L
M
R
S
C
0
C
Stray2
C
4
C
5
Crystal equivalent circuit
C
Switch
相關PDF資料
PDF描述
T5753-6AQ UHF ASK/FSK TRANSMITTER
T5754 UHF ASK/FSK TRANSMITTER
T5754-6AQ UHF ASK/FSK TRANSMITTER
T5760 UHF ASK/FSK Receiver
T5760-TG UHF ASK/FSK Receiver
相關代理商/技術參數
參數描述
T5753_07 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:UHF ASK/FSK Transmitter
T5753_08 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:UHF ASK/FSK Transmitter
T5753-6AP 功能描述:IC TX 310-330MHZ ASK/FSK 8TSSOP RoHS:否 類別:RF/IF 和 RFID >> RF 發射器 系列:- 標準包裝:4,000 系列:- 頻率:310MHz ~ 440MHz 應用:- 調制或協議:UHF,ASK 數據傳輸率 - 最大:20 kBaud 功率 - 輸出:1dBm ~ 5dBm 電流 - 傳輸:10mA 數據接口:PCB,表面貼裝 天線連接器:PCB,表面貼裝 存儲容量:- 特點:- 電源電壓:2.2 V ~ 4 V 工作溫度:-40°C ~ 85°C 封裝/外殼:16-LSSOP(0.154",3.90mm 寬) 包裝:帶卷 (TR)
T5753-6APJ 功能描述:射頻發射器 ASK/FSK Transmitter 310 - 330 MHz RoHS:否 制造商:Micrel 類型:ASK Transmitter 封裝 / 箱體:SOT-23-6 工作頻率:300 MHz to 450 MHz 封裝:Reel
T5753-6AQ 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:UHF ASK/FSK TRANSMITTER